3
EnduraLAM 24: Setup and Operation
1. Before unpacking, carefully check for signs of apparent shipping
damage. If there is any indication that the product has been damaged,
note it on the bill of lading and contact SIGNWarehouse Product Support
or Customer Service at your earliest opportunity.
2. The power supply should match the power requirements on the
nameplate and specifications. Use a grounded three-plug power cable.
Do not change the ground wiring.
3. Controlling Feed Direction: Use the Direction toggle switch to
determine the rotating direction of the pressure rollers. To feed media
forward, press the top of the toggle switch. Press the bottom of the toggle
switch to reverse the feed and eject media.
The ON/OFF toggle switch works the same way. Push the upper toggle to
activate the rollers. Use the lower switch to stop them.
To change the direction of the media feed, use the ON/OFF switch to stop
the rollers first. Then use the Direction Switch to reverse the feed
direction. Changing the direction during operation may damage the drive
motors.
4. Adjusting Laminating Speed: Turn the dial clockwise to increase
laminating speed and counterclockwise to decrease it.
5. The sequence to disconnect the power should be done in the reverse
order of the connection sequence.
6. The film unwind and media take-up rollers are designed to
accommodate a full 50-yard roll of overlaminate film. One end of the
release liner take-up roller has a handle (Figure 1),used to adjust the
friction to ensure that the speed of the liner take-up roller is in synch with
that of the laminator pressure rollers. Rotate the handle clockwise to
increase friction and slow the liner take-up roller. Turn it
counter-clockwise to reduce friction and speed up the liner take-up roller.
7. The pressure rollers are raised and lowered by the cranks situated at
the left and right ends of the platen. Rotating the knobs clockwise lowers
the rollers. Rotating them counter-clockwise raises them. When using the
knobs to raise and lower the pressure rollers, take care to ensure that the
same amount is used on either side to ensure that the rollers remain level.
This produces even pressure and prevents skewing or wrinkling
