Safety Precautions
E-5
zAvoid strong shocks/impacts or excess stress to prevent malfunction, damage or
breakdown. Make sure that the product has been securely mounted to other
products in order to prevent injury, fall or missing.
zDo not carry the camera or housing by holding the accessories such as arm, cable,
strobe, etc. Heavy components may fall and cause damage or injury.
zDo not rest heavy weight on the product. It might deform the outer casing, damage
internal parts, make the waterproofing fail, or result in fire or electric shock.
zRinse the product with fresh water, after underwater use. Ensure that the product is
waterproofed before rinsing. Refer to [Maintenance and Storage] for details.
zMake sure that the connectors have been secured with the connector caps before
rinsing the product with fresh water, after removal from other products.
zNever use chemicals, cosmetics, any petroleum solvents such as paint thinner, or
neutral detergent on the product. They may deform and damage the product.
zDo not leave the product in places with hot temperatures such as inside of a car or
in a car trunk in summer. The heat may deform plastic parts of the product,
damaging internal parts and resulting in potential fire or electric shock. If the product
is sealed tight in hot conditions, heated air expanding inside the product may deform
the casing and ruin the waterproofing.
zDo not store the product in wet or high humidity place, to avoid mold, rust, corrosion
or malfunction.
zDo not store the product with naphthalene or camphor mothballs, or in locations
such as a laboratory where chemicals are used. This environment can cause mold,
rust, corrosion or malfunction.
zIf you do not use the product for an extended period of time, periodic maintenance
will keep internal electronic parts from deterioration. Once a month, install batteries
and fire a test flash/light on. Operate all other switches as you would in normal
operation. Turn the power off, then remove batteries while the TTL lamp (red) is on
for the strobe.
zSEA&SEA SUNPAK Co., Ltd. assumes no liability for compensation of loss of
captured images or expenses caused by loss of images, even if you are unable to
shoot due to a product defect or malfunction.
zSEA&SEA SUNPAK Co., Ltd. will not be responsible for the replacement or
compensation for cameras, lenses or those accessories damaged due to your
invalid operation.
zCarefully observe the O-ring maintenance manual for the handling of O-rings before
use.
zSEA&SEA SUNPAK Co., Ltd. assumes no liability for errors or discrepancies in this
manual.
zSpecifications and appearance are subject to change without notice.
ys_110a_e_7.fm Page 5 Tuesday, July 15, 2008 11:29 AM
