Signal-433 Network Encoder User Manual
Chapter 2 nstallation Guide
Safety Instructions
WARNING: Hot plug is not allowed sin e it may ause system halted.
To prevent fire or ele tri al sho k, do not expose the devi e to rain or moisture.
The network en oder is powered with a voltage of 12V DC. The power supply voltage must
not ex eed the re ommended voltage, whi h otherwise may ause irreparable damage to the
devi e and the invalidation of the warranty. Therefore:
Do not repla e power supply with a voltage greater than 12V DC.
Do not onne t the devi e to the power if the power ord is damaged.
Do not plug the devi e into mains supply until all ables have been onne ted orre tly.
Do not ut the ord.
Avoid pla ing the devi e next to entral heating omponents and in areas of high humidity.
Do not over the devi e with elements that obstru t the ventilation slots.
If the network en oder has been kept in old onditions for a long time, keep it in a warm room
minimum 2 hours before plugging into the mains.
Mount the devi e in verti al position with the onne tors lo ated on the top side.
When repla ement parts are required, be sure the servi e te hni ian has used repla ement parts
spe ified by the manufa turer or have the same hara teristi s as the original part.
Unauthorized substitutes may result in fire, ele tri sho k or other hazards.
Safety he k- Upon ompletion of any servi e or repairs to this devi e, ask the servi e
te hni ian to perform safety he ks to determine that the devi e is in proper ondition.
Installations
RISK OF damage to the unit
Me hani ally handling the unit may result in damage. Do not onne t the unit to the power
Page 4 / 23
