SIFENE SIF-1001 Manual de usuario

Centrifugal Juicer

U ser Manual

SIF-1001

Facebook: @sifenefans

Message: @sifenefans

Email:[email protected]

Contents

C hapter 1 P recau tion s for safe use

C hapter 2 P arts an d th eir fun ctio ns

C hapter 3 D irections for use

C hapter 4 M ainten ance

C hapter 5 Safety in dexes

C hapter 6 F ault an alysis an d elim in atio n

Foreword

Thank you for using our juicer. F or correct use and m aintenance of the product, we have specially

com piled this U ser’s M anual. Please read it carefully before using the product and keep it for future

reference.

This U ser’s M anual is suitable for our SIF-1001 juicers only. We reserve the right of final interpretation

of it. All contents herein are your reference for use and m aintenance only. P lease consult our customer

service department about matters not mentioned herein and give us your valuable criticisms an d

suggestions. We hope to m ake your life warm, convenient and healthy through our products.

Chapter 1: Precautions for safe use

1. M ake sure the product has an input voltage of AC 120V～60H z before use.

2. D isconnect the power supply before dismantling, assemblin g or adjusting any part.

3. The product has Y type connection. If the power cable is damaged, contact our customer service

department or have it replaced by a designated service center directly.

4. Before use, check whether any parts such as the power cable or the plug is damaged and, if it is,

stop using the product and contact our customer service department prom ptly.

5. If product m aintenance is necessary after use, contact our customer service departm ent or have the

maintenance done by a designated service center directly. It is dangerous to dism antle the product

by yourself.

6. Before connecting the power supply, m ake sure the detachable parts such as the juice strainer and

the top cover are all properly installed.

7. When the product is running, never put hands or sharp articles into its feed opening, replace the

pushing rod with any object, or have eyes close to the feed opening as this m ay cause accidents to

happen.

8. Keep the juice strainer and m otor wheels away from the operator’s body and other hard foreign

objects when the product is running to avoid personal injuries and product dam age.

9. After juicing, do not dism antle the detachable parts of the product until the m otor and the juice

strainer have both stopped and the power supply has been disconnected.

10. O perate with the rated operating tim e strictly: Juice continually for 1 minute each tim e, at most.

After ending any function above, stop for 2 minutes to end a cycle. Stop for 15 to 20 minutes after

3 successive cycles and start again after the motor has cooled down. This practice can prolong life

of the product.

11. If the product stops run ning while in use, it is possibly caused by the temperature protection of the

motor. D isconnect the power supply for cooling and use the product 15 to 20 minutes later.

12. To avoid deformation and dam age caused by heat, do not disinfect any accessories in hot water

above 80℃or microwave ovens. Parts of the juicer in contact with food materials should be clean,

hygienic, reliable and in com pliance with relevant food hygiene certification.

13. D o not place m ain unit of the product into water or other liquids, or flush out with water or other

liquids (it can be wiped with a soft cloth).

14. D o not clean the product with steel wool, abrasive cleansers, or corrosive liquids (such as gasoline

or acetone).

15. P ut the product in a place out of reach of children. U se or play of the product by persons with

disabled lim bs, sensory or m ental disorders, or by persons without relevant experience or

knowledge (including children) is forbidden.

16. D o not process any fruits or vegetables with cores, hard seeds, shells, or thick skins until their cores,

hard seeds, shells, or thick skins have been removed.

17. This product is suitable for individuals and/ or families only.

Chapter 2: Parts and their functions

N o . P art F un ction

1 Pushing rod

F or gen tly pushing the food materials in food material feeding to ensure full

contact between the food m aterials and the juice strainer and im prove

juicing efficiency.

2 Top cover

F or connecting with the main unit. As a key part for juicing and safety

protection.

3 Juice strainer

F or cutting food m aterials by the cutter holder at its bottom , filtering juice,

and separating fruit residue by the lateral strainer.

4 M otor wheel

F or connecting the juice strainer and making the juice strainer align

autom atically for convenient handling.

5 M iddle ring

F or discharging the juice separated by the juice strainer by means of pressin g

6 Juice cup cover Put cover on the juice cup to keep foreign bodies out when accepting juice.

7 Baffle To separate the fruit juice from foam .

8 Juice cup A container for accepting juice; easy for cleaning.

9 Knob switch

F or con trolling the operating status (including inching, low speed, and high

speed) of the product.

10 M ain unit

As the m ain part of the product, it contains parts such as the m otor and

serves as the power source of the product.

11 Pull rod

A key com pon ent for starting the safety switch and locking the body an d

header to allow the m achine under normal working condition.

F ruit reside

cup

F or collecting the fruit residue separated by the juice strainer by means of

pressing.

Chapter 3: D irections for use

C lean the p arts in co ntact with food m aterials thoroughly before using the product for the first tim e

(see th e con tent of “ C hap ter 4 M aintenance” ).

G ears

0: F or closin g and stop ping

Inching: Inching

1: A lo w- speed gear for processing soft fruits and vegetables

such as watermelons, tom atoes, cucumbers and

strawberries.

2: A h igh- speed gear for processing all fruits and vegetables

(see “II. Tips for fruit selection” under “ D irections for use”

for the selection of fruits, vegetables and gears)

I. U se of product

The product is designed with a dual- action safety system and can run after all parts are correctly

installed. Install and use the product following the steps below.

1 Install middle ring on the body. P roper installation is required.

Put the juice strainer

into the middle ring and properly install it on the

motor wheel (before use, check whether the juice strainer is damaged

and, if it is, do not use the product and contact a designated service

center).

3 Install the pom ace cup.

4 Put the header right above on the body and properly install it as per

the direction indicated on the header.

5 Put the pulling rod inside the two grooves of the header until

com pletely in place or the product will not work norm ally.

6 Allow the fruit juice cup baffle to slide in the juice cup alon g the neck.

Put on the cup cover.

7 Put juice cup under the outlet.

8 Align the groove of the pushing rod with the flange inside the feedin g

port and put the pushing rod inside the feedin g port.

9 C onnect the power supply. (M ake sure the switch is off before

connecting the power supply).

C lean fru its and vegetables

and cut them into blocks suitable for the

food material inlet (remove hard seeds, shells, or thick skins of the

fruits and vegetables, if any, first).

11 Activate the switch, start working with working time ≤1min.

12 Put the prepared fruit and vegetables in the feeding port.

Push the blocks of fruit and vegetables gently through the feeding port

with the pushing rod. Too m uch excessive force will affect the juicing

efficiency.

(N ever put your fingers or other objects inside the feeding port!

D isconnect the power and clean the pomace cup when the pomace or

juice cup is filled.)

When there is no longer juice flowin g via the juice outlet after good

material processing, turn the switch off, disconnect th e power supply

and take the juice cup from the juice nozzle after the m otor and the

juice strainer have both stopped running (drink the juice soon,

otherwise its taste and nutrition will both be influenced after som e

tim e from exposure to air).

Take the j

uice cup away from the outlet nozzle when the m otor and

juicing screen has completely stopped.

The foam baffle attached to the juice cup m ay help you obtain a cup

of foam less juice. The baffle may be neglected if juice with foam is

required.

Chapter 4: Maintenance

1 Turn the power switch off before cleaning the product.

2 Clean the product promptly after use.

Exterior of m ain unit of the product m ay be wiped with a wet cloth. D o not

place the m ain un it of the product into water or other liquids, or flush out with

water or other liquids.

4 Store the product in a dry place without direct ultraviolet rays.

5 M ake sure the product is clean and dry before storing it.

6 Clean the detachable parts followin g the steps below.

1 Take out the pushing rod.

2 Pull open the pull rod from right direction and take off the header.

3 Remove the juice strainer and the middle ring in order.

4 With water, clean the pom ace cup, middle ring, juicing screen, and juice cup

successively.

Chapter 5: Safety indexes

As a class II electric appliance, this product needs no grounding device.

Chapter 6: Fault analysis and elimination

F ault P ossible cause Elimin ation

After the power supply is

connected and the switch

is turned on, the product

does not run.

1. The m iddle ring is not

correctly installed.

2. The top cover is not

correctly installed.

3 The top cover contact has

fractured.

1. Install the m iddle rin g correctly.

2. Install the top cover correctly.

3. R eplace the top cover.

There is a bad sm ell from

the motor the first few

tim es using the product.

It is normal.

If the bad smell still exists after the product has been

used several times, have the product tested by a

designated service center.

Rated voltage 120V~

Rated power 400W

Rated frequency 60H z

Continual juicing tim e ≤1 m in .

Time interval ≥2 m in .

The product stops

autom atically while in use.

1. The voltage is too low.

2. There are too m any food

materials in the product.

3. The pushing was rod is

pushed too violently.

4. The m otor is under

temperature protection.

1. Check wh ether the voltage is too low.

2. D isconnect the power supply and rem ove the surplus

food m aterials.

3. G ently push the pushing rod.

4. Stop the product and start it again 20 to 30 m inutes

later.

There is a lot of residue in

the juice.

1. The juice strainer is

damaged.

2. There is a lot of residue in

the m iddle ring.

1. R eplace the juice strainer.

2. C lean the m iddle ring.

The product has abnormal

vibration or big noise.

1. The juice strainer is not

correctly installed, resulting in

poor running balance.

2. The product is not steadily

placed or the foot pad has

fallen off.

3. The voltage is too high; or

4. There are m any food

materials in the product.

1. Install the juice strainer correctly.

2. P lace the product steadily or install the foot pad

correctly.

3. Check wh ether the voltage is too high.

4. D isconnect the power supply and rem ove the surplus

food m aterials.

There is very little juice.

1. There is a lot of residue in

the middle rin g.

2. The pushing rod was

pushed too violently.

1. Clean the m iddle ring.

2. G ently push the pushing rod.

The cutter holder is

seized.

The cutter holder is wound or

seized by food m aterials.

D isconnect the power supply, take out the food

materials and cut them into sm aller blocks.

N otes:

The table above introduces the com mon faults and their cause analysis and elimination m ethods. F or

other faults, contact our custom er service department or have the product repaired by a designated

service center directly. D o not dism antle or repair the product by yourself.

Facebook: @sifenefans

Message: @sifenefans

Email:[email protected]

Otros manuales de Exprimidor de SIFENE

SIFENE

SIFENE SIF-10011 Manual de usuario

SIFENE

SIFENE SIF-3301 Manual de usuario

Manuales populares de Exprimidor de otras marcas

GE 169201 Manual de usuario

Exquisit

Exquisit ZP 3001 WET Manual de usuario

Philips

Philips HR1851 Manual de usuario

Sam Cook

Sam Cook MASTERCHEF EXECUTIVE PSC-50 Manual de usuario

Termozeta

Termozeta spremiagrumi Manual de usuario

ElectrIQ

ElectrIQ WF1000 Manual de usuario

Bella

Bella WHOLE FRUIT JUICER Manual de usuario

HAEGER

HAEGER Little Juice CJ-025 006A Manual de usuario

Havells

Havells Fusion Manual de usuario

Siemens

Siemens MK554 SERIES Manual de usuario

Beper

Beper 90.302B Guía rápida

NATURSAFT

NATURSAFT 015.401.3 Manual de usuario

Moulinex

Moulinex BKB 2 Manual de usuario

Royal Catering

Royal Catering RCJU-01 Manual de usuario

camry

camry CR 4002 Manual de usuario

AIGOSTAR

AIGOSTAR 30HIM Manual de usuario

ZUMEX

ZUMEX MINEX Manual de usuario

Skymsen

Skymsen EX Manual de usuario