Showgear Powerport 3 Manual de usuario

Powerport 3

Highlite International B.V. –Vestastraat 2 –6468 EX –Kerkrade –the Netherlands

Product code: 50275

USER MANUAL

ENGLISH

Powerport 3

Product code: 50275

Preface

Thank you for purchasing this Showgear product.

The purpose of this user manual is to provide instructions for the correct and safe use of this product.

Keep the user manual for future reference as it is an integral part of the product. The user manual shall be

stored at an easily accessible location.

This user manual contains information concerning:

●Safety instructions

●Installation and operation of the device

●Intended and non-intended use of the device

●Maintenance procedures

●Troubleshooting

●Transport, storage and disposal of the device

Non-observance of the instructions in this user manual may result in serious injuries and damage of

property.

No part of this document may be copied, published or otherwise reproduced without the prior written

consent of Highlite International.

Design and product specifications are subject to change without prior notice.

For the latest version of this document or other language versions, please visit our website

www.highlite.com or contact us at service@highlite.com.

Highlite International and its authorized service providers are not liable for any injury, damage, direct or

indirect loss, consequential or economic loss or any other loss arising from the use of, or inability to use or

reliance on the information contained in this document.

Powerport 3

Product code: 50275

Table of contents

1. Introduction..........................................................................................................................................................3

Before Using the Product ..................................................................................................................................3

Intended Use .......................................................................................................................................................3

Text Conventions ................................................................................................................................................3

Symbols and Signal Words................................................................................................................................4

Symbols on the Information Label ..................................................................................................................4

2. Safety ....................................................................................................................................................................5

Warnings and Safety Instructions ....................................................................................................................5

Requirements for the User.................................................................................................................................7

3. Description of the Device ...................................................................................................................................7

Overview..............................................................................................................................................................7

Product Specifications ......................................................................................................................................8

Dimensions...........................................................................................................................................................8

4. Setup and Operation ..........................................................................................................................................9

Safety Instructions for Installation ....................................................................................................................9

Installation Site Requirements ..........................................................................................................................9

Connecting to Power Supply.........................................................................................................................10

Power Linking of Multiple Devices.................................................................................................................10

5. Troubleshooting .................................................................................................................................................11

6. Maintenance .....................................................................................................................................................11

Safety Instructions for Maintenance.............................................................................................................11

Preventive Maintenance................................................................................................................................11

Basic Cleaning Instructions ...................................................................................................................12

Corrective Maintenance................................................................................................................................12

7. Deinstallation, Transportation and Storage ....................................................................................................12

8. Disposal ..............................................................................................................................................................12

9. Approval.............................................................................................................................................................12

Powerport 3

Product code: 50275

1. Introduction

Before Using the Product

Important

Read and follow the instructions in this user manual before installing, operating or

servicing this product.

The manufacturer will not accept liability for any resulting damages caused by the non-observance of

this manual.

After unpacking, check the contents of the box. If any parts are missing or damaged, contact your

Highlite International dealer.

Your shipment includes:

Showgear Powerport 3

User manual

Fig. 01

Intended Use

This device is intended for professional use as a power distribution unit. It is suitable only for indoor use. This

device is not suitable for households.

Any other use, not mentioned under intended use, is regarded as non-intended and incorrect use.

Text Conventions

Throughout the user manual the following text conventions are used:

Buttons: All buttons are in bold lettering, for example “Press the UP/DOWN buttons”

References: References to chapters and parts of the device are in bold lettering, for example:

“Refer to 2. Safety”, “turn the adjustment screw (02)”

0–255: Defines a range of values

Notes: Note: (in bold lettering) is followed by useful information or tips

Powerport 3

Product code: 50275

Symbols and Signal Words

Safety notes and warnings are indicated throughout the user manual by safety signs.

Always follow the instructions provided in this user manual.

DANGER

Indicates an imminently hazardous situation which, if not avoided, will result in

death or serious injury.

WARNING

Indicates a potentially hazardous situation which, if not avoided, could result in

death or serious injury.

CAUTION

Indicates a potentially hazardous situation, which, if not avoided, may result in

minor or moderate injury.

Attention

Indicates important information for the correct operation and use of the

product.

Important

Read and observe the instructions in this document.

Electrical hazard

Provides important information about the disposal of this product.

Symbols on the Information Label

This product is provided with an information label. The information label is located on the backside of the

device.

The information label contains the following symbols:

This device is designed for indoor use.

This device falls under IEC protection class I.

This device shall not be treated as household waste.

Read and follow the instructions in the user manual before installing, operating or

servicing the device.

Powerport 3

Product code: 50275

2. Safety

Important

Read and follow the instructions in this user manual before installing, operating or

servicing this product.

The manufacturer will not accept liability for any resulting damages caused by the non-observance of

this manual.

Warnings and Safety Instructions

DANGER

Danger for children

For adult use only. The device must be installed beyond the reach of children.

Do not leave various parts of the packaging (plastic bags, polystyrene foam, nails, etc.) within

children’s reach. Packaging material is a potential source of danger for children.

DANGER

Electric shock caused by dangerous voltage inside

There are areas within the device where dangerous touch voltage may be present.

●Do not open the device or remove any covers.

Disconnect the device from electrical power supply before service and maintenance, and when the

device is not in use.

DANGER

Electric shock caused by short-circuit

This device falls under IEC protection class I.

Make sure that the device is electrically connected to ground (earth). Connect the device only to a

socket-outlet with ground (earth) connection.

Do not cover the ground (earth) connection.

●Do not immerse the device in water or other liquids. Do not install the device in a location where

flooding may occur.

Do not use the device during thunderstorms. Disconnect the device from the electrical power supply

immediately.

Powerport 3

Product code: 50275

Attention

Power supply

●Before connecting the device to the power supply, make sure that the current, voltage and

frequency match the input voltage, current and frequency specified on the information label on the

device.

●Make sure that the cross-sectional area of the extension cords and power cables is sufficient for the

required power consumption of the device.

Attention

General safety

●Do not shake the device. Avoid brute force when installing or operating the device.

●If the device is dropped or struck, disconnect the device from the electrical power supply

immediately.

If the device is exposed to extreme temperature variations (e.g. after transportation), do not switch it

on immediately. Let the device reach room temperature before switching it on, otherwise it may be

damaged by the formed condensation.

If the device fails to work properly, discontinue the use immediately.

Attention

For professional use only

This device shall be used only for the purposes it is designed for.

This device is designed to be used as a power distribution unit. Any incorrect use may lead to hazardous

situations and result in injuries and material damage.

●This device is not suitable for households.

●This device is not designed for permanent operation.

This device does not contain user-serviceable parts. Unauthorized modifications to the device will

render the warranty void. Such modifications may result in injuries and material damage.

Attention

Before each use, examine the device visually for any defects.

Make sure that:

All screws used for installing the device or parts of the device are tightly fastened and are not

corroded.

There are no deformations on housings, fixations and installation points.

The power cables are not damaged and do not show any material fatigue.

Powerport 3

Product code: 50275

Attention

Do not expose the device to conditions that exceed the rated IP class conditions.

This device is IP20 rated. IP (Ingress Protection) 20 class provides protection against solid objects greater

than 12 mm, such as fingers, and no protection against harmful ingress of water.

Requirements for the User

This product may be used only by instructed or skilled persons. Installation and maintenance can be

carried out by instructed or skilled persons. Service shall be carried out only by skilled persons. Contact

your Highlite International dealer for more information.

Instructed persons have been instructed and trained by a skilled person, or are supervised by a skilled

person, for specific tasks and work activities associated with the installation, service and maintenance of

this product, so that they can identify risks and take precautions to avoid them.

Skilled persons have training or experience, which enables them to recognize risks and to avoid hazards

associated with the installation, service and maintenance of this product.

Ordinary persons are all persons other than instructed persons and skilled persons. Ordinary persons

include not only users of the product but also any other persons that may have access to the device or

who may be in the vicinity of the device.

3. Description of the Device

The Powerport 3 is a compact power distribution unit. The device is equipped with a Neutrik powerCON

input and 3 Neutrik powerCON outputs. The maximum allowed current load is 16 A, divided over 3

outputs.

Overview

Fig. 02

Neutrik powerCON connector IN (Blue)

2 x mounting openings (M13)

Neutrik powerCON connector OUT (Gray)

Powerport 3

Product code: 50275

Product Specifications

Model:

Powerport 3

Electrical:

Input voltage

240 V AC, 50 Hz, max. 16 A

Rated current:

16 A (divided over 3 outputs)

Conductors:

Pins:

Connections:

Power connector IN:

Neutrik powerCON connector IN (Blue)

Power connector OUT:

3 x Neutrik powerCON connector OUT (Gray)

Power cable min. wire size:

1,5 mm2/16 AWG

Physical:

Dimensions:

140 x 75 x 55 mm (LxWxH)

Weight:

0,65 kg

Construction:

Housing:

Metal

Color:

Gray

IP rating:

IP20

Thermal:

Ambient temperature ta:

From -10 °C to 45 °C

Dimensions

Fig. 03

Powerport 3

Product code: 50275

4. Setup and Operation

Safety Instructions for Installation

WARNING

Incorrect installation can cause serious injuries and damage of property.

Installation must be carried out only by instructed or skilled persons.

Follow all applicable European, national and local safety regulations concerning electrical installations.

Installation Site Requirements

●The device must be installed only indoors.

●The device can be positioned on a flat surface or be mounted on a structure.

●The maximum ambient temperature ta= 45 °C must never be exceeded.

●The relative humidity must not exceed 50 % with an ambient temperature of 45 °C.

Attention

Power supply

Before connecting the device to the power supply, make sure that the current, voltage and frequency

match the input voltage, current and frequency specified on the information label on the device.

To connect the device:

Insert 2 screws into the 2 x mounting openings (02) and tighten them to mount the device on a

structure. See Fig. 04.

Fig. 04

Connect the power supply to the Neutrik powerCON connector IN (01). See 4.3. Connecting to

Power Supply on page 10 for more information.

Connect external devices to the 3 x Neutrik powerCON connectors OUT (03/04/05). See 4.4. Power

Linking of Multiple Devices on page 10 for more information.

Switch on the external devices.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Unidad de distribución de energía de Showgear

Showgear

Showgear PSA-63A4C Manual de usuario

Showgear

Showgear PSA-125A4C Manual de usuario

Showgear

Showgear PowerBOX 4PG Manual de usuario

Showgear

Showgear PSA-32A12S Manual de usuario

Showgear

Showgear PSA-16A3C Manual de usuario

Showgear

Showgear PSA-32A12M Manual de usuario

Showgear

Showgear PSA-32A6C Manual de usuario

Showgear

Showgear PSA-32A6S Manual de usuario

Showgear

Showgear PSA-16A3S Manual de usuario

Manuales populares de Unidad de distribución de energía de otras marcas

hager

hager SP 015 Manual de usuario

Pakedge

Pakedge PowerPak 9 Manual de usuario

Pts

Pts 9042 Series Manual de usuario

Shure

Shure WA405 Manual de usuario

CORNING

CORNING CCH 4U Manual de usuario

Panamax

Panamax M4LT-EX Manual de usuario

PANCONNECT

PANCONNECT FLAT 3M Manual de usuario

Raytheon

Raytheon 138-118 Manual de usuario

D&R ELECTRONICS

D&R ELECTRONICS PDU-6SS Manual de usuario

Botex

Botex PSA 322-6 DL Manual de usuario

GE QuiXtra 4000 Guía de inicio rápido

RDL

RDL EZ Series Manual de usuario

StarTech.com

StarTech.com RKPW161915 Manual del sistema

Vertiv

Vertiv Knürr DI-Strip Rack PDU Manual de usuario

ABB

ABB PSBS0065 Manual

Baumuller

Baumuller BFN 3-1-0007-001 Manual

Eaton

Eaton StructuredWiringSolutions ESWT41600 Manual

GE GEK-45404F Manual de usuario