DIRETTIVA MACCHINE
The installer who motorised a door becomes the automatic door machine manufacturer according
to directive 2006/42/CE and must:
–Arrange the Technical Booklet with the documents indicated in attachment VII of the
Machine Directive and keep them for at least 10 years.
–Draft the CE declaration of conformity according to attachment II-A of the machine
directive and provide the use with a copy.
–Apply the CE markings on the motorized door according to point 1.7.3 of attachment I
of the machine directive.
–In particular, but not exclusively, if for the purpose of the standard EN 16005 it is
necessary to install monitored sensors, the wiring has to carry out as described in
this manual (see pages 13/14/15/19) and the correct sensors operation has to be
checked following instruction manual of the sensors themselves.
For more information and for assist installers in applying the specifications of the directives and of
European standards concerning the safe use of motorized gates/doors consult the guidelines
available on internet at the address www.sesamo.eu
DECLARATION OF INCORPORATION
(Directive 2006/42/CE, Annex II, part B)
Manufacturer: SESAMO S.R.L.
Address: Str. Gabannone 8/10 - 15030 Terruggia –AL -ITALY
Declares that the product: PROSWING R
- is made to be incorporated in a machine to construct a machine considered by Directive 2006/42/CE
- conforms with the essential safety requirements indicated in appendix I of the directive with the
exception of the following points: 1.2.4.3, 1.2.4.4, 1.3.4, 1.3.5, 1.3.7, 1.3.8.2, 1.4, 1.5.3, 1.5.7, 1.5.14,
1.5.15, 1.5.16
- complies with the conditions of the following other CE Directives: 2014/30/UE Electromagnetic
Compatibility, 2014/35/UE Low Voltage
and that
- the following (parts/clauses of) agreed regulations have been applied:
EN 60335-1 EN 61000-6-2 EN 50366 EN 61000 -6–3EN16005
and also declares that:
- the relevant technical documentation has been completed in accordance with part B of appendix VII;
this documentation, or parts of it, will be delivered electronically or by traditional post upon justified
request from the competent national authorities
- the relative technical documentation will be compiled by: SESAMO SRL, Strada Gabannone, 8/10 - 15030
Terruggia (AL) - Italy
- it is not permitted to use the product until the machine in which it will be incorporated or will become a
component of has been identified and has received the declaration of conformity with the conditions of
Directive 2006/42/CE and the national legislation that transposes it, in other words, until the machinery
referred to in this declaration forms a single unit with the machine.
SESAMO S.R.L. Aldo Amerio
Maggio 2016 (Amministratore)
