Shivaki SR-160W(CF) Manual de usuario
REFRIGERATOR
INSTRUCTION MANUAL
Before use, please read this manual carefully.
Always remove the drain pan while thile this refrigerator is running.
Removing the drain pan will enhance the cooling power and save your
electric cost.
Model No.: SR-160W(CF)
1
NAMES OF THE PARTS
1. EVAPORATOR:
The heart of the refrigerator.
t evaporates the refrigerant fluid and thereby absorbs heat from the
surrounding, Made of pure aluminum.
2. CONTROL BOX:
Regulates the operation of the motor and controls the inside temperature
of the refrigerator.
3. PLASTIC COATED SHELF has full width and can slide out.
4. AGNETIC DOOR SEAL:
Keeps the refrigerator virtually airtight all along the edge, but is never-
theless easy to open.
5. ICE CUBE TRAY:
ce cubes are easy to remove from the tray.
6. USABLE RACK for cans or jars.
7. BOTTLE RACK for bottles, cans or jars.
8. USABLE RACK for butter, jars or eggs.
2
HOW TO OPERATE
Starting your new Refrigerator
1. Clean the refrigerator thoroughly. Wipe the outside with a soft dry cloth, the
inside with a damp cloth.
2. Keep the door open and insert the power supply cord into the socket.
3. Turn the thermostat dial to “7”. Close the door and let the refrigerator
operate for 15-20 minutes.
The freezer should then show some traces of frost.
Temperature control
You can control the inside temperature
by turning the thermostat dial. Higher
numbers mean greater cooling power,
smaller numbers mean less cooling
power. To make ice cubes in the freezer
compartment, set the dial to “7”. The
dial does not have to be set exactly on
the numbers, but can be any place in
between.
How to defrost
Defrost the refrigerator when the frost accumulated on the evaporator is about
5mm (1/5inch) thick.
Set the thermostat dial to “OFF”. Remove frozen or perishable foods.
Keep drip tray in place. Defrosting usually takes a few hours. To defrost quickly
remove all foods from the refrigerator and leave the door open.
Never use a knife or other metal instrument to remove ice/frost from the
evaporator. After defrosting, empty water from drip tray, return the thermostat
dial to the desired position to start refrigerating again.
NOTE: Wait 3 to 5 minutes before restarting if you unplug the machine.
Unit may fail to operate properly if restarted too quickly.
6
7
5
4
3
2
1
OFF
C
O
L
D
E
R
TEMPERATURE
CONTROL
4
WHAT TO DO...
1. When out of operating for a long time:
Remove the power supply cord.
Dry your refrigerator opening the door for 2-3 days.
2. When you get ready to move:
Securely fasten removable interior parts (or move and package them
separately)
Do not lay your refrigerator horizontally, or compressor may be damaged.
When you need service: Before you call for service make sure you
need it, check a few things noted below for yourself first.
If refrigerator is not operating:
s the power supply cord unplugged?
s home fuse blown or circuit breaker off?
If refrigerator is warmer than usual:
Has the door been open frequently or for a long period?
s refrigerator overcrowded-preventing good air circulation?
s the hot thing stored without cooling?
s the clearance between refrigerator’s side and the wall allowed
sufficiently?
If there are unusual sounds:
s refrigerator placed on the level?
Are foreign objects behind the refrigerator?
Are dishes on refrigerator shelves vibrating?
f so, rearrange the dishes.
3
HOW TO CLEAN
Cleaners: Never use harsh, abrasive cleaners, heavy-duty cleaners, or solvents
on any surface.
Exterior: Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains and
for periodic waxing, use silicon wax.
Evaporator: When refrigerator needs defrosting turn thermostat dial to “OFF”.
Do not use sharp instruments.
Refrigeration Section: Wash shelves and other removable parts in warm sudsy
water, rinse and dry. Wash interior with baking soda solution (3 Table spoons to
one quart of water) or warm sudsy water, rinse and dry.
agnetic Door Seals: Wash with warm sudsy water.
The Finishing Touch: Replace all parts and return thermostat dial to desired
setting.
HOW TO INSTALL
nstall refrigerator in a convenient location away from extreme heat and cold.
Allow sufficient clearance between the refrigerator and side wall so the door
will open for a fully usable interior. Refrigerator is not designed for recessed
installation.
Select a place with strong level floor.
Allow 10 cm of place between the
refrigerator’s side and the wall.
The electrical plug must be accessible
without moving the set.
10 cm
f the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a simmilary qualified person in order to avoid a hazard.
5
Otros manuales de Refrigerador de Shivaki
