2 ADC-V522IR Installation GuideADC-V522IR Installation Guide 3
Ethernet Mode
Add the Camera to an Alarm.com Account
1Using an Ethernet cable, connect the camera to
the network.
2Connect the camera’s AC power adapter and plug it
into a non-switched outlet.
3Add the device to the account by either selecting the
account in MobileTech OR by using a web browser
and entering the following URL:
www.alarm.com/addcamera
4Select the camera from the video device list or type
in its MAC address to begin adding the camera.
The camera’s MAC address is located on the back
of the camera.
5Follow the on-screen instructions to finish adding the
camera. You may configure camera settings from the
Customer Website.
AP Mode
Add the Camera to an Alarm.com Account
To ensure sufficient Wi-Fi signal, complete these
steps with the camera near its final location but prior
to mounting.
1 Connect the camera’s AC power adapter and plug it
into a non-switched outlet.
2 Hold down the WPS button and release when the LED
begins to flash white (about 6 seconds).
3 On an Internet enabled device, connect to the wireless
network “ALARM (XX:XX:XX)” where XX:XX:XX is
the last six digits of the ADC-V522IR’s MAC address,
which is located on the back of the ADC-V522IR.
4 On the same device, open a web browser and enter
“http://522irinstall” in the URL field. Follow the on-
screen instructions to add the ADC-V522IR to the
wireless network. The LED will be solid green when the
connection is complete.
