LDOC039 / Rev. 0.3LMS2, Service Bulletin, Firmware Update Procedure
4
© 2016 SIL3 Pty. Ltd. – All Rights Reserved.
13. Press the LMS button once to select Chassis Zero and hold the
LMS button down until the arrow turns red. You will notice a
check mark appears, indicating that the procedure is complete.
Note: ensure the chassis is on level ground prior to completing
this procedure.
14. Ensure the Boom Zero is selected, and hold the LMS button
down until the arrow turns red. You will notice a check mark
appears, indicating that the procedure is complete. Note:
Ensure the boom angle is set to 0 degrees using a magnetic spirit
level before completing this procedure.
15. Ensure that “Back” is selected and hold the LMS button down
until the arrow turns red to return to the previous menu.
16. Select the Radio Network menu.
17. Select “Link Boom Router” and hold the LMS button down until
the arrow turns red. Note: It is important that only one LMS2
equipped machine is in the vicinity for this procedure to execute
correctly.
18. Once completed, restart the LMS display by switching the
machine off and then on again.
Standard Fork Attachments – Zero
Due to tolerances in the machines, it is sometimes desirable to set the
zero weight of the forks.
The following procedure can be completed to determine if the fork zero
needs to be set:
1. Ensure the standard forks (i.e. A0300, A0301, A0304, etc. are
fitted and that the forks are kept horizontally level.
2. Fully retract the boom.
