1.7 Parameters setting
By using the buttons below the display (he einafte efe ed to as [\/] , [<>], [/\] ) you can pa amete ize the d ive:
●To access to main menù, p ess [\/] + [<>] , it will visualized “menu” fo 1 sec , afte the pa amete “p001”
●F om the main menu to select the pa amete to be changed p ess the button [\/] o [/\].
●F om main menù to visualize the actual value of pa amete p ess [<>].
●F om the pa amete to change the value p ess [\/] o [/\]
●F om the pa amete to sto e the value p ess the button [<>] fo 1 sec and it will appea “memo”
●F om the pa amete to come back at main menù without modify any conditions, p ess [<>] less than 1 sec
(don’t will appea “memo”).
●F om the main menù to go out p ess [<>] + [/\].
NOTE: Fo settings PROFINET pa amete s efe to attach
Legend MODE:
ST = Step/Di ection
WS = RS485 SHS P otocol
MB = Modbus
CO = CanOpen
PARAMETER MODE FUNCTION
p001 ST+WS+MB+CO
p002 ST+WS+MB+CO
p003 ST+WS+MB Curr nt s tting [A]
p004 WS+MB+CO S tting s rial Baud Rat
p005 WS+MB+CO S tting s rial addr ss
p006 ST+WS+MB
p007 ST+WS+MB S tting stand-by curr nt ( 0, 25, 50, 100% )
p008 ST+WS+MB
p009 ST+WS+MB
p010 ST+WS+MB S tting wav mod ( wav0, wav1 )
p011 ST+WS+MB S tting to op rat high fr qu ncy
p012 R s rv d R s rv d param t r for diagnostic
p013 MB
0par : wh n this param t r is stor d, all
param t rs will b s t to d fault valu and it
will app ar “rst” th n r start th driv r.
S t th s rial mod “ser” or st p/Dir ction
“step”, if th mod is chang d, aft r “memo”
will app ar “rst” and th driv will r start
S tting st p r solution ( 1/2, ..., 1/20 )
S tting param t r r sonanc 1 r duction
( fd0, ..., fd4 )
S tting param t r r sonanc 2 r duction
( small, big )
S tting s rial parity ( n, , o )
