Sign-in-China.com
Online Wholesale for AD & Signage Products
Warm Tips:
1. LCB4-I has only one air cylinder, other two bigger size machines with two cylinders.
2.The heat press machine uses electricity about 41A/50A/60 Amps, we suggest you
prepare thicker cables for safety reason.
3.You need to prepare one air compressor. And the suggested specification is that power
greater than 1.5KW, capacity about 30L, pressure more than 1MPa.
Heat Platen Test:
Each Single Copper sheathed heating rod is tested before it is cast in an aluminum alloy or
Mica Sheet. These heating rods are comparable to those found in industrial ovens that heat
up quickly, work efficiently and last many years.
Finished Machine Test:
1.
Turn on the machine, let it heating up to 200℃(392℉).
2.
Keep the temperature stay at 200℃(392℉) for at least half an hour.
IV. Installation
4.1 installation precautions
1. Before unpacking, carefully check if there is damage for the packing and machine during
transportation.
2. After unpacking, check if the service parts are correct as the packing list.
3. The installing place should be provided enough space for operating and free of dust,
novapor, no corrosive gas, no combustible or explosive substance around. Keep the
machine away from wind blowing place, otherwise will affect the roller temperature which
might bring the laminating quality.
4. After installation, adjust each caster to reach level ground. The casters only be used on
even ground for short distance movement.
Not ice: Please move carefully since it is heavy equipment.
