PRSstandard Assembly Guide Introduction DocID:SBG00520
Introduction
General Safety and Precautions
This safety summary contains general safety warnings that should be understood during operation of
this machine. Refer also to General Power Tool Safety Warnings found in the User Guide. Failure to
observe these precautions could result in injury.
Learn and understand safe use of the machine. Do not allow untrained individuals to
operate the machine without supervision. Be aware of the location of the Emergency
Stop switches at all times.
Eye and ear protection MUST be worn by the machine operator as well as any
bystanders or observers. Flying sawdust, material chips, and other debris can cause
serious eye injury.
Wear closed-toe shoes at all times.
Make sure that your material is properly secured before cutting, and be aware of any
small parts that may come loose after being cut. If a small part catches the edge of a
spinning bit, it can be thrown forcefully in any direction, causing injury or damage.
Never place your hands on the rails of the ShopBot. Be aware that the machine may
move unexpectedly in any direction, which can cause serious injury if your hands are
in the path of movement.
Never wear gloves while operating the machine. As with any power tool, a glove can
get caught in moving or spinning parts and pull your hand into the machinery.
Never leave a machine running and unattended. Understand that a spinning tool
generates friction and heat, creating a risk of fire. This risk is minimized by using correct
chip load, using sharp bits, and by always double-checking your files before cutting. Be
prepared to pause or stop the cut if something seems incorrect or unsafe.
Keep a working fire extinguisher within reach of the machine, for the reasons listed
above.
© Copyright 2021 ShopBot Tools, Inc. 9
