1 2 3 4 5
1 The reflector bracket 2 Semicircle Clasp 3 Transition Chassis
4 The feed 5 The feed bracket
Fig.5 the configuration of the feed system
6) Antenna adjustment
a. Adjustment of antenna elevation angle:
According to calculated antenna elevation angle，preset antenna reflector to calculated
position by rotating large knob of elevation lead screw (refer to elevation scale), then
trim elevation lead screw through knob to align antenna toward satellite.
b.Adjustment of antenna azimuth angle:
According to calculated antenna azimuth angle, approximately preset antenna to
calculated azimuth angle, unscrew one large knob under tripod upright, then, referring
to the scale, rotate large knob of azimuth lead screw to align antenna toward satellite.
Adjust antenna to get optimum reception effect by azimuth & elevation adjustment,
then screw down large knob on tripod upright to prevent antenna from shake during
its operation.
4 The maintenance of the antenna
4.1 Fasten the foundation with the steel wire that the type is bigger then ∅4.One
side connect the foundation, the other side connect the anchor. Collections the antenna
when the wind is bigger then the working wind.
4.2 Smear the lubricate Grease to protect the bolt when the antenna is not used.
4.3 It should be spray-paint when the antenna’s reflector is worked two years.The
bracket and the foundation should besmear gray paint to protect when they are
damaged.
