
DataMover SS 900 Synchronous
rev 1.0
SIMREX Corporation
3 of 13
Configuration
Any terminal program can be used to configure the
DataMover Synchronous. Windows HyperTerminal, for
example, is a common choice.
The configuration port settings on the DMSS Sync
default to 9,600 baud, 8 data bits, no parity, 1 stop bit,
or more commonly seen as 9600,8,N,1. After setting up
the terminal program, apply power to the DM Sync. The
LED on the front panel labeled PWR indicates that DC
power is on.
With a terminal program running and the CONFIG port
connected, if the terminal program is set up correctly,
you will see the screen below.
This screen lists the product name, serial number,
firmware revision and it identifies the CPU used inside.
These items are all needed if you need to contact Simrex
for support for any reason.