Sloan_07_MA_11703024022_2014.03.04
1. Do wiring according to wiring diagram and install battery into remote control.
2. How to learn & delete ID process?
a. Wake up the remote by pressing any button except touch colour wheel. When indicator is red, then remote is active.
(Remote will switch off after 10sec. of no action)
b. Press at learning button on controller (receiver).
c. Press any zone button .... (which you desire to control) on remote.
d. Then touch colour wheel.
e. ConnectedLEDlightwillblinktoconrmzonedesignation.
f. Presslearningbuttononcontroller(receiver)forover5secondsuntilconnectedLEDlightash,theIDisnowdeleted.
If you want to learn controller (receiver) into another zone, please follow learning ID
process operation 2.
Note: Set for each zone a master, set all others on the same zone as slaves.
Set the jumper on the controller for this selection. Short circuit for master, open circuit for slave.
Each zone can set only 1 controller to be a master. After a period of time, the master will do
synchronization operation to keep the same colour or colour changing mode of all slaves in one zone.
3.How to operate R/G/B/W channels?
a. Wake up the remote by pressing any button except touch colour wheel. If controller is switched off press Power button .
Press any zone button .... (which you desire to control) on remote.
b. Short press on R/G/B/W button is for switch on off R/G/B/W channel. Short press
on R/G/B/W button again, it’s for switch off of R/G/B/W channel.
Note: If you press R, press B channel, it’s the color of “R” and “B”. If you want to get blue
color only, please press R button again to switch off of this color.
c. Long press on R/G/B/W button is for dimming up of R/G/B/W channel. Long press again on
R/B/B/W button, it’s for dimming down.
4.How to choose colour by colour wheel?
a. Wake up the remote by any pressing button except touch colour wheel. If controller is switched off press Power button .
Press any zone button .... (which you desire to control) on remote.
b. Touch colour wheel , you can get any color you want.
c. Colour wheel works with S button , you can save colours into different zone. Please refer to
point ( 8 ) .
5. How to choose preset colours?
a. Wake up the remote by pressing any button except touch colour wheel. If controller is switched off press Power button .
Press any zone button .... (which you desire to control) on remote.
b. Press shortly, then you can get preset colours from cold-white, natural-white, warm-white,
magenta, blue, ice-blue, green, yellow, orange, red. If you keep pressing then it runs through
the preset colours, relase the button then it will stop at this colour.
6.How to choose colour changing (dynamic) mode?
a. Wake up the remote by any pressing button except touch colour wheel. If controller is switched off press Power button .
Press any zone button .... (which you desire to control) on remote.
b. Press run & pause button , mode will run. Press it 1 time, it runs one mode. Press button
again, it stops, then press one more time, it will enter next colour changing mode. There are total 10 build-in colour changing modes.
c. Run & pause button can work with S button , it can save modes into different zone. Please
view below point ( 9 ).
