does not indicate a malfunction
③When the wine cooler is not cooling sufficiently.
The food may be packed too tightly together which will block the flow of cool air.
You may have put something hot or a lot of foodstuffs into the wine cooler.
The door may not have been closed properly.
The wine cooler may not be ventilated.
There may be insufficient clearance between the refrigerator and the surfaces immediately both sides and above.
The temperature control dial may not be set properly.
④When the defrosting water overflows inside the wine cooler and onto the floor.
check that the drain pipe and the drain hose are not clogged.
check that the drain pan is housed properly.
⑤When the wine cooler’s cabinet front heats up.
in order to safeguard against condensation, there is an anti condensation, pipe which heats up the cabinet front
when running actuated. A war cabinet front does not indicate a malfunction.
⑥When condensation form on the outside of the wine cooler.
condensation may form on the outside when the humidity is high such as during a wet season. This is the same
result as the condensation formed when chilled water is poured into a glass. It does not, therefore, indicate a
failure, wipe dry with a dry cloth.
⑦When you hear a sound like water flowing.
A sound like water flowing is the wine cooler flowing. It does not indicate a malfunction.
⑧When the cabinet’s side panel heats up.
The side panel of the cabinet will heat up when the door is opened or closed frequently.
when starting the unit and when the unit operates in summer with high ambient outside temperature. In such case,
do not touch the panel, it results from the dissipation of the heat from inside the cabinet, and it does not mean
that something is wrong with the wine cooler.
Changing the LED light
Warning!
There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it, or
pull the fuse or the circuit breaker.
LED Light Board data: AC220~240 V, max. 1W;
To switch off the appliance;
Unplug the mains plug.
Undo the screw.
Put down the LED Light Board cover .
Change the defective light bulb.
Refit the LED Light Board cover and the screw.
Put the wine cooler back into operation.
Power Supply
The wine cooler is only applied with power supply of single phase alternating current of AC220-240Ⅴ ～
50Hz. lf fluctuation of voltage in the district user is of so large that the voltage exceeds the above scope, for safety
sake, be sure to apply A.C. automatic voltage regulator to the wine cooler. The wine cooler must employ a special
power socket instead of common one with other electric appliances. Its plug must match the socket with ground
wire.
Caution: do not use extension cord.
