ShoreStation DA0075-15 Manual de usuario

Document Number: 0004084

Rev. 3 (2016-6-24)Page 1

S H O R E S T A T I O N L A K E F R O N T S Y S T E M S

Solar ShoreLights

Models: DA0075-15, DA0076-15, DA0077-15,

DA0079-15, and DA0080-15

Introduction

ShoreStation Solar Shore Lights are the fastest and

easiest way to begin enjoying the safety, security and

comfort of waterfront lighting. No costly power supply installation. No

hassles with battery tending. Just sit back, relax and enjoy time with

family and friends.

This unique light is totally powered by the sun eliminating the need for

power on the waterfront. The light installs quickly to your ShoreStation dock

or on shore and provides the equivalent light output of a 40W light bulb.

The LED light source is rated for 50,000 hours of use and attracts fewer

bugs than an incandescent light bulb.

This manual provides installation, operating and care instructions for all mounting

applications on ShoreStation dock and on shore. Please read this manual thoroughly

before installing and operating your light.

Safety Instructions

DO NOT INSTALL OR USE THIS LIGHT BEFORE YOU FIRST STUDY MANUAL AND

UNDERSTAND THE INFORMATION CONTAINED IN IT.

1. Do not assemble the light unless you have read and understand all service

instructions.

2. The system contains a 12V, 9Ah battery that is rated NON-SPILLABLE by DOT

(Department of Transportation), ICAO (International Civil Airline Organization) and IATA

(International Airline Transportation Association) definitions.

3. The battery cannot be serviced. The battery must be replaced when it has reached

the end of its service.

4. When replacing the battery, remove wrist watches and jewelry, which might make

electrical contact with the battery.

5. Keep batteries away from children.

6. Caution: Tipping hazard!

Only use original base or post.

Check all accessory connections to the dock to ensure the post is rigidly

attached to the dock system.

Contents

Introduction

Safety Instructions

Specifications

Preparation

Assembly Instructions

Installation Instructions

Operation Instructions

Optional Light Settings

Care of your Solar Light

Troubleshooting

Midwest Industries, Inc.

122 E State Hwy 175

Ida Grove, IA 51445

(800) 859-3028

www.shorestation.com

Document Number: 0004084

Rev. 3 (2016-6-24)Page 2

S H O R E S T A T I O N L A K E F R O N T S Y S T E M S

Specifications

Light Output

450 lumens

Operating Temperature

-20° F to 140° F

Light Rating

50,000 hours

Battery Regulatory

Approval

D.O.T., I.A.T.A., F.A.A., C.A.B.,

& UL M20845

Battery Style

Sealed Rechargeable

Solar Panel Voltage

12V

Battery Voltage

12V

Solar Panel Power Rating

20W

Battery Capacity

9Amp/Hr

Preparation

Location, location, location…

Many variables will affect the operatingtime of the light. The time of year, location (geographic), and

environment will affect the power available from the sun. Obviously the time of year will cause the length of

time the sun is available to decrease and increase with the season. The further from the equator you are

geographically, the more variation you will experience.This light is designed for use during summer

months in the Northern US states. This system should provide 6 hoursof operation after a sunny, summer

day. Overcast days will provide some charging, but the length of time for light output will be reduced.

Care should be taken when selecting your installation location. Shade is an enemyof solar panels and

should be avoided. Observe your location and select an area that receives as much sunlight as possible

during the day. Also avoid any other large sources of light during evening hours. This may cause the

controller to switch off the

light.

The system is provided with

an on/off switch. This gives

you the option of turning the

system off to save the charge

for early morning use orto

ensure the system is fully

charged for special events or

weekends.

Shade will reduce the

performance of the light

Bad location

Good location

Document Number: 0004084

Rev. 3 (2016-6-24)Page 3

S H O R E S T A T I O N L A K E F R O N T S Y S T E M S

Assembly Instructions

System Components

Document Number: 0004084

Rev. 3 (2016-6-24)Page 4

S H O R E S T A T I O N L A K E F R O N T S Y S T E M S

STEP 1

Remove all packaging and sort all

hardware.

The Light Assembly is preassembled

and ready to operate after the

connection of the battery and solar

panel to the controller. To make the

connections, carefully flip the light

assembly over and loosen the 4

retaining bolts until the retainer clips

can be easily rotated.

Retain clips on top of light assembly

Loosen four bolts until retainer clips

can rotate.

Twist the retainer clips to allow

removal of the panel

Document Number: 0004084

Rev. 3 (2016-6-24)Page 5

S H O R E S T A T I O N L A K E F R O N T S Y S T E M S

Connect the wires Battery are number 1, then hook the Solar panel number 2, and last hookup the

connections marked load.

STEP 2

Carefully lift the solar panel from the

plastic base. This will expose the

interior components of the light.

Connect the harness connection as

shown.

Expose the panel to sunlight and

verify that the green charge

illuminates on the charge controller.

Solar Panel

Document Number: 0004084

Rev. 3 (2016-6-24)Page 6

S H O R E S T A T I O N L A K E F R O N T S Y S T E M S

Retain clips on top of light assembly

STEP 3

Carefully put the solar panel back

onto the plastic base. Be sure no

wires are between the bottom of the

panel and the battery.

Twist the retainer tabs back over the

panel and retighten the retainer bolts.

The light assembly is now ready to

be mounted on the post.

Document Number: 0004084

Rev. 3 (2016-6-24)Page 7

S H O R E S T A T I O N L A K E F R O N T S Y S T E M S

Dock Light Post Assembly Instructions

STEP 1

Remove all packaging and sort all

hardware.

Use the hardware provided to

assemble the MOUNTING

BRACKET to the LIGHT POST as

shown.

NOTE: Freestanding dock

mounting bracket shown.

Skip this step for the Gear Tower

Light (DA0077).

STEP 2

For the DA0077 Gear Tower

accessory and the DA0080 retrofit

light, place the adaptor on the post

supplied with the light (see inset).

This is not required for the other

accessories.

Place COVER PLATE on the top of

the LIGHT POST.

Use a power drill to assemble the

MOUNTING LEGS to the post using

the self-drilling screws

STEP 3

Assemble the LIGHT ASSEMBLY to

the MOUNTING LEGS by aligning

the pre-assembled bolts to the hole

on the top of the legs. Fasten using

the 1/4” nuts provided.

Document Number: 0004084

Rev. 3 (2016-6-24)Page 8

S H O R E S T A T I O N L A K E F R O N T S Y S T E M S

Installation Instructions

Your solar light includes one of the following styles for mounting: Pedestal, Dock Post, FloatingDock Post,

Gear Tower, and Retro-fit. Choose the appropriate instruction for the solar light style you purchased a

separate parts list is available for each.

Freestanding Dock DA0075-15

Align the mounting bracket with the leg frame. Push the bracket under the side of the dock and lift up until

the bracket contacts the side of the dock. Push the bracket over the leg and set it down onto the ‘ears’

attached to the leg frame. Verify that the top and bottom of the bracket are seated on the top and bottom

‘ears’ of the frame.

Verify that

the top and

bottom are

seated.

Document Number: 0004084

Rev. 3 (2016-6-24)Page 9

S H O R E S T A T I O N L A K E F R O N T S Y S T E M S

Floating Dock DA0076-15

Step 1: Align accessory bracket with the

socket.

Step 2: Slip connector into socket and pull

up.

Step 3: Install the bushing, washer, and bolt

as shown.

Step 4: Tighten the bolt to 25 ft.-lbs.

Document Number: 0004084

Rev. 3 (2016-6-24)Page 10

S H O R E S T A T I O N L A K E F R O N T S Y S T E M S

DA0077-15 - Gear Tower

Assembly

Step 1: Remove the plastic cover from your gear

tower. This will expose the pre-cut hole on the

surface.

Step 2: Insert the post into the opening and loosely

assemble the top u-bolt to the post.

Step 3: Adjust the post height until you have about 4”

of post exposed under the tower surface. Tighten the

top u-bolt.

Step 4: Assemble the bottom u-bolt, lock washers,

hex nuts, and caps to the bottom of the post. Refer to

Step 2.

Este manual sirve para los siguientes modelos

Manuales populares de Luz exterior de otras marcas

Sealey

Sealey LED37 Manual de usuario

nordlux

nordlux VEJERS Guía del usuario

SImx

SImx ELITE LED LHTC637 Manual de usuario

GEV

GEV CAROLINE 10833 Manual de usuario

NEBO

NEBO NEB-LSP-0020 Manual de usuario

WE-EF

WE-EF PFL540 LED Manual de usuario

Lindby

Lindby 9949029 Manual de usuario

HEPER

HEPER DOGO Side LW6048.585-US Instrucciones de instalación y funcionamiento

HEPER

HEPER LW8034.003-US Instrucciones de instalación y funcionamiento

Maretti

Maretti VIBE S 14.6080.04.A Manual de usuario

BEGA

BEGA 84 253 Manual

HEPER

HEPER MINIMO Instrucciones de instalación y funcionamiento

LIGMAN

LIGMAN BAMBOO 3 Manual de usuario

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Manual de usuario

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Manual de usuario

urban ambiance

urban ambiance UQL1273 Manual de usuario

TotalPond

TotalPond 52238 Manual de usuario

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Manual de usuario