SECO-LARM SD-995A-D3Q Manual de usuario

SD-995A-D3Q

Weatherproof Door/Gate Strike

Manual

 Unique design accommodates both wood and

metal doors

 Fail-secure operation

 Reversible for right or left-handed doors

 Zinc alloy body

 Corrosion-resistant case and moving parts

 Complete mounting hardware included

 Operating voltage: 12~24 VAC/VDC

 1,034-lb (470kg) Holding force

 Tested to 250,000 cycles

 Current draw: 500mA@12VDC,

1A@24VDC

 Strike depth: 9/16" (15mm)

 Faceplate size: 31/2"x17/16"x1/8"

(89x35x3 mm)

Features:

SECO-LARM® Weatherproof Door/Gate Strike

2 SECO-LARM® U.S.A., Inc.

Specifications:

Model

995A

Operation

Fail

secure

Operating voltage 12~24 VAC/VDC

Current draw 500mA@12VDC, 1A@24VDC

Design Reversible non-handed

Max. latch throw 9/16" (15mm)

Keeper width 15/8" (41mm)

Strike depth 9/16" (15mm)

Holding force 1,034-lb (470kg)

IP Rating IP42

Operating temperature 14°~113° F (-10°~45° C)

Operating humidity 0~95% RH (no condensation)

Faceplate dimensions 31/2"x17/16"x1/8" (89x35x3 mm)

Weight 12.1-oz (343g)

Parts List:

1x Door strike 1x Mounting template 2x Mounting tabs 2x Wood screws

4x Machine screws

2x Crimp connectors

1x Manual

Sides Top

31/2"

(89mm)

(35mm

)

(17.5mm

)

(76mm)

(15.35mm

)

25/8" (67mm

)

(41mm

)

(27.5mm

)

(17mm

)

(47mm

)

Dimensions:

SECO-LARM® Weatherproof Door/Gate Strike

SECO-LARM® U.S.A., Inc. 3

1. Measure the latch line (see fig. 1).

a. Measure the distance between the face of

the door jamb and the face of the door latch.

This is the vertical latch distance.

b. Measure the vertical latch distance on the

door jamb from the face of the door jamb. At

that point, draw a vertical line. This is the

latch line.

2. Measure the center line (see fig. 2).

a. Measure the distance from the floor to the

center of the door latch. Ignore the location

of the deadlatch pin when taking

measurements.

b. Measure the same distance as above along

the inside of the door jamb. This is the

center line.

3. Align the included mounting template to the latch

and center lines (see fig. 3)

4. Using the template as a guide, cut into the door

jamb to a depth of 3/4” (19mm).

NOTE: If cutting into a wooden door, use a chisel

to knock out a 1/8” (3mm) deep cut as shown on

the template.

5. Using two of the included machine screws, affix

the mounting tabs to the inside of the door jamb

(see fig. 4).

6. Connect the two wires from the access control or

egress device, e.g. keypad, push-button switch,

push-bar, etc. to the door strike wires.

Polarity is not important.

7. Conceal all wires in the door frame. Use two of

the included machine screws to mount the unit to

the mounting tabs. Adjust as needed to ensure

the door closes smoothly (see fig. 5).

NOTE: Intermittent duty use > 20 seconds per

cycle.

Installation:

Fig.4

Fig.3

Fig.2

Fig.1

Door

latch

Door

jamb

Deadlatch pin

Vertical latch distance

atch line

Fig.5

SECO-LARM® Weatherproof Door/Gate Strike

4 SECO-LARM® U.S.A., Inc.

Electric strike does not

activate

 Remove the strike and check that the wires are

connected properly

 Use a multimeter to test that the strike is receiving

the proper voltage and amperage.

If it is not, it may be necessary to use heavier gauge

wires, or increase the output of the power supply

 Make sure the activation device (keypad or

pushbutton switch) is working properly

Door does not open when the

electric strike is activated

 Check that the door latch is operating properly, and

replace if necessary

 The position of the electric strike may need to be

adjusted by moving it or adding washers or shims

Troubleshooting:

Also Available:

Fail-Secure Electric Door Strike

SD-990AQ

Fail-Safe Electric Door Strike

SD-990BQ

Indoor Access Control Keypad

SK-1011-SDQ

Electric Door Strike for Metal Doors

SD-995C

Electric Door Strike for Wood Doors

SD-994C

Universal Door Strike

SD-996C-NUQ

WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while

used in normal

service for three (3) year from the date of sale to the original customer. SECO-

LARM’s obligation is limited to the repair or

replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is

void if

damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,

improper or abnormal usage, or faulty installation, or if for any other reason SECO-

LARM determines that such equipment

is not operating properly as a result of causes other than defects in material and workmanship.

The sole obligation of

SECO-LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM

’s

option. In no event shall SECO-

LARM be liable for any special, collateral, incidental, or consequential personal or property

damage of any kind to the purchaser or anyone else.

NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM

reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints.

All trademarks

S.A., Inc. All

rights reserved.

SECO-LARM® U.S.A., Inc.

16842 Millikan Avenue, Irvine, CA 92606

Website: www.seco

larm.com

PITGW1

Phone: (949) 261

2999 | (800) 662

0800

Email: sales@seco

larm.com

MI_SD-995A-D3Q_170501.docx

Otros manuales de Cerrar de SECO-LARM

SECO-LARM

SECO-LARM SD-991A-D1Q Manual de usuario

SECO-LARM

SECO-LARM E-941S-600DPSQ Series Manual de usuario

SECO-LARM

SECO-LARM E-941SA-1K2PD Manual de usuario

SECO-LARM

SECO-LARM E-941DA-600Q Manual de usuario

SECO-LARM

SECO-LARM E-941S 600 Series Manual de usuario

SECO-LARM

SECO-LARM SLI ENFORCER 1200-lb Electromagnetic Lock... Manual de usuario

SECO-LARM

SECO-LARM SD-995C-D3Q Manual de usuario

SECO-LARM

SECO-LARM Enforcer E-941SA-80Q Manual de usuario

SECO-LARM

SECO-LARM E-942FC-600AR Manual de usuario

SECO-LARM

SECO-LARM SD-996C-NUVQ Manual de usuario

SECO-LARM

SECO-LARM SLI E-941SA-600 Manual de usuario

SECO-LARM

SECO-LARM Enforcer E-941DA-1K2P Manual de usuario

SECO-LARM

SECO-LARM SLI E-942FC-1K3SQ Manual de usuario

SECO-LARM

SECO-LARM SD-962H-8LAQ Manual de usuario

SECO-LARM

SECO-LARM SD-997B-1SQ Manual de usuario

SECO-LARM

SECO-LARM SD-994C Manual de usuario

SECO-LARM

SECO-LARM ENFORCER 600-lb Electromagnetic Lock Series Manual de usuario

SECO-LARM

SECO-LARM E-941S 600DPSQ Series Manual de usuario

SECO-LARM

SECO-LARM SD-997A-DQ Manual de usuario

SECO-LARM

SECO-LARM E-941SA-80Q Manual de usuario

SECO-LARM

SECO-LARM SD-997C-GCQ Manual de usuario

SECO-LARM

SECO-LARM Enforcer E-941SA-300 Manual de usuario

SECO-LARM

SECO-LARM SD-993B-SS Manual de usuario

SECO-LARM

SECO-LARM E-941SA-600 Manual de usuario

Manuales populares de Cerrar de otras marcas

Magic

Magic 105 Manual de usuario

Gantner

Gantner GAT NET.Lock 7020 System Guía rápida

Wittkopp

Wittkopp Insys 7202 Manual de usuario

Dorma

Dorma Studio Classic Manual de usuario

Securam

Securam ECSL-601 Manual de usuario

Sudhaus

Sudhaus 3003 Manual de usuario

Safety 1st

Safety 1st 48517 Manual de usuario

Pado

Pado FDS-10 Manual de usuario

Esco

Esco systeQ Series Manual de usuario

COMPX

COMPX National D8951 Manual de usuario

secureo

secureo Key Box Manual de usuario

Stock Loks

Stock Loks C8713 Manual de usuario

COMPX

COMPX 1T-058 Manual del propietario

Auslock

Auslock T11 Manual de usuario

ELCOM

ELCOM 7205 Manual de usuario

Stealth SAFES

Stealth SAFES ShadowVault Manual de usuario

Knox

Knox KeySecure 5 Manual de usuario

Kwikset

Kwikset 48334/01 Manual de usuario