Table of Contents
Introduction ........................................................................ 1
DRIFTER Basics .................................................................. 1
DRIFTER Display ................................................................. 2
Operation .............................................................................. 2
Back-light ........................................................................... 2
Battery on / offSwitch ...................................................... 3
Clock set up ....................................................................... 3
Set up .................................................................................. 4
New Battery - Learning the Capacity ................................. 5
Connectors .......................................................................... 5
Glossary .............................................................................. 6
Servicing ............................................................................. 7
Copyright © Setec Pty Ltd 201 2
Disclaimer
Setec Pty Ltd makes every effort to ensure the accuracy and suitability of the information in
this manual, however makes no claim that this information is suitable or relevant for
particular individual situations.
ONE YEAR LIMITED WARRANTY
Setec Pty Ltd: Drifter BATTERY MONITOR
IMPORTANT:
Evidence of original purchase is required.
WARRANTOR:
Setec Pty Ltd
Warranty only available in original country of purchase.
ELEMENT OF WARRANTY
Warranty is only valid if the unit has not been modified by the customer and has not been misused.
Setec Pty Ltd warrants to the original retail owner for the duration of this warranty, its DRIFTER Battery Monitor
(herein referred to as the product), to be free from defects in materials and craftsmanship with only the limitations or
exclusions set out below.
Warranty duration:
This warranty to the original retail owner only, shall terminate and be of no further effect ONE (1 ) year after the date of
original retail sale.
This warranty will be deemed invalid if the Product;
(A) Damaged or not maintained as reasonable and necessary,
(B) Modified, altered or used as part of any conversion kits, subassemblies, or any configurations not sold by setec.
(C) Improperly installed
(D) Repaired by someone other than an authorised Setec Pty Ltd repair agent for a detect or malfunction covered by
this warranty
(E) Used in conjunction with any equipment or parts or as part of a system not manufactured by Setec Pty Ltd.
(F) Where the serial number label or warranty void sticker of the product has been removed or damaged beyond
recognition.
Warranty only valid in the country of original retail sale.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a
replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure
does not amount to a major failure.
STATEMENT OF REMEDY
:
If in the event that the product does not conform to this warranty at any time while this warranty is in effect, the
warrantor at its discretion, will repair the defect or replace the product and return it to you without charge for parts or
service. This warranty does not provide for the reimbursement or payment of incidental or consequential damages.
PROCEDURE FOR OBTAINING WARRANTY:
In the event that the product does not conform to this warranty, the Product should be shipped or delivered, freight
pre-paid, to an authorised ayco dealer (with evidence of original purchase, eg a copy of the sales docket, point of
purchase), who will repair or replacement of unit.
Or
Contact ayco Head Office Service Centre on: 03 8792 21 36
