-8-
5-2. Re-mounting of finger assembly (LEHZJ)
(1) Mount the finger assembly onto the body. Refer to Figure 5-1 for finger assembly mounting.
The datum level of the finger assembly should face the same direction as the body mounting
surface.
(2) Tighten the finger assembly mounting screws to secure the body and finger assembly.
(3) Mount the dust cover and encoder dust cover.
Refer to the step (1) in the section "3-2. Re-mounting of dust cover and encoder dust cover" of
"3. Replacement of Dust Cover and Encoder Dust Cover" for how to mount the dust cover and
encoder dust cover.
Table 5-2 Tightening torque for finger assembly screws
Size
Recommended
tightening torque [Nm]
Hexagon socket flat countersunk head cap screw
Hexagon socket flat countersunk head cap screw
Hexagon socket flat countersunk head cap screw
Hexagon socket flat countersunk head cap screw
Fig. 4 Finger assembly mounting
* Insert the levers into the finger
grooves to mount the finger
assembly.
Hexagon socket flat countersunk
head cap screws
*Be careful not to drop the
body plate.
Datum level of finger assembly
(with groove on the side)
Datum level of body mounting
(with positioning dowel pin holes)
finger assembly should face
the same direction as the
body mounting surface.
finger assembly should face
the same direction as the
body mounting surface.
Positioning dowel pin holes
Fig. 5-1 finger assembly mounting condition
