micnode aux – Hardware User Guide
nnounce
TM
by Simpleway 2
Convenons used in this manual:
WARNING: Informaon marked ‘Warning’ alerts the user to potenal situaons that could cause personal injury or death.
CAUTION: Alerts the user to possible damage to equipment or property. By not following the instrucons, the damage caused to the equipment may not be
covered under warranty.
IMPORTANT! indicates instrucons or informaon that are vital to the successful compleon of the procedure.
NOTE is used to indicate addional useful informaon.
The intent of the lightning flash with arrowhead symbol in a triangle is to alert the user to the presence of un-insulated "dangerous" voltage within the
product's enclosure that may be of sufficient magnitude to constute a risk of electric shock to humans.
The intent of the exclamaon point within an equilateral triangle is to alert the user to the presence of important safety, and operang and maintenance
instrucons in this manual.
WARNING
1. To prevent the risk of electric shock, only qualified personnel should remove the cover.
2. Before servicing, disconnect the power supply.
3. Don’t expose the device or its equipment to water, rain, or any other liquids or liquid cleaners, as it may cause fire or electric shock.
IMPORTANT SAFETY INSTRUCTIONS
Operating temperature of the device - range 32°F – 122°F (0°C–50°C), storage temperature - range 14°F to 140°F (-10°C–60°C).
Power sourced 12V from micnode2 microphone station.
Relative humidity range during storage: 10% to 85% humidity (non-condensing).
Read these instrucons.
Keep these instrucons.
Heed all warnings.
Follow all instrucons.
Do not use this apparatus near water.
Clean only with a dry cloth.
Do not block any venlaon opening. Install in accordance with the manufacturer's instrucons
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Protect the power cord from being walked on or pinched parcularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
Only use aachments/accessories specified by the manufacturer.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally,
or has been dropped.
Adhere to all applicable, local codes.
Consult a licensed, professional engineer when any doubt or quesons arise regarding a physical equipment installaon.
The product is not intended to be installed as a system for providing emergency voice communicaon or to be installed in areas specified by ANSI/ NFPA 72,
"Naonal Fire Alarm Code."
The device is an accessory of the micnode2 microphone staon and cannot be used as a stand-alone unit.
Unpacking
1. micnode aux microphone station
2. handheld microphone
3. wall-mounting station holder
