Smeg SC166PZ Manual de usuario

Contents

1. INSTRUCTIONS FOR SAFE AND PROPER USE_______________ 33

2. INSTALLATION _________________________________________ 35

3. DESCRIPTION OF CONTROLS ____________________________ 38

4. USE OF THE OVEN______________________________________ 46

5. USING THE PIZZA FUNCTION _____________________________ 48

6. AVAILABLE ACCESSORIES _______________________________ 50

7. COOKING HINTS________________________________________ 51

8. CLEANING AND MAINTENANCE ___________________________ 55

9. EXTRAORDINARY MAINTENANCE _________________________ 60

INSTRUCTIONS FOR THE INSTALLER: these are intended for the

qualified technician who must install the appliance, set it functioning

and carry out an inspection test.

INSTRUCTIONS FOR THE USER: these contain user advice,

description of the commands and the correct procedures for cleaning

and maintenance of the appliance.

Introduction

1. INSTRUCTIONS FOR SAFE AND PROPER USE

THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND

THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE

PLACE FOR THE WHOLE WORKING LIFE OF THE OVEN. WE ADVISE

CAREFUL READING OF THIS MANUAL AND ALL THE INSTRUCTIONS

THEREIN BEFORE USING THE OVEN. INSTALLATION MUST BE CARRIED

OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE

REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC

USES AND CONFORMS TO CURRENT REGULATIONS IN FORCE. THE

APPLIANCE HAS BEEN BUILT TO CARRY OUT THE FOLLOWING

FUNCTIONS: COOKING AND HEATING-UP OF FOOD. ALL OTHER USES

ARE CONSIDERED IMPROPER.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER

USE.

DO NOT LEAVE THE PACKING IN THE HOME ENVIRONMENT. SEPARATE

THE VARIOUS WASTE MATERIALS AND TAKE THEM TO THE NEAREST

SPECIAL GARBAGE COLLECTION CENTRE.

IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE GROUNDED

ACCORDING TO THE METHODS REQUIRED BY SAFETY RULES.

WHEN LINKING UP TO MAINS BY PLUG AND SOCKET, MAKE SURE THAT

BOTH ARE COMPATIBLE AND CONNECT BY MEANS OF A POWER CABLE

COMPLYING WITH APPLICABLE REGULATIONS.

THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE HAS BEEN

BUILT IN.

NEVER UNPLUG BY PULLING ON THE CABLE.

DO NOT OBSTRUCT VENTILATION OPENINGS AND HEAT DISPERSAL

SLITS.

IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION

TEST OF THE OVEN, FOLLOWING THE INSTRUCTIONS BELOW. SHOULD

THE APPLIANCE NOT FUNCTION, DISCONNECT IT FROM THE SUPPLY AND

CALL THE NEAREST TECHNICAL ASSISTANCE CENTRE.

NEVER ATTEMPT TO REPAIR THE APPLIANCE.

Introduction

ALWAYS CHECK THAT THE CONTROL KNOBS ARE IN THE “ZERO” (OFF)

POSITION WHEN YOU FINISH USING THE OVEN.

NEVER PUT INFLAMMABLE OBJECTS IN THE OVEN: THEY COULD BE

ACCIDENTALLY LIGHTED AND CAUSE FIRES.

DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO

TOUCH THE HEATING ELEMENTS INSIDE THE OVEN.

THE I.D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER AND

BRAND NAME IS POSITIONED VISIBLY ON THE OVEN DOOR FRAME.

THE PLATE MUST NOT BE REMOVED.

THE OVEN IS DESIGNED FOR USE BY ADULTS. DO NOT ALLOW CHILDREN

TO GO NEAR OR PLAY WITH IT.

THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE

2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT

(WEEE).

THIS GUIDELINE IS THE FRAME OF A EUROPEAN-WIDE VALIDITY OF

RETURN AND RECYCLING ON WASTE ELECTRICAL AND ELECTRONIC

EQUIPMENT.

BEFORE THE APPLIANCE IS PUT INTO OPERATION, ALL THE LABELS AND

PROTECTIVE FILMS APPLIED INSIDE OR OUTSIDE MUST BE REMOVED.

The manufacturer declines all responsibility for damage to persons

or things caused by non-observance of the above prescriptions or by

interference with any part of the appliance or by the use of non-original

spares.

Instructions for the installer

2. INSTALLATION

2.1 Electrical connection

Check that mains voltage and power cable ratings are as per the

indications provided on the label attached to the oven door frame.

This label must never be removed.

It is obligatory for the electrical system to be grounded according to the

methods required by safety rules.

If a plug and socket connection is being used make sure that the plug

and socket are compatible. Avoid use of adapters and shunts as these

could cause overheating and risk of burns.

If a fixed connection is being used fit power line with an omnipolar circuit

breaker with a contact opening gap equal to or greater than 3 mm in an

easily accessible position in proximity to the oven.

For operation on 220-240V

∼

:use an

H05RR-F / H05RN-F / H05V2V2-F type

three-core cable (3 x 1.5 mm2).

The cable end to be connected to the

appliance must be provided with an ground

wire (yellow-green) at least 20 mm longer.

The manufacturer declines all responsibility for damage to persons

or things caused by non-observance of the above prescriptions or by

interference with any part of the appliance.

Instructions for the installer

2.2 Mounting the oven

The oven is designed for mounting into any piece of furniture as long as

heat-resistant. Proceed according to the dimensions shown in Figures

1, 2and 3. For installing under a work top, follow the dimensions given

in Figure 1-3. For installing under a work top with combined heating

plates, ensure a minimum clearance from any side walls of at least 110

mm as shown in Figure 1.

For installing in a column, follow the dimensions given in Figure 1-2

allowing for a clearance of 80 to 90 mm at the top and sides of the

column. Tighten the four screws Ainside the frame to secure (Fig. 1).

For installing beneath a non-integrated top, allow for a rear and bottom

clearance as shown in Figure 1(ref. B). See relevant instructions for

fitting and securing the cook top.

Instructions for the installer

Never use the oven door to lever the oven into

place when fitting.

Avoid exerting too much pressure on the oven door

when open.

Instructions for the user

3. DESCRIPTION OF CONTROLS

3.1 Front control panel

All the oven controls are grouped together on the front panel.

THERMOSTAT KNOB

Cooking temperature is selected by turning the knob clockwise to the

desired setting, between 50° and 240°C/ / .

Instructions for the user

FUNCTION SWITCH KNOB

Rotate the knob in either direction to select desired function from the

following:

NO FUNCTION SET

GRILL ELEMENT +

VENTILATION

PIZZA FUNCTION

LOWER HEATING ELEMENT +

VENTILATION

UPPER AND LOWER

HEATING ELEMENT

VENTILATED HEATING

ELEMENT

GRILL ELEMENT

UPPER AND LOWER

HEATING ELEMENT +

VENTILATED HEATING

ELEMENT

WIDE GRILL ELEMENT

Instructions for the user

TIMER KNOB (CERTAIN MODELS ONLY)

Lets you choose manual cooking or the timer with automatic turn-off of

the oven when done.

For manual control of cooking time, turn the knob anticlockwise to

the symbol .

Turn clockwise to wind up the alarm and set to the desired time.. The

numbers from 5 to 90/120 correspond to minutes. Adjustment is

progressive and intermediate positions between the numbers shown

may be used.

At the end of programmed cooking, an audible alarm sounds which goes

off automatically after 4-5 seconds.

THERMOSTAT INDICATOR LIGHT

When this light comes on, the oven is

heating up.

When this light goes out, the preset

heating temperature has been

reached.

When the light flashes, the

temperature inside the oven is steady.

PILOT LIGHT (GREEN)

This light comes on when any of the oven elements is

receiving power.

Instructions for the user

3.2 Clock + timer with end of cooking (certain models only)

Allows selection of manual cooking or to set timer and cooking time.

Always rotate the small knob AANTICLOCKWISE.

Select function and cooking temperature before setting cooking time.

3.2.1 Adjusting the clock

To adjust to correct time, PRESS and rotate the small knob A

anticlockwise.

3.2.2 Manual cooking

For manual cooking, rotate small knob Aanticlockwise until pointer is

aligned with .

3.2.3 Setting cooking time

To set cooking time, rotate small knob Aanticlockwise to the desired

length of time (maximum 90 minutes).

3.2.4 End of cooking

At end of cooking the oven turns off automatically and the alarm starts

sounds.

3.2.5 To turn the alarm off

Turn small knob Aanticlockwise until pointer is aligned with .

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Horno de Smeg

Smeg

Smeg SO4604S4PNR Manual de usuario

Smeg

Smeg SC166-8 Manual de usuario

Smeg

Smeg CSA19ID-6 Manual de usuario

Smeg

Smeg Oven Manual de usuario

Smeg

Smeg CG90IXT9 Manual

Smeg

Smeg ALFA161X Manual de usuario

Smeg

Smeg ALFA 150 Manual de usuario

Smeg

Smeg Four Oven Manual del sistema

Smeg

Smeg TRA93P Manual de usuario

Smeg

Smeg SA578X-9 Manual de usuario

Smeg

Smeg CE9IMXA Manual de usuario

Smeg

Smeg Classic SF6341GVX Manual de usuario

Smeg

Smeg Oven Manual de usuario

Smeg

Smeg SFPA6300TVX Manual de usuario

Smeg

Smeg 91 477 0995 Manual de usuario

Smeg

Smeg SCT105-9 Manual de usuario

Smeg

Smeg SF61M3GVN Manual de usuario

Smeg

Smeg Commercial Oven ALFA41UK Manual de usuario

Smeg

Smeg SCA712-2 Manual de usuario

Smeg

Smeg SFA4603MCNX Manual de usuario

Smeg

Smeg SFA130 Manual de usuario

Smeg

Smeg Multi-Function Built-In Oven Manual de usuario

Smeg

Smeg classic DOSFA38X Manual de usuario

Smeg

Smeg Oven AP361MFEB Manual de usuario

Manuales populares de Horno de otras marcas

Bosch

Bosch HVA531NS0 Manual de usuario

Electrolux

Electrolux EOF6P46X Manual de usuario

NEFF

NEFF B44S32 5GB Series Manual de usuario

Combi

Combi BLODGETT BC142GDS Manual de usuario

AEG

AEG COMPETENCE 311704300 Manual de usuario

Falcon

Falcon DOMINATOR PLUS G3106 Series Guía del usuario

Rational

Rational SCC WE 61G Manual de usuario

Electrolux

Electrolux air-o-convect 20 GN 2/1 Manual de usuario

Miele

Miele HR 1954-2 Manual de usuario

KHIND

KHIND OT50 Manual de usuario

Henny Penny

Henny Penny Smoker Box Manual de usuario

Lang

Lang ECOD-AP Manual de usuario

AEG

AEG BEK455310M Manual de usuario

Frigidaire

Frigidaire FNGE90JGR Manual de usuario

Hotpoint

Hotpoint FE9 S831 JSH IX Manual de usuario

GE Advantium SCB2000 Manual de usuario

AEG

AEG DE401301DM Manual de usuario

DeLonghi

DeLonghi XA660 Manual