Changing the operating mode
from „Standard“ to „Backup“
The lock is of fully redundant design. This means that all electrical components vital to the proper functioning of the lock come in pairs and
form a complete second or backup operating system. As the systems are of equal standard, each has to be made operational by the same
procedure. The instructions on the following pages, therefore, have to be completed twice, once for the standard system and onceforthe
backup system. After energizing the lock, it automatically starts up in the standard mode. All entries made immediately following switching
on the lock, e.g. for opening or setting of the lock, always apply to the standard system.
The backup system is reserved for an emergency, i.e. when the lock refuses to open due to a fault in the standard system. Entries made in the
backup system are completely independent of the standard system. When, after energizing the lock, the operation mode is switched over
from the standard to the backup system, all following entries made to open or set the lock, up to and including the automatic deactivation
of the lock, automatically apply to the backup system only. The next time the lock is switched on, it will automatically start up in the standard
mode again.
Change-over: Standard system ÆBackup system:
Press On/Enter key. Next, press Function key.
- Using the t/ukeys (keys 1 and 2) go to:
Menu Mode select
Select by pressing the On/Enter key.
- Using the t/ukeys, go to:
Select: Backup mode
Confirm by pressing the On/Enter key.
Next, continue tipping on the Function key until you return to the point where you are requested to enter a code, and start making the
necessary entries, e.g. for entering of a code or programming the lock, for the back-up system.
From this point on until the locked is automatically switched of, or until the operating mode is manually changed over to the standard
system by way of the menu item „Mode select“, all subsequent entries will be valid for the back-up system only.
Please note!
When the lock is set for the first time, make sure the factory-set administrator code 1 2 3 4 5 6 7 of the back-up system is also replaced with a
valid secret code! Failing this, the lock can be opened by anybody knowing the factory setting whenever it is in backup mode. Until the
system administrator has changed the factory-set administrator code for the backup system, i.e. 1 2 3 4 5 6 7 to the secret code of his choice,
the lock will send out the warning Backup code still factory setting! each time it is switched on.
Menu
Mode select…
<
Select:
Backup mode
<
3
