PROBLEMS CAUSES SOLUTIONS
Transmitter
not working
1 .The transmitier switch is on "OFF" 1.Turn on the transmitter
2.lnstall the batteries improperly 2.Check with the pole indications
and reinstall the batteries again
3.Batteries are completely consumed 3.Replace with new batteries
Control failure
I .The iransmitter switch rs on "OFF" 1.Turn on the transmitier
2.The fuselage switch is on "OFF" 2.Turn on the fuselage
3.The antenna is installed
improperly or is pulled out
incompletely
3.Reinstall the antenna and pull it
out completely
4.Fly with strong winds 4.Do not fly the helicopter in
windy conditions
5.The transmitter indicator is
flash ing 5.Pull down the throttle stick to the
end and replace the batteries
Ascendi ng
failure
1.The rotation of main blades is too slow 1 . Push up the throttle stick
2.The fuselage battery is well
consumed 2.Recharge the fuselage battery
Landing too soor The throttle stick is pulled down
too fast Pull down the throttle stick slowly
to perform a smooth landing
PRECAUTIONS:
1 .lnsufficient electricity power will shorter the control distance.
2.lnsuff icient electricity power will lead to difficulties in taking off and ascending.
3.Fix the helicopter in time if there is any damage. Flying a damaged helicopter could
cause injuries.
4.Remove the transmitter batteries if not in use for a long time in case of battery Ieakage.
5.Avoiding dropping and crashing the helicopter for it will lead to damages and shorten
the use life.
6.Before flying, always turn on the transmitter switch first, then the fuselage switch.
Otherwise, the helicopter will be confused with extraneous signal and be out of control.
T.After f lying, always turn off the f uselage switch f irst, then the transmitter switch.
Otherwise, the helicopter will be confused with extraneous signal and be out of control.
-7-
