4.Water Connection
Please read and understand these instructions thoroughly and completely
prior installation and before use. Failure to follow the installation
instructions and operating instructions thoroughly or improper use voids
the warranty. Failure to follow these instructions could cause property
damage or serious bodily injury and/or death. MAKE SURE ALL
ELECTRICAL POWER IS TURNED OFF AT ALL TIMES OF INSTALLATION.
All SIDFEN ELECTRIC TANKLESS WATER HEATERS MUST BE INSTALLED BY
A LICENSED ELECTRICIAN AND PLUMBER IN ACCORDANCE WITH ALL
NATIONAL, APPLICABLE STATE, PROVINCIAL, AND LOCAL ELECTRICAL AND
PLUMBING CODES PRIOR TO THE INSTALLATION OF ANY SIDFEN ELECTRIC
TANKLESS WATER HEATER.
DO NOT SOLDER ANY PIPES WITH WATER HEATER CONNECTED TO PIPES.
IF YOU DO, YOU MAY DAMAGE THE WATER HEATER AND VOID THE
WARRANTY.
We recommend that a manual shut-off valve be installed on the inlet side of the
water heater so there is a convenient shut-off point available in the event that
future maintenance or servicing is required.
Step 1
Install the COLD WATER and HOT WATER lines to the desired location.
▶IMPORTANT:
Before connecting these pipes to the water heater hoses if used. It is extremely
important to FLUSH the lines to eliminate all plumbing paste or residue in the lines
caused by any welding or soldering.
Step 2
Due to our great design and flexibility
there are several ways to attach your
SIDFEN electric tankless water heater
for your hot water needs. We recommend
you consult your licensed plumber to
discuss the best option for you.
Connect the COLD WATER line to the
water heater line marked INLET located
on the right side of the water heater when
facing the water heater. Connect the
HOT WATER line to the water heater line
marked OUTLET on the left side when
facing the water heater. The inlet and the
outlet can not be reversed. Make sure
that the water pipes are securely
mounted(Fig15).
▶IMPORTANT:
▶RECOMMENDATION:
COLD
WATER
Gasket
INLET
OULET
HOT
WATER
-10-
Fig15
