Simfer 8661 Manual de usuario
Instruction Manual
Priručnik za uporabu
DECORATIVE CHIMNEY HOOD
DEKORATIVNAKAMINSKANAPA
GB
HR
H10-20-300-088 Rev 001
Dear Customer,
Thank you very much for your preference for Simfer products. Our
objective is to ensure that you enjoy this product, manufactured
environmentally-friendly with a total sense of quality in a precise working
environment at our modern facilities, most efficiently.
We recommend you to read the instruction manual carefully and keep
it handy before you use this Simfer chimney hood so that it maintains its
quality just like the first day you bought it and serves you most efficiently.
NOTE:
This Instruction Manual has been prepared for a variety of models.
Some of the features specified in the Manual may not exist in your device.
These features are marked with *.
Our devices are designed for domestic use. They are not for
professional use.
"PLEASE READ THE INSTRUCTIONS BEFORE YOU INSTALL OR
USE THIS DEVICE."
This product has been manufactured in an environmentally-friendly
and modern plants without harming the nature.
“Conforms with the EEE Regulations."
GB
CONTENTS:
1.SAFETY INTRODUCTIONS.................................................... 3
2. INTRODUCTION AND TECHNICAL DRAWING OF THE CHIMNEY HOOD... 4
3.INSTALLATION OF CHIMNEY HOOD....................................... 5
3.1.Location of the Chimney Hood...........................
3.2.Mounting Chimney Hood On The Wall................
3.3.Mounting the Aluminum Pipe ...........................
3.4.Installation of Outer Duct...................................
3.5.Installation of Inner Duct Mounting Bracket ......
4. .................................... 7FUNCTIONS OF THE CHIMNEY HOOD
4.1.Control Panel and its Functions........................
4.2.Operating the Chimney Hood...........................
4.3.In ducted use.................................................
4.4.Round Charcoal Filter......................................
4.5.Use of Charcoal Filter......................................
4.6.Installation of Charcoal Filter...........................
4.7.Use of Aluminum Cartridge Filter......................
5.REPLACING THE BULB..................................................... 9
5.1.Led................................................................
5.2.Candle Type Halogen Bulb...............................
6.MAINTENANCE OF THE CHIMNEY HOOD............................... 10
7.IF CHIMNEY HOOD DOES NOT WORK.................................... 11
1.SAFETY INSTRUCTIONS
ŸThis product is designed for domestic use.
ŸProduct Voltage is 220-240 Volts 50Hz.
ŸPower cord of your product is fitted with grounded plug. This cord must be
plugged into a grounding socket.
ŸAll electrical installation must be done by a qualified electrician.
ŸInstallation by unqualified persons may lead the product run with lower
performance, be damaged or cause accidents.
ŸPower supply cord should not be jammed or crushed. Power cord should
not be close to hobs, etc, otherwise it may melt and cause fire.
ŸDo not plug in the product into a socket before the installation is complete.
ŸMake sure the mains switch is easily accessible in order to cut the power of
the product in case of any danger.
ŸDo not touch the bulbs of your product if used for a long period of time. The
bulbs will be hot and may burn your hand.
ŸKitchen chimneys are designed for domestic use. If used for other
purposes, it may lead to a failure and not be covered under the warranty.
ŸFollow the authorized agencies' rules and regulations regarding letting out
the air. (This warning does not apply to usage with non-ducted chimney
hoods.)
ŸFood that may burst into flames should not be cooked under the device.
ŸTurn on the product after you place pots, pans, etc on the hobs. Otherwise
excess heat may cause deformation of some parts of your product.
ŸDo not leave hot oil on the hobs. Pans with hot oil inside may cause self-
ignition.
ŸWhen cooking i.e. deep frying, hot oil may burst into flames. Be careful on
your curtains and cloths.
ŸMake sure you replace the filters at the recommended intervals. Filters not
replaced on time carry fire risk due to increase of grease on them.
ŸDo not use non-fire-resistant materials instead of filters.
ŸKeep the potentially dangerous packaging materials away from children.
ŸDo not use your product without a filter, do not remove filters when the
product is operating.
ŸIn case of start of flames, cut off the power of the chimney fan and cooker.
(Cut off the power by unplugging the device).
GB
3
Lightining
Filter
Control Panel
Duct
1.SAFETY INSTRUCTIONS
ŸTurn off the hobs before you remove pots, pans, etc.
ŸIf the cleaning is not done periodically, your product may carry fire risk.
ŸCut off the power supply before any maintenance work. (Cut off the power by
unplugging the device.)
ŸFor duct-out chimney hoods, use pipes with a diameter of 150mm or
120mm. You should minimize the ducting distance with minimum bends.
ŸMake sure your children do not play with the product. Do not let young
children operate the product.
ŸIf the power cord is damaged, the damaged cord should be replaced by the
manufacturer or its service agent or similarly specialized personnel in order
to avoid a dangerous situation.
ŸIn case of start of flames, cut off the power of the chimney fan and cooker
and cover the flame. Do not use water to extinguish the fire.
Install "MAX 6 A" fuse for the extractor fan.
2. INTRODUCTION AND TECHNICAL DRAWING OF THE CHIMNEY HOOD
4
Installation Template Fig 1
3.INSTALLATION OF CHIMNEY HOOD
3.1.Location of the Chimney Hood
3.2.Mounting Chimney Hood On The Wall
2 drywall (8mm) anchors are nailed into the holes drilled according to
installation template (A,B). They are fixed into the wall through 2 key holes by
screws as shown in Figure 2.
GB
5
Electric Stove
Min.: 650 mm. / Max.:750 mm.
Gas Stove
Min.: 750 mm. / Max.:800 mm.
0
80
50
130
220
180
250
MAX
90
80
70
40
30
10
20
50
0
60
3.3.Mounting the Aluminum Pipe
Place the aluminum pipe on the plastic duct. Place the other end of the pipe
into the air outlet in the kitchen. Figure 2
Twists and bends on the aluminum pipe may cause minimizing the air suction
so avoid unnecessary bends and twists as much as possible. Figure 3-4
Place the inner duct and outer duct carefully on the product. Fix the inner
duct to inner duct connection plate with 2 screws.
3.4.Installation of Outer Duct
Put the outer duct on the chimney hood and fix to it by 2 screws (Figure 5)
3.5.Installation of Inner Duct Mounting Bracket
2 fixing holes are drilled on the wall with Ø6mm electric drill at a suitable
height and place to fix the inner duct hanger plate onto the wall. 6mm drywall
anchors are nailed into those holes and inner duct mounting brackrets are
pinned down. (Figure 6)
At the last step of chimney hood installation, the inner duct is screwed on the
inner duct mounting brackets.
NOTE: Packaging may not include inner duct according to model.
6
Fig 2 Fig 3 Fig 4
Fig 5 Fig 6
4.FUNCTIONS OF THE CHIMNEY HOOD
4.1.Control Panel
ŸDigital Control: touch the symbols on the keys. (On/Off function and timer
are on the same key; if pressed for 1 sec on-off function will operate. If
pressed for 3 sec. 15 minutes timer will operate.
NOTE: When the product operates for a certain time, the aluminum filters get
dirty and the digital display shows "C" Clean sign. This means the filters
should be cleaned. Press the speed reduction key for 5 secs in order to delete
"C" sign from the display.
ŸPush Buton: Pressing the buttons will enable different functions.
In order to disable them, press the button OFF.
7
ŸStops the motor, except for the lighng system.
ŸLow speed
ŸMedium speed
ŸIntense speed
ŸIt turns on and off the lighting system only.
SYMBOL FUNCTIONS
ŸSwitches on and off the motor. (Except for the lighting) If
pressed for 3 sec. motor switch off itself after15 minutes.
ŸDecreases the speed when the motor is running.
ŸDisplay
ŸIncreases the speed when the motor is running.
ŸOnly switches on and off the lighting system.
SYMBOLS FUNCTIONS
4.2.Operating the Chimney Hood
Extractor hood is used in ducted and non-ducted kitchens.
4.3.In ducted use;
In ducted use, extractor fan should be connected to an air outlet to send the
air out. In order to use your extractor hood efficiently, make sure length of the
pipe system between the extractor hood and the air outlet should be short.
Your product has been manufactured suitable for ducted and non-ducted
use.
4.4.Round Charcoal Filter
In kitchens with no duct, a round charcoal filter should be reintroduced the
clean air into the kitchen. You can obtain the round filter from your service or
dealer.
4.5.Use of Charcoal Filter
ŸOur products allow the installation of charcoal filter
ŸRegardless of use of charcoal filters or not, grease filters should be
installed on the product. Do not use your product without grease filter.
ŸUse of charcoal filteris as follows.
ŸCut off the device power before replacing charcoal filter.
ŸCharcoal filter is used in the kitchens with no duct therefore should be
replaced in every 3-5 months depending on the frequency of use.
ŸCharcoal filter should never be washed.
4.6Installation of Charcoal Filter
ŸCharcoal filters are used in the kitchens with no duct.
ŸCharcoal filters are installed onto both sides of the fan as shown in by
turning 10 degrees clock-wise. Figure 7
ŸWhen uninstalling, reverse the same procedure.
4.7Use of Aluminum Cartridge Filter
ŸAluminum cartridge filter holds dust and grease in the air. Extractor hood
should never be used without aluminum cartridge filter. Figure 8
GB
8
5.REPLACING THE BULB
Always switch off the electrical supply before carrying out any operation.
5.1.LED
ŸLED bulb does not operate is possible to remove as shown in Figure 9
ŸA new bulb to be supplied from service points is replaced with the same
reoperation.
ŸCables are designed with sockets. The plug in should be made according
to previous connection.
5.2.Candle Type Halogen Bulb
ŸBulb does not operate is possible to remove as shown in.
ŸA new bulb with the same features is replaced with removed bulb.
Note: Remove the holder on the LED bulb. Put the new LED bulb on the
holder housing of the LED bulb you removed as shown in Figure 10.
GB
9
Fig 7 Fig 8
Installing Posion
Fig 9
Kırmızı
Siyah
Fig 10
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Idiomas:
Otros manuales de Campana de ventilación de Simfer
