SMC Networks LOOPANTNVIS3 Manual de usuario

Issue 1

LOOPANTNVIS3

FOLDING LOOP ANTENNA

Operators Manual

South Midlands Communications Ltd

SM House, School Close

Chandlers Ford Industrial Estate

Eastleigh, Hampshire

SO53 4BY

United Kingdom

Tel: +44 (0)23 8024 6200 Email: sales@smc-comms.com Web: www.smc-comms.com

Issue 1

Preface

SMC - South Midlands Communications Ltd was established in 1958 and

initially specialized in antenna support masts, towers and HF antennas. SMC is

now recognized globally as a specialist communications company.

Over the last 50 years the SMC product range has grown to include pneumatic

telescopic masts, aluminum lattice masts, high-level photography solutions, Mil’

specification antenna positioners and two way radio products including GPS,

AVLS and data transfer.

SMC are able to advise, design, supply and install mobile communications

systems, from the simple to more complex and integrated networks.

Although every care is taken in the production of this publication it may contain

technical inaccuracies or typographical errors. SMC may make improvements

and or changes in the product detailed in this manual at any time without notice.

Correspondence regarding this publication should be addressed to:

South Midlands Communications Ltd

SM House, School Close

Chandlers Ford Industrial Estate

Eastleigh, Hampshire

SO53 4BY

United Kingdom

Tel: +44 (0)23 8024 6200

Fax: +44 (0)23 8024 6206

Email: sales@smc-comms.com

Web: www.smc-comms.com

Issue 1

Safety Information

Always follow the Operating Instructions

Installation must only be carried out by authorized

personnel

The Folding Loop Antenna is heavy and care should be

taken when installing the unit.

Beware of overhead obstructions and power lines. Drive the

vehicle accordingly.

Do not operate the Folding Loop Antenna Outside of the

operating temperature range -35

C to +70

Take care not to trap fingers whilst raising and lowering

the Folding Loop Antenna. Always wear protective

gloves.

Ensure that the Folding Loop Antenna is securely mounted

to the vehicle

Do not use the antenna unless it is positioned correctly in

the Operational Position

Do not attempt to apply RF power if the Folding Loop

Antenna is not powered with the correct DC supply

Do not touch the Folding Loop Antenna when in use and

RF power is applied.

Failure to observe any of the warnings in this manual may result in

personal injury, death, or equipment damage. South Midlands

Communications Ltd (SMC) accepts no responsibility for

unauthorized use.

Issue 1

Product Introduction

The Folding Loop Antenna has been designed and manufactured to meet the

requirements of NVIS HF mobile communications for both on-road and off-road

vehicles.

High conductivity tubing is used in the loop element to provide high

communication efficiency, and a custom-modified electronic tuner is used to

provide a 50-ohm nominal termination impedance at all operating frequencies.

The termination arrangement is hermetically sealed to IP66 specifications.

Following initialisation, where the tuner unit memorises each operating frequency

used by the HF transceiver, each subsequent tune operation is completed within

10 mS. This is achieved by the tuner having on-board memory to instantaneously

measure and determine the operating frequency of each operating channel, and

to switch in the required matching configuration for each stored channel. The

Folding Loop Antenna is inherently compatible with virtually any HF transceiver

over the operational frequency range and power rating with no separate channel

control required for the antenna.

The radiation pattern presented by the Folding Loop Antenna is shown above

in 3D, giving maximum radiation in an arc from the front of the vehicle, over the

vehicle (thus giving excellent NVIS performance), and to the rear of the vehicle.

The front and rear radiation paths also provide excellent results for ground-wave

communication between a fleet of vehicles travelling in line. This assumes the

loop is mounted with the element in the same plane as the line of the vehicle (i.e.

from front to rear) and with the Folding Loop Antenna in the Operational

Position.

Issue 1

Specification

Dimensions

Weight:

14.5 kg

Frequency Range:

3.0 –15.0 MHz

TX Power Input Range:

1.5-200 Watts PEP

Continuous TX CW/Data Power:

80W

Number of operating channels:

Unlimited

Non-Volatile Channel Memory

Addresses:

170 (165 TX, 5 RX)

Input Impedance Range

45-55 ohms

VSWR

Typically less than 2:1 when tuned, (3:1 max)

DC Operating Range

+10.5V to 18.0V DC,

(+13.8V DC nominal)

DC Current:

230 mA average

Initial tuning response time:

(For initial memory setting only)

Up to 20 seconds max

Recurrent tuning response time:

(for on-air use inc. freq hopping)

Typically less than 10 ms per channel

Operational Temperature

-35° to +70°C

Control cable

Standard 50-ohm coaxial cable plus 13.8V

nominal DC feed

957mm

1660mm

800mm

225mm

Issue 1

Retainer Upstand

Antenna

Features

Catch

Base

Electrical

Enclosure

Locking Arm

Base

Roof Rack

Plate

Locking Knob

Issue 1

Installation

The following procedure describes how to install the Folding Loop Antenna on

to a pair of vehicle roof bars.

The Folding Loop Antenna is heavy and care should be

taken when installing the unit.

Take care not to trap fingers when installing the Folding Loop

Antenna. Always wear protective gloves when raising or

lowering the Folding Loop Antenna.

1. Remove the Folding Loop Antenna from its packaging and place next to

the vehicle.

2. Adjust the roof bars on the vehicle so that they are 800mm apart between

the centre of each bar. Ensuring the roof bars are parallel to each other.

3. Lock the Folding Loop Antenna into the Operational Position. Ensuring

that the locking Screw on both Locking Arms is engaged into its

corresponding Catch on it’s the Base.

4. Place the Folding Loop Antenna onto the roof bars, with the angle

section of the loop facing to the front of the vehicle, and support.

5. Place the a Roof Rack Plates under the vehicle roof bars as shown and

bolt into position using the supplied bolt, nut and washers. Repeat this

procedure for all six fixing positions on the two Bases.

Front of

Vehicle

Roof Bars

800mm

Issue 1

6. Place both Retainer Upstands onto the roof bars as shown.

7. Place the Roof Rack Plates under the vehicle roof bars and bolt the

Retainer Upstands into position so that they are secure but can be

adjusted.

8. Release the Folding Loop Antenna from it Operational Position, by

turning the Locking Knobs counter clockwise, disengaging the Locking

Arms from the Catch’s. Lower the Folding Loop Antenna down onto the

Retainer Upstands using the Locking Arms.

Take care not to drop the Folding Loop Antenna on the

Retainer Upstands.

455mm

680mm

Issue 1

9. Adjust the Retainer Upstands so that they allow the Locking Knobs to

engage into them.

10.Secure the Locking Knob in position and tighten the bolts securing the

Retainer Upstands to the roof bars.

Ensure the Folding Loop Antenna is securely mounted to the

vehicle and that all bolts are securely tightened.

Tabla de contenidos

Otros manuales de Antena de SMC Networks

SMC Networks

SMC Networks HMANT-6 Manual de usuario

SMC Networks

SMC Networks SMCAMP-1000 Manual de usuario

SMC Networks

SMC Networks HMANT-4 Manual de usuario

SMC Networks

SMC Networks SMCANT-OOM5P Manual de usuario

SMC Networks

SMC Networks HMANT-6 - FICHE TECHNIQUE Guía de instalación

SMC Networks

SMC Networks HMANT-4 - FICHE TECHNIQUE Manual de usuario

Manuales populares de Antena de otras marcas

Alfa Network

Alfa Network APA-L01 Manual de usuario

Naval

Naval PR-422CA Manual de usuario

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Manual de usuario

TERK Technologies

TERK Technologies TV44 Manual de usuario

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Manual de usuario

HP J8999A Manual de usuario

MobilSat

MobilSat MSP-S Manual de usuario

Steren

Steren ANT-UHF 13 Manual de usuario

Novatel

Novatel 600-G Manual de operación

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Manual de usuario

TRENDnet

TRENDnet TEW-AO12O Manual de usuario

Radio Shack

Radio Shack 15-1837 Manual de usuario

CommScope

CommScope CMAX-OMFX-43M-I53 Manual de usuario

Ramsey Electronics

Ramsey Electronics DAP25 Manual de usuario

COBHAM

COBHAM SAILOR 800 VSAT Manual de uso y cuidado

Trango Systems

Trango Systems AD900-9 Manual de usuario

Steren

Steren ANT-100 Manual de usuario

Proxim

Proxim 5054-PA-23 Manual de usuario