07-29-10
SHO-ME®
Installation Instructions for the Wall-Mounted
AC & DC Rechargeable Lights
Mount the charger-base in an
upright position (as in illustration)
near a 110-volt receptacle. Plug the
AC charger into the receptacle. Red
light indicates the battery is
charging.
Mount the charger-base in a vehicle
in an upright position (as in
illustration) near the cigarette lighter
or other accessory outlet and plug
the DC charger into the receptacle.
Mount the charger-base in a
vehicle in an upright position (as
in illustration). Connect the Black
wire to ground and the Red wire
to a constant +12-volt positive.
DC ChargerAC Charger Direct-Wire DC Charger
Mount With
This Side
UP
Placing light on charging base
Hold light firmly in hand. Place left side
of the light in the charging base then
rotate light to the right until it latches
into place.
Removing light from charging base
Hold light firmly in hand. Press out on
the locking tab on the charging base
then pull light from charging base or
pull up on light to slide light from
charging base.
PRODUCTS COMPANY 804 East Hwy 248 Cassville, MO 65625
U.S. and Canada Toll Free Numbers Phone: 800-641-4098 FAX: 800-526-1240
CHARGING
FULL CHG
SHO-ME
®
Turning the Night Eye LED lights On &Off
Simply press the on/off button one time. This
will turn the LED lights on in either a steady or
flashing mode. To go to the other mode,
simply turn the light off and turn it on again.
Each time the LED lights are turned on, they
will change modes.
Switch for
Night Eye
LED Lights
Night Eye
LED Lights
For Model No
09.201LEDTL & 09.201LEDTL
