WARNING & CAUTION
ØPlease handle the equipment with care. Physical Damage to the system is not covered under
warranty.
ØDo not power on the system without reading this manual. Ensure proper power supply with
Earthing.
ØNote down the serial number and model no. of the device for future reference and quote in all
support and service requests.
ØTo connect or interface the Card reader to the Smart XS NG unit please refer to the Hardware
nstallation Guide or Manual and carefully follow the instructions. A trained technician must
make the connections.
Any negligence on your part may damage the Card reader interface on the Smart XS NG
terminal.
ØDo not use this unit near water.
Ø Do not open system or places it near other heavy electrical equipment. The system is sensitive
to Electro Static Discharge (ESD)
ØNever insert objects of any kind into the unit or through the cabinet slots as they may touch
voltage points and/or short circuit parts possibly resulting in fire or electric shock. Never spill
liquid of any kind on the unit.
ØWhen connecting up the Controller Access Controller ensure that the mains power supply is
safely isolated. Power up the controller only when installation is complete.
ØOperating conditions: 0 to 55 deg Celsius and 50 deg Celsius at 90% RH.
Fire Safety and accountabi ity Notice
When connecting card or Biometric readers to any emergency entry, exit door, barrier or elevator must
provide an alternative exit in accordance with all fire and life safety codes pertinent to the installation.
These fire and safety codes vary from city to city and you must get approval from local fire officials
whenever using an electronic product to control a door or other barrier.
Important Instructions
Care should be taken identifying the wires. mproper wiring may render permanent damage to
the device or personal injury.
Refer the color code on the Reader to connect the external weigand reader on the controller.
Check the earthing at the site before installing the controllers. Normally the earthing should be
between 1V to 2V only. Earthing on the higher side may damage the controller or its various
other components.
Before nstallation delete all data (Factory reset) using keypad menu * 90
Disc aimer
Changing of default user password is mandatory to avoid tampering of the device.
n case of user password not changed; smart will not be responsible for any tampering on the
device.
