ServersCheck Infrasensing EST-IRSPOT Series Manual de usuario

Infrared IR Spot Sensor Guide

for elevated skin temperature screening

2 EST-IRSPOT Manual- Revision 12 –June 6, 2020

Reproduction without permission is prohibited.

Software:

The software described in this manual is furnished under a license agreement and may

be used only in accordance with the terms of that agreement.

Trademarks:

ServersCheck and InfraSensing are registered trademarks of ServersCheck BVBA. All

other trademarks or registered marks in this manual belong to their respective

manufacturers.

Disclaimer:

Information in this document is subject to change without notice and does not

represent a commitment on the part of ServersCheck.

ServersCheck provides this document “as is,” without warranty of any kind, either

expressed or implied, including, but not limited to, its particular purpose. ServersCheck

reserves the right to make improvements and/or changes to this manual, or to the

products and/or the programs described in this manual, at any time.

ServersCheck has made this document to the best of its abilities. However ServersCheck

assumes no responsibility for its use, or for any infringements on the rights of third

parties that may result from its use.

This product might include unintentional technical or typographical errors. Changes are

periodically made to the information herein to correct such errors, and these changes

are

incorporated into new editions of the publication.

Warranty:

For the warranty on this product please visit https://infrasensing.com/

OPENING SENSORGATEWAY, ADDON, EXPANSION HUB, SENSOR OR ANY OTHER

HARDWARE VOIDS THE WARRANTY

3 EST-IRSPOT Manual- Revision 12 –June 6, 2020

Safety Precautions

CAUTION

For safety reasons, the SensorGateways (base units), PCs, add-ons, expansion

hubs and sensor probes may never be moved, disconnected, connected fully

or partially covered while operating. Disconnect any power supply before

performing installation or maintenance work.

DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH FOR POWER

SENSORS OR SENSORS IN ELECTRICAL ENVIRONMENTS

• Apply appropriate personal protective equipment (PPE) and follow safe electrical

work practices. In the USA, see NFPA 70E.

• Only qualified electrical workers should install electrical equipment like our power

sensors. Such work should be performed only after reading this entire set of

instructions.

• NEVER install if something is not clear.

• NEVER work alone.

• Before performing visual inspections, tests, or maintenance on this equipment,

disconnect all sources of electric power. Assume that all circuits are live until they

have been completely de-energized, tested, and tagged.

• Turn off all power supplying the power sensors and the equipment (such as base

units) in

which it is installed before working on it.

• Always use a properly rated voltage sensing device to confirm that all power is off.

• The successful operation of this equipment depends upon proper handling,

installation, and operation. Neglecting fundamental installation requirements may

lead to personal injury as well as damage to electrical equipment or other property.

• NEVER bypass external fusing.

• Before performing testing on any equipment in which the power sensors are

installed, disconnect all input and output wires to the power meter. High voltage

testing may damage electronic components contained in the electronics.

• The power sensors should be installed in a suitable electrical enclosure.

4 EST-IRSPOT Manual- Revision 12 –June 6, 2020

Failure to follow the above instructions may result in damage of the equipment, serious

personal injury or death.

5 EST-IRSPOT Manual- Revision 12 –June 6, 2020

ELEVATED SKIN TEMPERATURE KITS DISCLAIMER

The IR spot sensors are not medical grade devices. The

sensors are not designed for the specific intention of

human fever detection nor the diagnosis, mitigation or

prevention of disease or health conditions. A person may

be carrying or transmitting diseases without having an

elevated skin temperature.

Where the use of our products is permitted, they should

always be complemented with medical grade devices for

confirmation and additional screening. Operation of the

sensors should always be supervised by a medical

professional.

The device should be operated indoors within a 20-25C

temperature environment for its 0.5C accuracy. Different

temperatures may affect the accuracy of the device.

Allow 5 minutes for the device to warm up before

performing any measurements.

In the USA the use of our sensors should also follow the

Enforcement Policy for Telethermographic Systems

During the Coronavirus Disease 2019 (COVID-19) Public

Health Emergency from the FDA.

6 EST-IRSPOT Manual- Revision 12 –June 6, 2020

EST-IRSPOT Manual- Revision 12 –June 6, 2020 
 
Overview ............................................................................................................................................................8 
Best Practices..................................................................................................................................................10 
1. Elevated skin temperature versus body core temperature. ...........................................................10 
2. Temperature accuracy, operation and maintenance .......................................................................11 
3. Sensor Leds...................................................................................................................................................13 
EST Covid-19 Kit - Temperature IR Spot Sensor..................................................................................14 
1. What’s in the kit ..........................................................................................................................................15 
2. Optional Expansion and add-ons...................................................................................................17 
2.1. Adjustable Tripod with mount adapter for the IR spot sensor....................................17 
2.2. 21" Touch Monitor ....................................................................................................................17 
2.3. Expansions for EST Kits (not KIT-IRSPOT or KIT-IRSPOT2)............................................18 
How it works...................................................................................................................................................19 
Set up instructions........................................................................................................................................21 
1. How to set and power up the monitoring appliance.......................................................................22 
2. Connecting the Appliance to a wired network...........................................................................24 
3. Connecting the Appliance to your Wifi network .......................................................................24 
4. Software Upgrade ...............................................................................................................................26 
5. How to power up the SensorGateway (BASE-WIRED)..............................................................27 
6. Connecting the SensorGateway directly to the Appliance .....................................................28 
7. Connecting the SensorGateway and appliance within your current network...................34 
8. Firmware Upgrade for the Gateway...............................................................................................37 
9. Connecting the Sensors into your Gateway ................................................................................38 
10. Adding the Sensor data into your Monitoring Appliance..................................................40 
11. Updating your Covid Settings.....................................................................................................48 
Setup of optional items...............................................................................................................................50 
1. Installing the sensor on the Optional Tripod .....................................................................................50 
2. Wall mount the sensors ............................................................................................................................52 
3. Connecting your appliance to a wireless display. .............................................................................53 
4. Connecting to the software using your smart phone or tablet....................................................57 
5. Privacy mode.........................................................................................................................................61 
Support resources.........................................................................................................................................64 
1. Free technical support........................................................................................................................64 
2. Sensor platform manual....................................................................................................................64 

8 EST-IRSPOT Manual- Revision 12 –June 6, 2020

7.3. Monitoring Appliance & Software manual..................................................................................64

1. Overview

A simple cost effective solutions to limit the spread of the on-going pandemic.

Countries like Taiwan and Singapore have shown that it is possible to reduce the

spreading of the SARS-CoV-2 or Novel Corona virus by implementing strong protective

measures while trying to keep the economy going.

One of those measures is the continuous screening of people's temperature in offices

and other public places. This is critical to keep businesses open as long as possible.

By modifying our hardware, we have developed an emergency solution enabling to

monitor skin temperature.

9 EST-IRSPOT Manual- Revision 12 –June 6, 2020

10 EST-IRSPOT Manual- Revision 12 –June 6, 2020

2. Best Practices

2.1. Elevated skin temperature versus body core temperature.

An infrared sensor does not monitor the core body temperature but the radiated

temperature of the skin. It is important to understand that the skin temperature is not

the same as the core body temperature. The known fever temperature of 37.5°C or

100.4°F is the core body temperature. Skin temperature is significantly lower.

Studies following the SARS and N1H1 outbreaks were conducted in respect to IR

temperature scanning of people to detect potential cases of fever. We recommend the

user of the system to read the sources below.

If the event of a potential elevated skin temperature being recorded, it is important that

this should always be confirmed using a secondary screening with a medical grade

device.

Sources:

Detection of body temperature with infrared thermography: accuracy in detection of

fever

(https://www.researchgate.net/publication/232712926_Detection_of_body_temperature_wi

th_infrared_thermography_accuracy_in_detection_of_fever)

Utility of infrared thermography for screening febrile subjects

(http://www.hkmj.org/article_pdfs/hkm1304p109.pdf)

Fever Screening and Detection of Febrile Arrivals at an International Airport in Korea:

Association among

Self-reported Fever, Infrared Thermal Camera Scanning, and Tympanic Temperature

(https://www.e-epih.org/journal/view.php?doi=10.4178/epih/e2014004)

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Accesorios de ServersCheck

ServersCheck

ServersCheck Wireless Sensor Manual de usuario

Manuales populares de Accesorios de otras marcas

Hillco

Hillco 2810 Manual de usuario

Siemens

Siemens QSA2700D Manual del operador

Contours

Contours ZY024 Manual de usuario

Saivod

Saivod VS621 Manual de usuario

Virtuox

Virtuox VirtuCLEAN 2.0 Manual de usuario

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manual de usuario

Z-Wave

Z-Wave HSD-200Z Manual de usuario

turck

turck FMX-IM-2UPLI63FX Manual de usuario

Decagon Devices

Decagon Devices 10HS Manual de usuario

UPPAbaby

UPPAbaby Cup Holder Manual de usuario

Elko

Elko SmartSensor Leakage Wireless Manual de usuario

Grizzly

Grizzly H8371 Manual de usuario

Panasonic

Panasonic HG-T Series Manual de usuario

IFM Electronic

IFM Electronic Efector 250 Series Guía de referencia

DigiDesign

DigiDesign 888/24 I/O Manual de usuario

PROZIS

PROZIS QUAY Manual de usuario

patagonia

patagonia PSI Vest Manual de usuario

SFC Energy

SFC Energy EFOY GO! Manual de usuario