SMART AMC-K2001 Manual de usuario

AMC 1080P/1080i HD

PTZ Color Video Cameras

User Manual V1.2

SAFETY NOTICE-IMPORTANT!!!

The following important notes must be followed carefully to run the camera and respective

accessories in total safety. The camera and relative accessories are called video system in

this section.

Before installing the camera, please read this manual carefully. Please follow installation

instructions indicated in this manual during installation. Please keep this manual for future

use.

The installation should be performed by qualified service personnel or system installers in

accordance with all local rules.

Before powering on the camera, please check the power voltage carefully. Make sure that

you are using the correct power source.

Please put the power cable, video cable and control cable in safe place.

Do not operate the camera beyond the specified temperature and humidity. Working

temperature range of the camera is between 0℃and +40℃. The ambient humidity range is

less than 95﹪.

During transporting, avoid violent shake or force to the camera.

To prevent electric shock, do not remove screws or housing of the camera. There are no

self-serviceable parts inside. Refer to qualified service personnel for servicing.

Video cable and RS485 cable should be kept far away from other cables. Shielded and

independent wiring is necessary for video and control cables.

Never aim the lens of the camera at the sun or other extremely bright objects. Otherwise, it

may cause damage.

When cleaning the camera, please use soft cloth. If the camera is very dirty, wipe it off

gently with a soft cloth moistened with a weak solution of water and a neutral kitchen

detergent. Wring all liquid from the cloth before wiping the camera, then wipe off all

remaining dirt with a soft, dry cloth. Use lens cleaning paper to clean the lens.

Do not move the camera head manually. In doing so would result in malfunction of the

camera. Do not hold the camera head when carrying the video camera.

This camera is for indoor use only. It is not designed for outdoor use.

Make sure the camera is not directly exposed to rain and water.

Make sure the camera is far away from area where radiation, X-rays, strong electric

waves, or magnetism is generated.

CONTENTS

ABOUT THE PRODUCT-------------------------------------------------------- 1

FEATURES -------------------------------------------------------------------------------- 1

LIST OF PARTS &ACCESSORIES------------------------------------------------------------ 1

MAIN PARTS &INTERFACES---------------------------------------------------------------- 2

DIP SWITCHES SETTINGS------------------------------------------------------------------ 3

REMOTE CONTROLLER -------------------------------------------------------------------- 4

CABLE CONNECTING INSTRUCTIONS --------------------------------------- 6

DVI-I INTERFACE-------------------------------------------------------------------------- 6

CABLE PACKAGE -------------------------------------------------------------------------- 7

HD-SDI INTERFACE ----------------------------------------------------------------------- 7

POWER CONNECTION---------------------------------------------------------------------- 8

REMOTE CONTROLLER OPERATION----------------------------------------- 9

POWER ----------------------------------------------------------------------------------- 9

HOME ------------------------------------------------------------------------------------ 9

CAMERA SELECTION----------------------------------------------------------------------- 9

FOCUS ----------------------------------------------------------------------------------- 9

PATTERN -------------------------------------------------------------------------------- 10

IRIS-------------------------------------------------------------------------------------- 10

BLC------------------------------------------------------------------------------------- 10

ZOOM ----------------------------------------------------------------------------------- 10

MENU ----------------------------------------------------------------------------------- 10

BACK------------------------------------------------------------------------------------ 11

DIRECTION /MENU OPERATION ----------------------------------------------------------- 11

OK-------------------------------------------------------------------------------------- 11

DATA ------------------------------------------------------------------------------------ 11

PRESET SETTING------------------------------------------------------------------------- 12

NUMBER KEYS --------------------------------------------------------------------------- 12

CANCEL --------------------------------------------------------------------------------- 12

ENTER----------------------------------------------------------------------------------- 12

LIST OF SPECIAL PRESET COMMANDS ----------------------------------------------------- 12

INSTALLATION INSTRUCTIONS--------------------------------------------- 13

DESKTOP MOUNT INSTALLATION ---------------------------------------------------------- 13

WALL MOUNT INSTALLATION -------------------------------------------------------------- 13

CEILING MOUNT INSTALLATION------------------------------------------------------------ 14

PENDANT MOUNT INSTALLATION ---------------------------------------------------------- 15

MENU SETTINGS ------------------------------------------------------------ 16

MENU CONFIGURATION ------------------------------------------------------------------- 16

MENU EXPLANATION---------------------------------------------------------------------- 20

VIDEO ---------------------------------------------------------------------------------- 21

EXPOSURE ---------------------------------------------------------------------------- 21

WHITE BALANCE----------------------------------------------------------------------- 22

PAN/TILT/ZOOM------------------------------------------------------------------------ 22

SYSTEM-------------------------------------------------------------------------------- 23

STATUS -------------------------------------------------------------------------------- 24

RESTORE DEFAULTS------------------------------------------------------------------ 24

ANNEX 1 TECHNICAL SPECIFICATIONS------------------------------------ 25

ANNEX 2 SIZE AND DIMENSION -------------------------------------------- 27

ANNEX 3 SW1 DEFINITION -------------------------------------------------- 28

TROUBLESHOOTING-------------------------------------------------------- 30

ABOUT THE PRODUCT

Features

1/2.8 inch Exmor CMOS sensor, 2.2

megapixel；

Supports full resolution up to1080/60P and

SD video formats；

Simultaneous outputs of HD and SD videos；

HD video interfaces: HD-SDI, DVI-I；

OSD menu；

20x optical zoom, 12x digital zoom；

Precise driving system with high reliability

and precision；

Support VISCA , Daisy chain and Pelco

protocols;

With IR remote controller；

Desktop/Ceiling/ Wall/Pendant mount

optional.

List of Parts & Accessories

When you open the box, check all accessories

according to the packing list.

Camera (1)

Power Adapter (1)

Remote Controller (1)

Cable Package (1)

Main Parts & Interfaces

Camera

Front View

1 Camera Module

2 Power Indicator

3 Remote Controller Indicator

Rear View

4 DVI-I interface

5 HD-SDI interface

6 Composite interfaces (CVBS output,

RS485/RS422, RS232 IN and RS232 OUT)

7 DC12V power input

Bottom View

8 DIP Switch

Set camera address, protocol, baud rate,

video format and mounting type.

9 Mounting Hole

1/4”inch screw thread for fixing camera.

10 Locating Hole

To define installation direction of camera.

11 Fixing Screw Hole (M3)

To connect the camera with pendant

mounting bracket.

ABOUT THE PRODUCT

DIP Switches Settings

Before operating the camera, set the camera

address, DVI-I output signal format and video

format etc through DIP switches. The camera

has two DIP switches: SW1 and SW2 as

below:

Note

SW1 is used to set address, video

output and mounting type, SW2 is

used to set protocol, baud rate and

video format.

Default Settings

Address

Baud Rate

9600bps

Protocol

VISCA

Video Format

1080i50

Analog Video Format

YPbPr

Mounting Type

Desktop Installation

Sw1 settings

No. 1~6 are used to set address for camera,

the DIPs adopt binary system. No. 7 is used to

set analog video format. No. 8 is used to set

mounting type. Refer to page 27 for details.

Sw2 settings

No. 1 and 2 of SW2 is used to set protocol; no.

3 and 4 is used to set baud rate; no. 5, 6, 7, 8

is used to set video output format. Refer to

below chart for details:

SW2

DIP No.

Protocol

OFF

VISCA

OFF

PELCO- D

OFF

PELCO- P

Reserved

DIP No.

Baud

Rate(bps)

OFF

2400

OFF

4800

OFF

9600

38400

DIP No.

Video

Format

OFF

1080P60

OFF

1080P50

OFF

1080i60

OFF

1080i50

OFF

720P60

OFF

720P50

OFF

1080P30

OFF

1080P25

OFF

720P30

OFF

720P25

When No.5~8 is all ON, video format can be

switched by calling preset, refer to page12.

When HD video output format is set as

1080p60,1080i60 or 720p60, relative SD

video format is NTSC; when HD video output

format is set as 1080p50, 1080i50 or 720p50,

relative SD video format is PAL.

Remote Controller

1 HOME

Press HOME button, camera moves to

initial position where both pan and tilt angle

is zero.

2 Camera Selection Button

Used to switch among 4 cameras, press 1-4

number buttons to control cameras with 1-4

addresses respectively. For example, press

button 1 to control the camera with address

3 Focus

Press“AUTO”button to switch to Auto Focus,

press “MANU” button to switch to Manual

Focus mode.

“ ”button to Focus Near

“ ”button to Focus Far

“ ”button to Auto Focus once every time

it is pressed, then switch back to Manual

Focus mode.

4 Iris

Press“ ”button to reset iris value to

default. “ ”button to Iris Open

“ ”button to Iris Close.

5 Menu

Press MENU button to enter / exit menu.

6 Data

Press DATA button to set on / off the

display of pan tilt angel, zoom times and

other prompt message.

7 Number Keys

Used to input numbers, for example, preset

number.

Tabla de contenidos

Otros manuales de Videocámara de SMART

SMART

SMART SWC-120UHD Manual de usuario

Manuales populares de Videocámara de otras marcas

Toshiba

Toshiba CAMILEO Z100 Manual de usuario

Panasonic

Panasonic NV-VS40B Manual de usuario

Canon

Canon RC 260 Manual de usuario

Sony

Sony Handycam DCR-DVD7E Manual de usuario

Brinno

Brinno TimeLapse TLC200 Manual de usuario

JVC

JVC GR-SXM68AC Guía de inicio rápido

Panasonic

Panasonic AG-HMC152EN Manual de usuario

Insignia

Insignia NS-DCC5HB09 - Camcorder - 720p Manual de usuario

MYDLINK

MYDLINK DCS-6100LH Manual de usuario

Sony

Sony video Hi8 Handycam CCD-TR555 Manual de usuario

SECURECOM

SECURECOM V-5014B Manual de usuario

Panasonic

Panasonic HDC-SD100 Manual de usuario

Sharper Image

Sharper Image U-VIDEO Manual de usuario

JVC

JVC AA-V15EG Manual de usuario

Canon

Canon LEGRIA HV40 Manual de usuario

Sony

Sony Handycam DCR-VX2000 Manual de usuario

RCA

RCA CC616 Manual de usuario

Panasonic

Panasonic NVM40 Manual de usuario