Remove bolts and front cap of stem
Slide handlebar into place
Replace bolts, front cap of stem
and tighten
Carefully orient the pre-assembled
handlebar and stem over the bicycle
making sure that all cable housings smoothly go to each side of the bike without being kinked,
twisted or bent.
A lign handlebar , and tighten the head set bolt .
Please be notice : The stem should be make a direction change before attaching the
handlebar .
Install the front wheel
Insert the front wheel into the fork
Make sure that the wheel is seated and centered
in the fork, and the brake disc should be fitted in
between the brake linings .
Tighten the wheel into the fork as per provided
retention device specific requirements (refer to
the following figures).
Test wheel attachment by lifting the front end of
the bike and firmly hit downward on the front wheel with your palm. There should be on
play in the connection.
Quick release binder
This type of binder is most commonly used to attach wheels to the frame and fork as well as to
tighten the seat post into the frame. They allow for a tool-free, quicker use than nuts and bolts but
require knowledge on how to properly use them.
Put the lever in an opened position (A)
Tighten the adjustment nut (1) by small increments until you need considerable force to
push (2) the lever to its closed position (B) with your fingers or palm
Adjustment of steering wheel
Stand in the front of wheel, clamp the front wheel by both legs and hold the handgrip with both
