Sinclair AMC-14Aa MOBILE SERIES Manual de usuario
USER'S MANUAL
AMC-14Aa
MOBILE SERIES
CONTENT
1. SUMMARY ．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．1
※．USAGE NOTICE ．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．
5 --
7
8. ACCESSORIES AND INSTALLATION OF DRAINAGE HOSE ．．
19--21
※．FUNCTIONS OF DISPLAYER AND PANEL ．．．．．．．．．．．．．．．．
8--1
0
3. SAFETY LABELS OF THE UNIT．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．2
2. WORKING PRINCIPLE．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．1
9. ACCESSORIES OF DRAINAGE WATER ．．．．．．．．．．．．．．．．．
. . .. . . 22
4. SPECIFICATIONS ．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．3
5. STRUCTURE．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．4
6. OPERATING METHODS ．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．． 5 --10
7. NAMES AND FUNCTIONS OF THE REMOTE CONTROLLER．．11-- 18 2
10. CARE AND MAINTENANCE ．．．．．．．．．．．．．．．．．．．．．．．．．23 --24
11. TROUBLESHOOTING．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．25
12. USER NOTICES ．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．26 -- 27
13. AFTER SALES SERVICE．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．．27
－2－
SUMMARY
－1－
This MOBILE AIR CONDITIONER is a small, movable air conditioner. It possessed the
functions of COOL, HEAT, DRY and the Separate Ventilation, and depends on different places, it
canbemovedaswill.Itisfitforhome andofficeuse,especiallyfitforthehousewithmanyrooms.
Withthecompactconfiguration,excellentworkmanship,elegantappearance,itlookslikeastanding
Benzcar. Itisconvenientformoving,energysaving,andwith lownoise.
Note:Pleasereadthismanualcarefullybeforeoperatingtheunit,themanualisusedforreference,
andthetechnicalparameters aresubjecttochangewithoutnotice.
WORKING PRINCIPLE
With the help of upper motor, the airflow of indoor pass through the evaporator becomes the
cooled wind, but with the help of lower motor, the airflow of indoor pass through the condenser
becomes the heated wind. There is two duct systems designed in its structure.The heated wind is discharged
bytherearoutlet,thecooled windisdischargedbythefrontoutlet,flow-guidedbythelouver,andit
brings the gentle cooling airflow, and the low temperature environment is maintained.
The Working Principle
Cooled wind
Uppermotor
Lowermotor
Evaporator
Airflow 1
Airflow 2
Capillary
Heated wind
Condenser
－2－
You can be killed or seriously injured if
you don't immediately follow instructions.
You can be killed or seriously injured if
you don't follow instructions .
All safety messages will tell you what the potential hazard is, how to reduce the chance of injury, and
what will happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and
obey all safety messages.
This is the safety alert symbol.
This symbol warns you to the potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER"
or "WARNING." These words mean:
SAFETY LABELS OF THE UNIT
－3－
SPECIFICATIONS
Model
Cooling capacity (Btu/h)
Rated voltage
Rated frequency
Cooling rated current (A)
Max. cooling/heating input current (A)
Cooling rated power (W)
Max. imput power (W)
Airflow (m3/h)
Refrigerant and charge amount
Noise (sound press)(cool air outlet)dB(A)
Weight (N.W.)
Dimension (H×
W
×
D) (mm)
Package dimension (H×
W
×
D) (mm)
Heating rated power (W)
Heating capacity (W)
14000
220~240V
50Hz
7.4
10.6/--
1700
2450
570
59
840×546×405
870×761×460
47
--
--
A MC-14Aa
4. Noise is tested 1m in front of front air outlet vent under cool air state, it is sound press grade.
5. Please refer performance parameter on nameplate as standard. The design are subject to be
3. Max. input power is tested under cooling mode when indoor temp. dry bulb 35℃and wet bulb 24℃.
Note:
2. Heating capacity is tected when indoor temp. dry bulb 20℃and wet bulb 12℃.
changed without notice.
1. The cooling capacity was tested in the condition of the indoor dry bulb temp.27℃,wet bulb
temp.19℃(the temp of indoor and outdoor are same) with exhaust pipe min length.
R410A 800g
6. Device is not intended for continuous running
－4－
ＳＴＲＵＣＴＵＲＥ
Ｆｒｏｎｔ
Ｒｅａｒ
Control panel
Air outlet
Handle
Upper air inlet grille
Heat air exhaust vent
Power cord
Lower air inlet grille
16℃－30℃．
The working range of COOLｍｏｄｅ ａｎｄ ＤＲＹ ｍｏｄｅ：
Place requirements:
OPERATING METHODS
－5－
※．Usage notice
Unpack the Air Conditioner
Remove packaging materials
Remove and properly dispose the packaging materials. Remove tape and glue residue from surfaces before
WARNING
Excessive Weight Hazard
Use two or more people to move and install the air conditioner.
Failure to do so can result in back or other injury.
turning on the air conditioner. Rub a small amount of liquid dish soap over the adhesive with your fingers.
Wipe with warm water and dry it.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue.
These products can damage the surface of your air conditioner.
•
•
•
Place the air conditioner on a smooth level floor that strong enough to support the unit.
Allow at least 12 inches (50 cm) of air space on all sides of the unit for good air ventilation.
Place the unit in an area where the temperature will not fall below 18℃. The coils will be covered
with frost at temperatures below 18℃, and this may reduce performance.
NOTE: The portable air conditioner has wheels for easy movement, but it should only be rolled on smooth and
flat surfaces. Do not attempt to roll the portable air conditioner on carpet or over objects.
12″(50 cm)
min.
12″(50 cm)
min.
Power must adopt the rated voltage and special circuit for AC. And diameter of power cord should be big enough.
OPERATING METHODS
－6－
Electrical Requirements
death, fire, or electrical shock.
WARNING
Electrical Shock Hazard
Plug into a grounded 3-prong outlet.
Failure to follow these instructions can result in
Do not use an extension cord.
Do not use an adapter.
Do not remove ground prong.
The portable air conditioner should be connected to a 230V 50Hz, 15 fused 3 prong grounded outlet.
Time-delay fuse or time-delay circuit breaker is recommended to be used.
All wiring must comply with local and national electrical codes and should be installed by a qualified electrician.
If you have any questions, contact a qualified electrician.
※．Usage notice
－7－
OPERATION METHOD
Earthing
There must be reliable earth
煤
气
管
Water pipe
Gas pipe
※．Usage Notice
■The wiring must be operated by the professional personnel by
protect switch and magnetic and heat drop-off air switch that with
enough capacity in fixed circuit. Don't connect earth wire to water
pipe or gas pipe. When the air conditioner is not used, please pull
out the power plug or cut off power supply.
wire in the power supply
following the national regulation. There must be electric leakage
Tabla de contenidos
Otros manuales de Acondicionador de aire de Sinclair
Sinclair
Sinclair MS-H09AICN PT Manual de usuario
Sinclair
Sinclair FREE COMBI SERIES Manual de usuario
Sinclair
Sinclair MC-C24AI Manual de usuario
Sinclair
Sinclair ASH-28AT Manual de usuario
Sinclair
Sinclair ASH-13AIA PT Manual de usuario
Sinclair
Sinclair MULTI VARIABLE SERIES Manual de usuario
Sinclair
Sinclair MATRIX ASH-24AIM PT Manual de usuario
Sinclair
Sinclair SDV5 Series Manual de usuario
Sinclair
Sinclair ASP-18AI Manual de usuario
Sinclair
Sinclair ASDH-96AI Manual de usuario
Sinclair
Sinclair AMC-11AN Manual de usuario
Sinclair
Sinclair ROCKY Series Manual de usuario
Sinclair
Sinclair ASC-60AN Manual de usuario
Sinclair
Sinclair ASH-09AIK Manual de usuario
Sinclair
Sinclair ASH-09AIP PT Manual de usuario
Sinclair
Sinclair KING ASH-09AK Manual de usuario
Sinclair
Sinclair SDV5 SDV5-100EAS Manual de usuario
Sinclair
Sinclair SF-08C Manual de usuario
Sinclair
Sinclair ZOOM Series Manual de usuario
Sinclair
Sinclair MULTI VARIABLE SERIES Manual de usuario
