Peripheral interface and properties
Brief introduction
Cable test include Cable diagnosis, Speeds test and Impendence test. Speed test and impendence test
need to be cooperated with RT-80 adaptor or with another NCT-500 tester.
Test can be done by auto or individually, and test results can be saved.
Network test include Port, PoE test, Switch and Internet test. Test also can be done by auto or individually,
and test results can be saved.
Cable test
Cable diagnosis can indicate open,short,online,fail and length of cable information.
Speed test can test cable communication load capacity under 1000M，100M，10M model with 64 byte and
1518 byte double test.
Impendence test can get cable signal loss rate and cable impendence value.
Wiremap
The test will show cable Wiremap graphically.
Switch discovery
The tester can discovery and indicate equipment info and neighbor info through LLDP(LEEE) CDP
（Cisco）(such as device name, software version, VLAN info, Ports info etc)
PoE port voltage level and of power and Ethernet power supply pairs can be tested to determine the
（PoE 和PoE+）problems.
Flash ports can flash the network device ports to find the corresponding ports or device.
Network communication test
Graphically display network communication delay though persistent ICMP protocol Ping test.
Identify DHCP client availability.
Connect pre-set URL page to check up DNS and HTTP malfunction.
Data reflector
Tester can be set to data reflector to cooperate with another NCT-500 device for cable test
Audio generator
NCT-500 can generate digital audio signal to work with CT-100 audio tracker (optional accessories) to
find the target cable.
Cable ID
To identify the cable ID to cooperate with ID-10 adaptors (optional accessories)
USB storage
NCT-500 can be a storage device by connecting computer for test report reading and removable storage.
