Siemens SITRANS AS100 Manual de usuario

Instruction Manual April 2005

AS 100

sitrans

Safety Guidelines: Warning notices must be observed to ensure personal safety as well as that of

others, and to protect the product and the connected equipment. These warning notices are

accompanied by a clarification of the level of caution to be observed.

Qualified Personnel: This device/system may only be set up and operated in conjunction with this

manual. Qualified personnel are only authorized to install and operate this equipment in accordance with

established safety practices and standards.

Unit Repair and Excluded Liability:

• The user is responsible for all changes and repairs made to the device by the user or the user’s

agent.

• All new components are to be provided by Siemens Milltronics Process Instruments Inc.

• Restrict repair to faulty components only.

• Do not reuse faulty components.

Warning: This product can only function properly and safely if it is correctly transported, stored,

installed, set up, operated, and maintained.

Note: Always use product in accordance with specifications.

This document is available in bound version and in

electronic version. We encourage users to purchase

authorized bound manuals, or to view electronic versions

as designed and authored by Siemens Milltronics Process

Instruments Inc. Siemens Milltronics Process Instruments

Inc. will not be responsible for the contents of partial or

whole reproductions of either bound or electronic

versions.

While we have verified the contents of this

manual for agreement with the

instrumentation described, variations

remain possible. Thus we cannot

guarantee full agreement. The contents of

this manual are regularly reviewed and

corrections are included in subsequent

editions. We welcome all suggestions for

improvement.

Technical data subject to change.

MILLTRONICS®is a registered trademark of Siemens Milltronics Process Instruments Inc.

Contact SMPI Technical Publications at the following address:

Technical Publications

Siemens Milltronics Process Instruments Inc.

1954 Technology Drive, P.O. Box 4225

Peterborough, Ontario, Canada, K9J 7B1

Email: techpubs.smpi@siemens.com

• For a selection of Siemens Milltronics level measurement manuals, go to:

www. siemens.com/processautomation. Under Process Instrumentation, select

Level

Measurement

and then go to the manual archive listed under the product family.

• For a selection of Siemens Milltronics weighing manuals, go to:

www. siemens.com/processautomation. Under Weighing Technology, select

Continuous

Weighing Systems

and then go to the manual archive listed under the product family.

Table of Contents

General Information ...........................................................................................................1

SITRANS AS 100 Sensor ......................................................................................................................1

Features .....................................................................................................................................................1

Specifications ......................................................................................................................2

Outline and Dimensions ....................................................................................................4

Installation ...........................................................................................................................6

Ideal Locations .........................................................................................................................................6

Conditions to Avoid .................................................................................................................................6

Conditions to Consider ...........................................................................................................................6

Mounting .............................................................................................................................7

Temperature Considerations ................................................................................................................8

Interconnection ...................................................................................................................9

SITRANS AS 100 Standard Temperature Version (ST) .................................................................9

Extended Temperature Version (ET) ..................................................................................................9

Analog Output ........................................................................................................................................10

Relative Sensitivity ................................................................................................................................10

Applications ....................................................................................................................... 11

Pneumatic Conveyor ............................................................................................................................11

Screw Conveyor Discharge ................................................................................................................11

Diverter Gate ..........................................................................................................................................11

7ML19985DM02 SITRANS AS 100 – INSTRUCTION MANUAL Page 1

General Information

SITRANS AS 100 Sensor

SITRANS AS 100 is an acoustic sensor for flow detection. It monitors high frequency

acoustic emissions (sound waves) generated by:

• the friction and impact of solids flow in pipes, chutes, and conveyors

• cavitation occurring in pumps, pipes, and valves

• turbulence of gases or liquids leaking through valves and flanges

• friction and jarring of mechanical parts

Acoustic emissions travel readily through solid materials such as metal, but are strongly

attenuated when traveling through air. As such, the Sensor is immune to airborne

interferences and provides a non-invasive method of monitoring process activities.

The sensor can be configured electrically during wiring to operate in either low or high

sensitivity range mode. The high sensitivity range applies where highest signal levels

vary up to 40 dB. The low sensitivity range applies where highest signal levels vary

between 28 and 68 dB.

SITRANS AS 100 Sensor provides an analog output for use with the Sitrans Control Unit.

The Sensor may be operated independently from the Control Unit by providing an external

supply. The output is fed into a control panel, chart recorder, data logger, or

programmable logic controller with a suitable input.

SITRANS AS 100 Sensor is primarily used for solids flow detection. However, this device

can be used in pump cavitation and fluid leak detection, provided sufficient noise levels

are generated.

Features

• non-invasive

• screw in, bolt on, weld, or bond in place

• analog output

• high and low sensitivity range of operation

Page 2 SITRANS AS 100 – INSTRUCTION MANUAL 7ML19985DM02

Specifications

Model

• standard standard operating temperature range (see below)

• extended extended operating temperature range (see below)

Power

• 20 to 30 V DC

• 18 mA typical

Operating Temperature

• standard1-20 to 80 °C (-4 to 176 °F)

•extended:

-30 to 120 °C (-22 to 248 °F)2or

-40 to 125 °C (-40 to 257 °F)

Relative Sensitivity

• 0.5% / °C of reading, average over the operating range

Output

• analog, 0.08 to 10 V DC nominal, 100 KΩminimum load impedance

Construction

• housing 304 stainless steel

303 stainless steel (hazardous rated version)

• cable standard: 4 m (13 ft) cable, PVC jacketed, 3 twisted pairs, 24 AWG,

shielded

extended: 4 m (13 ft) cable, thermoplastic elastomer jacketed, 6

conductor, 24 AWG conductor, shielded

1. Class II and ATEX II versions available

2. Class II version available

7ML19985DM02 SITRANS AS 100 – INSTRUCTION MANUAL Page 3

Ingress Protection

• IP 68 (waterproof) The IP 68 test was performed by immersing the enclosure in 1.8m of

water for 30 minutes.

Weight

• 0.4 kg (1 lb.)

Approvals

•General CE

• Hazardous Europe: ATEX II 3D

US: FM Class II, Div. 1, Groups E, F, G

Canada: CSA Class II, Div. 1, Groups E, F, G

Page 4 SITRANS AS 100 – INSTRUCTION MANUAL 7ML19985DM02

Outline and Dimensions

SITRANS AS 100 (ST and ET Versions)

SITRANS AS 100 (Class II Rated ST and ET Versions)

8mm

(0.3")

44mm

(1.8")

36mm

(1.4")

17mm

(0.7")

67mm

(2.7")

mounting post, 17A/F

nut and M10 thread

6 x 24 AWG cable

8mm

(0.3") 44mm

(1.8")

36mm

(1.4")

32mm

(1.3")

82mm

(3.2")

mounting post, 17A/F

nut and M10 thread

6 x 24 AWG cable

½" NPT

(CSA and FM approvals)

M20 (ATEX approval)

female conduit fitting

7ML19985DM02 SITRANS AS 100 – INSTRUCTION MANUAL Page 5

Accessories

Extension Tab (optional)

Mounting Disc (optional)

Note: Both Tab and Disc are 304SS.

10mm

(0.4")

85mm

(3.3")

15mm

(0.6")

15mm

(0.6")

bolt hole,

14mm

(0.55")Ø

SITRANS AS 100 mounting hole

M10 thread

30mm

(1.2")

30mm (1.2")Ø

SITRANS AS 100 mounting hole

M10 thread

15mm

(0.6)

Page 6 SITRANS AS 100 – INSTRUCTION MANUAL 7ML19985DM02

Installation

Ideal Locations

• areas where the acoustic emission levels are highest and most consistent

• where the material impact is greatest

• areas closest to the point of leakage (e.g. valve body)

• closest point to source of cavitation (e.g. pump body)

Conditions to Avoid

• non-metallic surfaces, as these tend to attenuate acoustic emission levels

• pipes with non-metallic liners as these tend to attenuate acoustic emission levels

Conditions to Consider

• joints and interfaces attenuate the acoustic emission levels.

• minimal temperature variation where acoustic emission levels are weak.

• location should provide sufficient response time in alarm or control circuit. e.g. loss

of bearing lubrication, plug chute detection.

Solids Flow Sensing

Good friction between product and

piping. Mount Sensor on the

upstream side of gasket for highest

level of acoustic emission activity.

Minimal amount of acoustic emission

activity due to limited friction

between product and piping.

Recommended Not Recommended

Otros manuales para SITRANS AS100

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Accesorios de Siemens

Siemens

Siemens SITRANS FSS200 Manual de usuario

Siemens

Siemens 5WG1 201-2DBx3 Series Manual de usuario

Siemens

Siemens 3200 Series Manual de usuario

Siemens

Siemens SITRANS WS300 Manual de usuario

Siemens

Siemens Milltronics RBSS Manual de usuario

Siemens

Siemens Milltronics RBSS Manual de usuario

Siemens

Siemens Symaro QSM2100 Manual de usuario

Siemens

Siemens QAA2280.xWNC Manual de usuario

Siemens

Siemens SITRANS LG270 Manual de usuario

Siemens

Siemens RUGGEDCOM WIN7025 Manual de usuario

Siemens

Siemens QSA2700D Manual de usuario

Siemens

Siemens SIMATIC ET 200SP Manual de usuario

Siemens

Siemens QFM3100 Manual de servicio

Siemens

Siemens SITRANS WFS320 Manual de usuario

Siemens

Siemens jpQO Manual de usuario

Siemens

Siemens HFPO-11 Manual de usuario

Siemens

Siemens RUGGEDCOM WIN7018 Manual de usuario

Siemens

Siemens SITRANS WW100 Manual de usuario

Siemens

Siemens SITRANS WS300 Manual de usuario

Siemens

Siemens Milltronics TASS Manual de usuario

Siemens

Siemens milltronics MFA 4P Manual de usuario

Siemens

Siemens AP 257/42 Manual de servicio

Siemens

Siemens DELTA 5TC1 01 Manual de servicio

Siemens

Siemens QAA2391.EWTC Manual de usuario

Manuales populares de Accesorios de otras marcas

Hillco

Hillco 2810 Manual de usuario

Contours

Contours ZY024 Manual de usuario

Saivod

Saivod VS621 Manual de usuario

Virtuox

Virtuox VirtuCLEAN 2.0 Manual de usuario

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manual de usuario

Z-Wave

Z-Wave HSD-200Z Manual de usuario

turck

turck FMX-IM-2UPLI63FX Manual de usuario

Decagon Devices

Decagon Devices 10HS Manual de usuario

UPPAbaby

UPPAbaby Cup Holder Manual de usuario

Elko

Elko SmartSensor Leakage Wireless Manual de usuario

Grizzly

Grizzly H8371 Manual de usuario

Panasonic

Panasonic HG-T Series Manual de usuario

IFM Electronic

IFM Electronic Efector 250 Series Guía de referencia

DigiDesign

DigiDesign 888/24 I/O Manual de usuario

PROZIS

PROZIS QUAY Manual de usuario

patagonia

patagonia PSI Vest Manual de usuario

SFC Energy

SFC Energy EFOY GO! Manual de usuario

Axminster

Axminster Tooling Stylus Tip Ballpoint Pen Kit Manual de usuario