Scientific 5000 Series Manual de usuario

MODEL 5000 SERIES TEST SYSTEMS

Manual

Scientific Test, Inc.

1110 E. Collins Blvd., #130

Richardson, Texas 75081

www.scitest.com

Email: [email protected]

Voice: 972●479●1300

FAX: 972●479●1301

Version 1.23

March 25, 2008

LIMITED WARRANTY

SCIENTIFIC TEST, INC. (STI) WILL REPAIR (OR AT ITS OPTION, REPLACE) THE

SERIES 5000 TESTER (PRODUCT) FREE OF CHARGE FOR PARTS AND LABOR FOR

A PERIOD ONE (1) YEAR FROM THE DATE OF PURCHASE IF STI FINDS IT TO BE

DEFECTIVE IN MATERIAL OR WORKMANSHIP, PROVIDED THE PRODUCT IS

RETURNED (SHIPPING PREPAID AND PROPERLY PACKED) TO STI. THIS

WARRANTY DOES NOT APPLY IF, IN THE OPINION OF STI, THE PRODUCT HAS

BEEN DAMAGED BY ACCIDENT, MISUSE, NEGLECT, IMPROPER PACKING OR

IMPROPER MODIFICATIONS OR SERVICE.

IN THE EVENT THIS PRODUCT SHALL PROVE DEFECTIVE IN WORKMANSHIP OR

MATERIALS THE PURCHASER’S SOLE REMEDY SHALL BE THE REPAIRS STATED

IN THIS WARRANTY AND UNDER NO CIRCUMSTANCES SHALL STI BE LIABLE FOR

ANY LOSS OR DAMAGE, DIRECT, INCIDENTAL OR CONSEQUENTIAL ARISING OUT

OF THE USE OF, OR INABILITY TO USE, THIS PRODUCT CAUSED BY ANY DEFECT

IN THE PRODUCT.

THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED,

AND STI HEREBY DISCLAIMS ALL OTHER WARRANTIES OF MERCHANTABILITY

AND FITNESS FOR A PARTICULAR PURPOSE.

EC DECLARATION OF CONFORMITY

Scientific Test, Inc.

3306 W. Walnut

Suite 412

Garland, TX 75042

U.S.A.

Declare under our sole responsibility that the

5300S and 5300HS

To which this declaration relates is in conformity with the following standard(s) or

other normative document(s).

EN55022 1994

EN50082-1 1992

IEC 801-2 1991

IEC 801-3 1991

ENV 50204 1996

IEC 801-4 1988

EN 61010-1

Following provisions of the Electromagnetic Compatibility (89/336/EEC) Directive and

Low Voltage (73/23/EEC) Directive.

The Technical Construction File is maintained at Scientific Test, Inc. at the address

listed above.

The authorized representative located in the community is:

Safety Summary

Please take a moment to review these safety precautions. They are provided for

your protection and to prevent damage to the system. This safety information

applies to all operators and service personnel.

Symbols and Terms

These symbols appear on the equipment:

ATTENTION

Refer to Manual

Protective

Ground

DANGER

High Voltage

Service Safety Summary

Only qualified personnel should perform service procedures. This safety

information applies to all service personnel.

Do Not Perform Service Alone

Do not perform internal service or adjustments of this product unless another

person capable of rendering first aid and resuscitation is present.

Use Care When Servicing With Power On

Dangerous voltages which may exceed 2KV exist at several points in this

product. To avoid personnel injury, do not touch exposed connections or

components while power is on. Disconnect power before removing protective

panels, soldering or replacing components.

Disconnect Power

To avoid electrical shock, disconnect the main power by means of the power

cord or the power switch.

Specific Precautions

Observe all the following precautions to ensure your personal safety and to

prevent damage to either the system or equipment connected to it.

Power Source

The system is grounded through the power cord. To avoid electrical shock,

plug the power cord into a properly wired receptacle with an earth ground

connection. Do this before making connections to the input or output

terminals of the system.

Without the protective ground connection, all parts of the system are potential

shock hazards. This includes connectors and controls that may appear to be

insulators.

Use The Proper Power Cord

Use only an appropriate power cord which has provisions for a ground

connection and is rated for the amount of current and voltage specified on the

rear of each system. Use only a power cord that is in good condition.

Use The Proper Fuse

To avoid fire hazard, use only a fuse that meets all type, voltage and current

specifications as shown below:

IEC 127: 5 by 20 mm, time lag, 1A, 250V, Type T or

IEC 127: 5 by 20 mm, time lag, 2A, 120V, Type T

Do Not Remove Covers

To avoid personal injury, do not operate the system without the covers.

Do Not Operate in Explosive Atmospheres

The system provides no explosion protection from static discharge or arcing

components. Do not operate the system in an atmosphere of explosive

gases.

Do Not Operate The System In A Manner Not Specified

Failure to operate the system as described in this manual may result in

serious injury or death.

Use Care When Operating System

Dangerous voltages can exist at the front terminals that may exceed 2KV. To

avoid personal injury or death, exercise caution when operating system.

Power and Environmental Characteristics

Power Requirements and Frequency

100 to 132 VACRMS, for 47 Hz through 63 Hz

200 to 240 VACRMS, for 47 Hz through 63 Hz

Temperature

25ºC ± 5ºC

Relative Humidity

To 50% at or below 30ºC

Ventilation Requirements

Equipment should be located no closer than 4 cm from the wall in a well

ventilated room.

Installation/Overvoltage Catagory

ESD Susceptibility

The following areas can be static sensitive: Screws, seams, toggle switches,

ports and the start/stop switch.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Equipo de prueba de Scientific

Scientific

Scientific SMO2000XP Manual de usuario

Scientific

Scientific SMO2000X Manual de usuario

Scientific

Scientific SMO5000X Series Manual de usuario

Scientific

Scientific SME1190 Manual de usuario

Scientific

Scientific SMO502ED Manual de usuario

Scientific

Scientific SMO702 Manual de usuario

Scientific

Scientific SMO1000A-S Manual de usuario

Scientific

Scientific SMO1000E Manual de usuario

Scientific

Scientific SMO1000U Manual de usuario

Scientific

Scientific SMO2000X-E Manual de usuario

Scientific

Scientific SM6030A Manual de usuario

Manuales populares de Equipo de prueba de otras marcas

SMART

SMART KANAAD SBT XTREME 3G Series Manual de usuario

Agilent Technologies

Agilent Technologies BERT Serial Manual de usuario

Agilent Technologies

Agilent Technologies N3280A Manual de usuario

Vernier

Vernier Go Direct Voltage Manual de usuario

Lifeloc

Lifeloc R.A.D.A.R. Manual de usuario

Fluke

Fluke T5-600 Instrucciones de funcionamiento e instalación

Mercury

Mercury TSL01 Manual de usuario

MAHA

MAHA MBT Series Manual de usuario

Fuji Electric

Fuji Electric P-61 Manual de usuario

ETC

ETC SealerAtor Manual de usuario

Skyfine

Skyfine ETHYWAY V2 Manual de usuario

Appion

Appion G5 Twin Manual de usuario

PCB Piezotronics

PCB Piezotronics 8159-0112A Manual de usuario

BW Technologies

BW Technologies MicroDock II Manual de usuario

Sun Nuclear

Sun Nuclear 1027 Manual de usuario

Biomark

Biomark HPR LITE READER Manual de usuario

Hioki

Hioki 3169-20 Manual de usuario

Ashcroft

Ashcroft ATE-100 Manual de usuario