To report any issues with this product, please contact our customer service department at (888) 274-8664.
For more information, visit www.sitonit.net
EBEAM ASSEMBLY INSTRUCTIONS
STEPS
Bottom Slot
Infeed would run up this side
Beam is shown upside-down. Beam is shown upside-down. Beam is shown upside-down.
For leg installation without wire trays, complete steps 4–6 below.
For leg installation with wire trays, see steps 7–11 (pages 6–7).
4. Flip the beam upside-down and slide in one mounting plate per leg, aligning them to the desired locations, leaving at least a
3" gap in one of the bottom slots for the power infeed and ¾" spacing from the open ends of the beam for the end caps.
5. If attaching multiple beams: From within the ganging bracket, inside of the beam (shown inverted above), fasten the
ganging bracket using the ⅛" hex L-key to install two #10–24 × ⅜" screws up into the inside bottom of the beam and four
#10–24 × ⅜" screws down into the inside top of the beam.
6. Place the legs in position and use the 3⁄16" hex L-key to secure them in place with two 5⁄16"–18 × ¾" screws per mounting
bracket. Turn beam upright. Note: Legs can be mounted in two dierent directions.
4
RECOMMENDED LEG PLACEMENT
5
6
Top of Beam
Infeed would run up this side
LEG FACES IN LEG FACES OUT
Beam is shown upside-down.
5
