SIGNIFY GARDCO 161 SCONCE Manual de usuario

www.gardcolighting.com

443561201270 Rev. C

Page 1 of 3

Signify Classified - Internal

IMPORTANT !!!

MUST remove LANYARD ASSEMBLY to correctly install luminaire to SURFACE MOUNT CONDUIT BOX:

1. Loosen (2) locking screws and remove WALL MOUNTING PLATE from back of luminaire.

Discard WALL MOUNTING PLATE.

2. Remove (2) LANYARD SCREWS holding BRACKET and LANYARD in place. Discard screws,

BRACKET, LANYARD.

3. HOLES for LANYARD BRACKET SCREWS must be sealed with sealant (by others).

INSTALLATION INSTRUCTIONS

FOR WS (WALLMOUNT, SURFACE CONDUIT) OPTION,

161 SCONCE

IMPORTANT: READ ALL INSTRUCTIONS BEFORE PERFORMING ANY WORK. BE SURE

ALL POWER IS OFF PRIOR TO INSTALLING LUMINAIRES.

WARNING: LUMINAIRE MUST BE GROUNDED IN ACCORDANCE WITH APPROPRIATE

CODES. FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY.

BACK OF LUMINAIRE

Signify Classified - Internal

443561201270 Rev. C

Page 2 of 3

INSTALLATION INSTRUCTIONS

NOTE:

Splice box is secured to wall with 5/16”

bolts or screws (by others). Structural

members must be present in wall to

accept bolts.

1. Determine which hub(s) in surface mount

splice box are to be used in this

installation. Install and seal electrical

fitting(s) in hub(s). Install and seal plug(s)

in unused hub(s). Apply sealant to the two

unused holes in the top angled wall of the

splice box. Install conduit section(s) into

fittings as required.

2. Determine mounting location of splice

box. Apply a bead of sealant around each

mounting hole on the outside of the box.

For installations where conduit enters

through the back of the splice box, apply a

bead of sealant on the outside of the box

around the conduit hole used. Secure box

to wall with 5/16” bolts (by others) making

sure box is level.

3. Complete conduit installation and route

supply wires into splice box.

(cont. p. 3 of 3)

FOR WS (WALLMOUNT, SURFACE CONDUIT) OPTION,

161 SCONCE

Signify Classified - Internal

443561201270 Rev. C

Page 3 of 3

INSTALLATION INSTRUCTIONS

FOR WS (WALLMOUNT, SURFACE CONDUIT) OPTION,

161 SCONCE

4. Make electrical connections. Luminaire line to supply line, common to common, and ground to ground,

including splice box ground.

5. Place splices and excess wire in splice box. Carefully engage hanger bracket to splice box being careful not to

pinch wires. Allow luminaire to rest against box. Tighten locking screws.

FIXTURE INSTALLED

ON WS OPTION

representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. The

information presented in this document is not intended as any commercial offer and does not form part of any quotation or contract. All trademarks are owned by Signify Holding

or their respective owners.

Tabla de contenidos

Otros manuales de Luz exterior de SIGNIFY