8 Manual_Cromatec_I_II_2021-10-007.00_EN.docx
•An incorrect operation may stop or interrupt tissue processing. Make sure
that the device is not interfered with or changed by unauthorized
personnel during operation.
An incorrect operation may stop or interrupt tissue processing. (If power is turned
off by unauthorized personnel, the dying process may be interrupted and dyeing
problems may occur.) Design the work environment so that only operators with
expertise can use the machine. (As a precaution, also consider the use of external
alarms, etc.)
•Do not bring open flames near the device.
The device uses organic solvents that can ignite when exposed to fire.
•Never allow foreign objects to enter the device.
The ingress of water, metal, paper or other foreign objects into the air inlets (to
the fan, etc.) may result in fire, electric shock, operator injury, equipment failure,
etc. If foreign objects have entered the device, switch off the device immediately
and contact the technical service department or a local representative of SLEE
medical GmbH.
•Do not operate the device while wearing metal objects on the body.
Body-worn wires (pins, jewelry, clothing, etc. made of metal) may come into
contact with the device and cause an electric shock.
•Never block the ventilation openings or air inlets on the device.
Never block the ventilation openings (air inlets) by setting them up against a wall
or objects, and do not use the unit in a poorly ventilated place or with the dust
cover still attached. This can lead to heat build-up in the device and a drop in its
performance and also cause fires, accidents, failures, etc. due to abnormal
overheating.
•Check the power cord, other cables and the power outlet regularly for
damage and dust accumulation.
Foreign objects and dust accumulation on the wall outlet can cause fires. Clean
the mains socket at regular intervals.
•Make sure that no tissue gets into the drying station and still sticks with
flammable solvent.
If stored flammable solvents are heated in the drying station and evaporate, this
can cause fires or explosions.
•Do not place the device in a place that is used as a living area.
If a common room is used, an exhaust system is required. Provide protection
against electrostatic discharge at the installation site.
•Install the device indoors. Do not place the unit in a location exposed to
direct sunlight, snow or rain.
This product is designed for indoor use; do not use it outdoors. UV radiation and
high temperatures can cause damage to the device. Never use the device when it
is exposed to snow or rain, as this could result in electric shock or short circuit.
