Page of 10
SAVE THESE INSTRUCTIONS
WORK AREA
•Keep work area clean, free of clutter and well lit. Cluttered and dark work areas can cause
accidents.
•Keep children and bystanders away while operating a sandblast cabinet. Distractions can cause
you to lose control, so visitors should remain at a safe distance from the work area.
•Be alert of your surroundings.
PERSONAL SAFETY
•Stay alert, watch what you are doing and use common sense when using a sandblast cabinet. Do
not use a sandblast cabinet while you are tired or under the influence of drugs, alcohol or
medication. Amoment of inattention while operating a sandblast cabinet may result in serious
personal injury.
•Dress properly. Do not wear loose clothing, dangling objects, or jewelry. Keep your hair, clothing
and gloves away from moving parts. Loose clothes, jewelry or long hair can be caught in moving
parts.
•Use safety apparel and equipment. Use safety goggles or safety glasses with side shields which
comply with current national standards, or when needed, a face shield. Use a dust mask if working
in dusty work conditions. This applies to all persons in the work area.Also use non-skid safety
shoes, hardhat, gloves, dust collection systems, and hearing protection when appropriate.
SANDBLAST CABINET USE AND CARE
•Do not modify the sandblast cabinet in any way. Unauthorized modification may impair the
function and/or safety and could affect the life of the equipment. There are specific applications for
which the sandblast cabinet was designed.
•Always check for damaged or worn out parts before using the sandblast cabinet. Broken
parts will affect the sandblast cabinet operation. Replace or repair damaged or worn parts
immediately.
•Replace gloves. Cabinet gloves do wear. Replace as necessary
•Do not exceed the sandblast cabinet load capacity.
•Distribute the load evenly. Uneven loads may cause the sandblast cabinet to tip, resulting in
personal injury to the operator or others.
•Use the sandblast cabinet on flat and level surfaces capable of supporting the sandblast
cabinet and its maximum load. Pulling or pushing a load on a slanted or uneven surface can result
in loss of control.
•Store idle sandblast cabinet. When sandblast cabinet is not in use, store it in a secure place out
of the reach of children. Inspect it for good working condition prior to storage and before re-use.
•Use grounded receptacle only for electrical hookup. Requires 120V volts to operate the light.
•Disconnect incoming air line when adding abrasives or when servicing hoses, power gun or
other components.
•It is recommended to have an air dryer for your compressor being used for the Sand Blaster.
