SIGMA TEK BWH 011 Manual de usuario
Date of creation: 11.08.2020 Version date: 17.04.2023 Article number: 12-246-011-E
BWH 011
WLAN HGW Base Station
Instruction Manual
Publisher: SIGMATEK GmbH & Co KG
A-5112 Lamprechtshausen
Tel.: +43/6274/4321
Fax: +43/6274/4321-18
Email: [email protected]
WWW.SIGMATEK-AUTOMATION.COM
Copyright © 2020
SIGMATEK GmbH & Co KG
Translation of the Original Instructions
All rights reserved. No part of this work may be reproduced, edited using an electronic system, duplicated or
distributed in any form (print, photocopy, microfilm or in any other process) without express permission.
We reserve the right to make changes in the content without notice. SIGMATEK GmbH & Co KG is not responsible
for technical or printing errors in this handbook and assumes no responsibility for damages that occur through
its use.
WLAN HGW BASE STATION BWH 011
WLAN HGW Base Station BWH 011
The BWH 011 base station serves as the gateway
of a connection between an HGW and a machine
control. Safety data (via Black Channel), as well as
Non-safety data can be redundantly transmitted,
depending on the S- DIAS control used (e.g.:
CP/SCP 111).
States can be made visible via programmable
pictogram LEDs. The base station can also
communicate with other controls over an Ethernet
interface.
17.04.2023 Page 1
BWH 011 WLAN HGW BASE STATION
Table of Contents
1 Introduction 5
1.1 Target Group/Purpose of this Operating Manual 5
1.2 Important Reference Documentation 5
1.3 Contents of Delivery 5
2 Basic Safety Directives 6
2.1 Symbols Used 6
2.2 Disclaimer 8
2.3 General Safety Directives 9
2.4 Software/Training 10
3 Standards and Directives 11
3.1 Technical Guidelines 11
3.2 Directives 11
3.2.1 EU Conformity Declaration 12
3.3 Wireless System Operation 12
4 Type Plate 13
5 Technical Data 14
5.1 Performance Data 14
5.2 Electrical Requirements 14
5.3 Environmental Conditions 16
5.4 Wireless 17
5.4.1 WLAN 2.4 GHz 17
5.4.2 WLAN 5 GHz 18
5.4.3 Antennae 18
5.5 Miscellaneous 18
6 Interfaces 19
6.1 Connections Bottom 19
Page 2 17.04.2023
WLAN HGW BASE STATION BWH 011
6.1.1 X1: M12 Y-coded (supply, Ethernet) 19
6.1.2 X2: M12 D-coded (Ethernet) 20
6.1.3 X5: Phoenix 2-pole RM 3.5 mm (Coupling LED) 20
6.2 Side Connections 21
6.2.1 X3: USB 2.0 DualRole (Type C) 22
6.2.2 X4: microSD Card 23
6.3 Display 24
6.3.1 Front LEDs 24
6.3.2 Signal Light/Coupling Light 25
6.4 WLAN 27
7 Mechanical Dimensions 29
8 Assembly/Installation 30
8.1 Check Contents of Delivery 30
8.2 Preparing the Hardware 30
8.3 Conditions 30
8.4 Check List 31
8.4.1 Determining Antennae Positions 31
8.4.2 Placing the Installation Number 32
8.5 Wiring 32
8.5.1 Ground/Shielding 32
8.5.2 ESD Protection 33
9 Status and Error Messages 34
10 Operation/Start-up 44
10.1 Configuration 44
10.1.1 Default Configuration 44
10.1.1.1 Ethernet 44
10.1.1.2 WLAN 44
17.04.2023 Page 3
BWH 011 WLAN HGW BASE STATION
10.2 WLAN Channels and Settings 45
10.3 Testing the Operating Area 46
10.4 Operation 46
10.4.1 Coupling the Operating Panel 46
10.4.2 Decoupling the Operating Panel 46
11 Help with Disruptions/Troubleshooting 48
12 Transport/Storage 49
13 Storage 50
14 Maintenance 51
14.1 Cleaning and Disinfecting the Device Surface 51
14.2 Service 51
14.3 Repair 52
15 Exchanging the microSD Card 53
16 Disposal 56
17 Accessories 57
17.1 Antennae 57
17.2 microSD Card 57
Page 4 17.04.2023
WLAN HGW BASE STATION BWH 011
1 Introduction
1.1 Target Group/Purpose of this Operating Manual
This operating manual contains all information required for the operation of the product.
This operating manual is intended for:
lProject planners
lTechnicians
lCommissioning engineers
lMachine operators
lMaintenance/test technicians
General knowledge of automation technology is required.
Further help and training information, as well as the appropriate accessories can be found on
our website www.sigmatek-automation.com.
Our support team is happily available to answer your questions.
Please see our website for our hotline number and business hours.
1.2 Important Reference Documentation
lSafety System Handbook
lHGW_BWH_Configuration Manual
lWLAN Configuration
lDocumentation Connection Cables for Operating Devices
lHW IP Address Settings
This and additional documents can be downloaded from our website or obtained through
support.
1.3 Contents of Delivery
1x BWH 011
17.04.2023 Page 5
BWH 011 WLAN HGW BASE STATION
2 Basic Safety Directives
2.1 Symbols Used
The following symbols are used in the operator documentation for warning and danger
messages, as well as informational notes.
DANGER
Danger indicates that death or serious injury will occur, if the specified
measures are not taken.
To avoid death or serious injuries, observe all guidelines.
Danger indique une situation dangereuse qui, faute de prendre les
mesures adéquates, entraînera des blessures graves, voire mortelles.
Respectez toutes les consignes pour éviter des blessures
graves, voire mortelles.
WARNING
Warning indicates that death or serious injury can occur, if the specified
measures are not taken.
To avoid death or serious injuries, observe all guidelines.
Avertissement d’une situation dangereuse qui, faute de prendre les
mesures adéquates, entraînera des blessures graves, voire mortelles.
Respectez toutes les consignes pour éviter des blessures
graves, voire mortelles.
Page 6 17.04.2023
WLAN HGW BASE STATION BWH 011
CAUTION
Caution indicates that moderate to slight injury can occur, if the
specified measures are not taken.
To avoid moderate to slight injuries, observe all guidelines.
Attention indique une situation dangereuse qui, faute de prendre les
mesures adéquates, peut entraîner des blessures assez graves ou
légères.
Respectez toutes les consignes pour éviter des blessures
graves, voire mortelles.
DANGER
Danger for persons with pacemakers, implanted defibrillators or other
active implants.
Danger pour les personnes portant un stimulateur cardiaque, un
défibrillateur implanté ou d'autres implants actifs
CAUTION
Danger for ESD-sensitive components.
Les signes de danger pour les composants sensibles aux décharges
électrostatiques.
CAUTION
Non-ionizing radiation
Rayonnement non ionisant
INFORMATION
INFORMATION
Provides important information on the product, handling or
relevant sections of the documentation, which require particular
attention.
17.04.2023 Page 7
BWH 011 WLAN HGW BASE STATION
2.2 Disclaimer
INFORMATION
The contents of this operating manual were prepared with the greatest
care. However, deviations cannot be ruled out. This operating manual is
regularly checked and required corrections are included in the subsequent
versions. The machine manufacturer is responsible for the proper
assembly, as well as device configuration. The machine operator is
responsible for safe handling, as well as proper operation.
The current operating manual can be found on our website. If necessary,
contact our support.
Subject to technical changes, which improve the performance of the
devices. The following operating manual is purely a product description. It
does not guarantee properties under the warranty.
Please thoroughly read the corresponding documents and this operating
manual before handling a product.
SIGMATEK GmbH & Co KG is not liable for damages caused
through, non-compliance with these instructions or applicable
regulations.
Page 8 17.04.2023
Otros manuales para BWH 011
1
Tabla de contenidos
Otros manuales de Accesorios de SIGMA TEK
