I. Security and prevention
1.Notice
1.1 In order to use this product better and safer, please read this instruction carefully before install
and operate it. Please pay attention to all the notice in operation and maintenance. Save all manuals
and documentation for future reference.
1.2 Swimming pool heat pump is a special appliance. Improper installation will cause damage and
danger. It should be installed and maintained by the professionals. Please contact our authorized local
service point for installation and maintenance. Please read and follow this instruction carefully before
and during installation.
Remarks:
We will not bear the responsibility for any personal injury or unit damage caused by non-Compliance
of the regulations and instruction in this manual.
1.3 Please check whether the distribution power capacity, switch and socket are compliance with the
requirements of our unit power. Details please refer to the rating label or parameter table in this
manual.
1.4 The power should be equipped with leakage protection separately. Power cable should be chosen
in accordance with the operation requirements of the unit.
1.5 The unit must be grounded safely. Do not use the unit if grounded unsafely. Do not connect the
ground line to the neutral and or tap water pipe.
1.6 The wire must be joined in compliance with the requirements of the wiring chart. Do not alternate
and or repair the unit personally.
1.7 Do not install the unit closed to inflammable, explosive and naked light spot.
1.8 To ensure the unit operate properly, please equipped with a filter in the water input when
installation.
1.9 Please contact us or our authorized service site if the unit failures. The unit can’t be used again
without technicians’ checking.
1.10 The unit parameter has been set before leave of the factory. The parameter Can’t be adjusted
by the unprofessional.
1. Scroll Compressor
II. Advantage
2.Warning!
2.1 Do not carry devices alone.
2.2 Connect all the ground wires.
2.3 All the electrical connections should be made by a certified electrician .
2.4 When manipulating electrical equipment, make sure there is no voltage using a well calibrated
voltmeter . To avoid damaging the equipment the equipment, do not use heating or cooling devices
during the construction phase. Why? Because components can become obstructed with dirt and
debris which man damage the device.
50% fewer moving parts than standard piston-type compressors. This equates to much
improved reliability and improved efficiency. Scroll compressors are also much quieter in
operation than their piston-type counterparts. And, while all heat pumps are known for the
ir low operating noise levels.
1
