LAVA
Electronics
Inc.
Tel
:
1-909-923-
87743,
Email:
isma
[email protected] www.l
avasat.com
LAVA Electronics Inc Copyright 2009
Step 3: Install the Electrodes for the Receiver.
Randomly pick one pair of electrodes and screw for receivers. (Please pick the same
size electrodes for each receiver.)
Step 4: Adjust the collar to fit your pets.
To ensure a proper fit, please follow the steps below:
1. Put the straps on the receiver.
2. With your dog standing, centre the collar receiver where contact points are
underneath your pet’s neck, touching the skin.
3. The collar receiver should fit snugly, yet loose enough to allow on finger to fit
between the strap and your dog’s neck. If the strap is too long for your dog, cut
off the excess length.
4. Allow your dog to wear the collar for several minutes and then recheck the fit.
Check the fit again as your dog becomes more comfortable wearing the collar
receiver.
How to use the transmitter and receivers
1. Mode (⑨) Button for change different functions (There are 4 functions which are
Static Shock, Vibration, Beep, and Light Mode).
2. “1/2” (⑦) Button for switch channels.
3. Light Button for the LED Light (②) which on the Transmitter.
4. Y (⑧) Button is a Launch button for the receiver and also a work button.
5. Up/Down (⑤) Button is on the side of the transmitter for adjusting the static
shock and vibration levels (1-100).
6. The Transmitter and Receiver will get into the Save Mode if you do not use it
for 2 minutes.
7. There is no display on the LCD Screen when the Transmitter gets into the SAVE
MODE, please press the Mode Button and Hold for 5 second the Transmitter
will get back to Standby Mode.
8. The Green indicated light will turn off automatically when receiver gets into
the SAVE MODE, please gently shake receiver, the receiver will get back to the
Standby Mode.
We would recommend you to use the Beep Mode first before starting the static
shock and always start from the lowest level of static shock.
