Silvan Selecta TR12-2 Manual de usuario

Instruction Manual

MANTR12-2 REV C 17/10/16

MODEL: TR12-2

12L TROLLEY SPRAYER

VICTORIA (HEAD OFFICE)

244- 264 Greens Rd,

Dandenong South, 3175 Australia

Telephone: +61 (03) 9215 2700

Facsimile: +61 (03) 9215 2701

www.silvan.com.au

NEW ZEALAND

22 Sunshine Avenue

Te Rapa, Hamilton, 2001 New Zealand

Telephone: +64 (07) 8496033

Fax: +64 (07) 8496070

www.silvannz.co.nz

SILVAN AUSTRALIA PTY. LTD.

ABN 48 099 851 144

Specifications

Before attempting to operate or install the sprayer carefully read and take note of the following

safety warnings.

Failure to comply with these warnings may result in serious injury or death.

Warning ! Prior to using the sprayer all operators must read and fully understand the contents of this instruction manual,

all safety information fitted to the sprayer and any other manual for associated equipment.

Warning ! Never allow an inadequately trained person to install or operate the sprayer.

Warning ! Do not spray or flammable liquids.

Warning ! Refer to the chemical manufacturer’s label for correct use and safe handling instructions of chemicals before

filling or using the sprayer. Always wear the recommended safety clothing and equipment when handling chemicals and

operating the sprayer. Ensure that all operators and associated personnel are familiar with the legal regulations and codes of

practice that apply to the safe use, storage and disposal of spray chemicals

Warning ! Exercise care to ensure proper stability when carrying or operating in hilly and uneven terrain, particularly if

the ground is wet or loose. Wear non-slip shoes.

Warning ! Before carrying out maintenance work, wash the sprayer thoroughly to remove all toxic chemicals that may

contaminate the sprayer. Wear appropriate safety clothing and equipment when carrying out maintenance. Do not clear

blocked nozzles by blowing out with your mouth.

Warning ! Never point the spray gun at any person or any part of the human body.

Warning! Dispose of empty chemical containers and chemical residues in accordance with the instructions supplied by

the chemical manufacturer

GENERAL

This trolley sprayer has been designed and manufactured primarily for the purpose of applying agricultural and

horticultural herbicides and insecticides to plants. It may also be used for cleaners and other products compatable with

Viton seals

PUMP

Flow: 2.4 L/min open flow

Pressure: 2.5 Bar

TANK

12L blow moulded translucent polyethylene tank, U.V. stabilized and impact resistant with calibrated fill mark moulded

into the tank. Safety pressure release valve fitted. Nominal capacity 12Litres

SPRAY LANCE

Trigger jet assembly with 500mm long lance supplied with adjustable nozzle

TROLLEY

2 wheel Trolley, Adjustable handle length, 150mm diameter wheels

FILTRATION:

Filter in spray lance handle.

DIMENSIONS

Length 340 mm Width 300 mm Height 900 mm Weight (dry) 3.25 kg

Safety Instructions

GUN ASSEMBLY

Fit the spray lance to the gun ensuring the rubber seal is fitted. Fit the 45 degree elbow and nozzle to the tip of

the lance again insuring the seal is in place.

SEAL POSITION

FITTING WHEELS

Fit each wheel with the supplied parts as shown

AXLE

WASHER

WHEEL

WASHER

R-CLIP

HUB CAP

AXLE

WASHER

WHEEL

R-CLIP

HUB CAP

Installation

FIT THE TROLLEY HANDLES AND ADJUST THE HEIGHT

The handle length can be adjusted by loosening the nut shown in the diagram, adjusting the length and retightening trolley

Installation

FILLING THE TANK AND ADDING CHEMICAL

Warning : Before using the sprayer for the first time or adding chemical check the operation and function of the

sprayer with clean water.

Check that the filter is clean and all fittings, hoses and gun connections are tight.

Partly fill the sprayer before adding chemical. Always use clean water to prevent blockages and ensure chemical function is

not inhibited.

Add the chemical according to the directions on the chemical container following all safety and protective equipment

recommendations.

Do not use wet powders or chemicals that must remain suspended in solution and require agitation. Only use chemicals or

dyes that fully dissolve.

Do not use a sprayer that has been used to spray herbicides for insecticides or nutrients unless the sprayer has been

thoroughly cleaned including neutralizing the herbicide according to the manufactured directions if required.

OPERATING THE PUMP

The tank is pressurised by manually pumping the handle up and down. A pressure safety valve prevents over pressurisation.

After use always release the air pressure inside the tank using the pressure safety valve, particularly in hot weather.

CLEANING THE FILTER IN THE GUN HANDLE

Use clean water and rinse out the sprayer after use to avoid the filter becoming clogged. The filter is fitted inside the handle

of the sprayer. Unscrew the hose connection to the gun and withdraw the filter using a pair of needle nose pliers and clean.

FILTER INSIDE GUN HANDLE

Service & Maintenance

Operation

SERVICING THE PUMP

To access all o-rings and seals the pump will need to be opened. Top of pump will twist open then Piston can slide out.

Remove diaphragm and clear,

replace if damaged

Check Piston O-Ring and pump O-ring is clean

and lubricated (Vaseline / Petroleum Jelly)

Service & Maintenance

Inspect under diaphragm for dirt or debris and clean

P/No TR12-20 -Spray lance

P/No TR12-21 -Pump Assembly

P/No TR12-22 -Seal Service Kit

Kit Not Shown. Includes common o-rings and seals for pump service and maintenance.

P/No TR12-23 -Handle Lock Nut

Spare Parts

TROUBLE SHOOTING GUIDE

Symptom

Remedy

No or limited pressure inside

the tank.

Air Leak

-Check pump assembly is screwed in tight. Check for dirt or damage of

sealing gasket, replace if necessary

-Check safety air release valve is tightly fitted, not damaged or making

“hiss” noise. Remove, clean then refit.

-Check Spray hose connection, where hose exits tank is tightly fitted and

connection not making “hiss” noise

Pump will not pump

-Check diaphragm on end of pump is clean, remove and wash under

clean water or replace if damaged

-Check O-Ring on piston is clean and lubricated or replace if necessary.

There is pressure inside tank

but limited or no flow from

the nozzle

The suction foot filter on the end of the spray suction tube inside the tank

is blocked. The suction tube can be removed from the tank for cleaning

by unscrewing connection on the outside of the tank

Unscrew the spray gun from the hose to access the filter inside the cun

handle to clean.

The nozzle is blocked. Unscrew the black coloured nozzle from the end

of the gun and clean all parts.

The sprayer sprays air without

water

The suction tube inside the tank has come loose. Refit

Trouble Shooting

Tabla de contenidos

Otros manuales de Pistola pulverizadora de pintura de Silvan Selecta

Silvan Selecta

Silvan Selecta 190547 Manual de usuario

Silvan Selecta

Silvan Selecta UP100-S7 Manual de usuario

Silvan Selecta

Silvan Selecta SPOTPAK SP50-S7 Manual de usuario

Silvan Selecta

Silvan Selecta Supaflo 3500 Manual de usuario

Silvan Selecta

Silvan Selecta RP70N-S7 Manual de usuario

Silvan Selecta

Silvan Selecta 200 litres Manual de usuario

Silvan Selecta

Silvan Selecta WP16-6 Manual de usuario

Silvan Selecta

Silvan Selecta TGS Manual de usuario

Silvan Selecta

Silvan Selecta TR13-1 Manual de usuario

Silvan Selecta

Silvan Selecta Utepak 100L Manual de usuario

Silvan Selecta

Silvan Selecta REDLINE SPOTPAK Series Manual de usuario

Silvan Selecta

Silvan Selecta TR25-2 Manual de usuario

Silvan Selecta

Silvan Selecta TR25-S7 Manual de usuario

Silvan Selecta

Silvan Selecta WP16-6 Manual de usuario

Silvan Selecta

Silvan Selecta K02A Manual de usuario

Silvan Selecta

Silvan Selecta 190545 Manual de usuario

Silvan Selecta

Silvan Selecta RP50-P1 Manual de usuario

Silvan Selecta

Silvan Selecta Spotpak 50L Manual de usuario

Silvan Selecta

Silvan Selecta Super 400L Series Manual de usuario

Silvan Selecta

Silvan Selecta WP12-1 Manual de usuario

Silvan Selecta

Silvan Selecta LT30-S8 Manual de usuario

Silvan Selecta

Silvan Selecta Oktopus 500L Manual de usuario

Silvan Selecta

Silvan Selecta Rakpak Plus Manual de usuario

Silvan Selecta

Silvan Selecta DEC101213P Manual de usuario

Manuales populares de Pistola pulverizadora de pintura de otras marcas

SNOWJOE

SNOWJOE Sunjoe 24V-GS-LTW-RM Manual de usuario

Graco

Graco 246737 Manual de uso y cuidado

Binks

Binks SV100 Manual de usuario

Fimco

Fimco LG-4-3-1 Manual de usuario

AG SPRAY

AG SPRAY FS-ATV-25BL Manual de usuario

Nordson

Nordson MicroMax 2 Manual de usuario

Bonide

Bonide 051 Manual de operación

zogics

zogics Z-DAS Manual de usuario

KISANKRAFT

KISANKRAFT KK-KBS-165 Manual de usuario

Matrix

Matrix SG 650 Manual de usuario

Anest Iwata

Anest Iwata SGA-3 Guía de inicio rápido

paasche

paasche VV Hoja de datos

Carlisle

Carlisle DeVilbiss JGA-510 Manual de usuario

Gardena

Gardena 11120 Manual de usuario

Conrad

Conrad Hobby Airbrush K3 Manual de usuario

wiwa

wiwa 14025 R/F Manual de usuario

Graco

Graco EM 390 Manual de operación

DeVilbiss

DeVilbiss LUNA2i Manual de usuario