CAUTION! DISCONNECT BOTH THE MONITOR AND THE COMPUTER FROM THE AC POWER SOURCE
WHILE INTERCONNECTING THE TWO UNITS.
INPUT SIGNAL
Signal types : Separate R,G,B, H/V Composite sync.
Signal levels : All TTL
Signal Polarity : VIDEO....................Positive
H/V Composite Sync.......Negative
OPERATION
1. Connect the 8-way DIN connector cable of the monitor to the mating computer
connector
2. Plug both the monitor and the computer into the AC power source
3. Turn on the monitor and computer power switches.
4. After a brief warmup period, adjust the front panel BRIGHTNESS control for
comfortable viewing. Lower levels will increase tube life and lessen screen
burn.
5. Video stability, focus, width and height have been preset at the factory and
should not require further attention. However, if you cannot obtain a
satisfactory display, return your monitor to the SINCLAIR dealer for
readjustment.
WARNING! After extended periods of operation at high temperature, turning off
the computer will activate an x-ray protection circuit in the monitor, cutting
off its raster. To restore the raster for maintenance or adjustment of the
monitor, turn off the monitor AC power switch and wait for a while before
turning it on again.
Home
Edition
This PDF created with the FREE RoboPDF Home Edition (not legal for business or government use)
Get RoboPDF: An Easy, Affordable Alternative for Creating PDFs - www.robopdf.com Buy RoboPDF
Home
Edition
This PDF created with the FREE RoboPDF Home Edition (not legal for business or government use)
Get RoboPDF: An Easy, Affordable Alternative for Creating PDFs - www.robopdf.com Buy RoboPDF
