Peel the liner from the appropriate side of the VHB tape to
align the Die Cut Holes with the Threaded Holes of the
mounting plate.
Firmly and evenly press the adhesive onto the plate.
Connect the Speaker Cable to the feed
connection of the main cable and then
to speakers.
Note: if only one speaker is
required it can be connected
directly to the feed connector of
the main cable
Reinstall the Windscreen and
carefully tuck all excess cable
into the helmet.
Reinstall all liners and cheek
pads into the helmet.
The 25-1184 cable will exit from
the front of the left cheek pad
Carefully Peel the secondary liner from the VHB tape
USING A CLEAN & LINT FREE WIPE, CLEAN THE TWO SURFACES TO BE BONDED USING
50:50 ISOPROPYL ALCOHOL (IPA) AND ALLOW TO AIR DRY.
and place the assembly in the predetermined position
ONCE THE ADHESIVE IS PLACED APPLY PRESSURE VIA A
SPRING CLAMP OR WEIGHT TO AID BOND STRENGTH.
Dry fit the assembly to the
interior of the helmet to
determine proper placement
for mic element
Note that the “TALK” side of the mic needs to
be directly in front of the mouth with a distance
from the lips of 1/4 inch
Setcom Technical Support
1-650-965-8020 x703
http://setcomcorp.com/cr/helmetkits.php
http://setcomcorp.com
More information on Helmet Kits can be found at:
24 HOURS WILL YIELD 90% OF THE TOTAL BOND STRENGTH AND
72 HOURS FOR FULL BOND POTENTIAL.
Ambient 78°F - 25°C
and mate undisturbed
DWG #19-6003 REV BPage 4 of 4
