Security Brands Ascent 16-ANTOMNI Manual de usuario
1 of 2
INSTALL GUIDE|4G LTE OMNI ANTENNA EXTENSION KIT / 16-ANTOMNI
Make sure you have all items shown below.
(1-5/8" antenna pole not included)
1
Overlap mounting brackets to prepare
for U-bolt installation.
5Feed U-bolts through slots on
overlapping mounting brackets.
6
Gather existing antenna cables and tuck into the enclosure
out of the way.
Disconnect existing antenna cables
from jacks on Ascent unit circuit board.
2Attach first antenna to first mounting
bracket using carriage bolts and hex nuts.
3
Attach second antenna to second mounting
bracket using carriage bolts and hex nuts.
4
Omni Antenna (2x)
U-Bolt (2x)
Mounting Bracket (2x)
Carriage Bolt (4x)
Hex Nut (4x)
TEK Screw (8x)
Lag Screw (8x)
25' Antenna Cable (2x)
Install in order shown. Leave plenty of room so that assembly
will slide easily onto 1-5/8" antenna pole (not included).
Fish 25' antenna cables from antenna
pole location through back of Ascent unit.
8
Install fasteners on U-Bolts to prepare for
installation on antenna pole.
7Attach antenna assembly to antenna pole
and connect 25' antenna cables.
9
Connect 25' antenna cables to jacks on
Ascent unit circuit board in any order.
10
2 of 2
© 2018 Security Brands, Inc. All rights reserved. IG-16ANTOMNI-EN Rev. A (9/2018)
INSTALLATION COMPLETE!
NCall (844) 259-8265
Email [email protected]
We are available Mon–Fri / 8am–5pm Central
INSTALL GUIDE|4G LTE OMNI ANTENNA EXTENSION KIT / 16-ANTOMNI
TEK screws and lag screws are included for ease in
alternate mounting methods.
Consult Summit Control for best practices.
Otros manuales de Antena de Security Brands
Manuales populares de Antena de otras marcas
Alfa Network
Alfa Network APA-L01 Manual de usuario
Naval
Naval PR-422CA Manual de usuario
Feig Electronic
Feig Electronic ID ISC.ANTH200/200 Series Manual de usuario
TERK Technologies
TERK Technologies TV44 Manual de usuario
Directive Systems & Engineering
Directive Systems & Engineering DSE2324LYRMK Manual de usuario
HP
HP J8999A Manual de usuario
