schroff VME64 Series Manual de usuario
VME64x Tower System
User’s Manual
Product No.:
10836-050
November 12, 2007Doc-No: 63972-159_R1.0
Impressum:
Schroff GmbH
D-75334 Straubenhardt, Germany
The details in this manual have been carefully compiled and
checked - supported by certified Quality Management System
to EN ISO 9001/2000
The company cannot accept any liability for errors or misprints.
The company reserves the right to amendments of technical
specifications due to further development and improvement of
products.
Copyright © 2007
All rights and technical modifications reserved.
Rev. Date updated Change
R1.0 November 12, 2007 Initial Release
VME64x Tower System
10836-050
www.schroff.biz I R1.0, November 12, 2007
Table of Contents
1 Safety ................................................................................................................. 1
1.1 Intended Application ............................................................................................ 1
1.2 Safety Instructions ............................................................................................... 2
1.3 Safety Symbols used in this document................................................................ 2
1.4 General Safety Precautions................................................................................. 2
1.5 References and Architecture Specifications ........................................................ 3
2 Product Definition............................................................................................. 4
2.1 Mechanical Overview........................................................................................... 5
2.2 Tower System...................................................................................................... 6
2.3 VME64x Backplane ............................................................................................. 6
2.4 Power Supply....................................................................................................... 7
2.4.1 Grounding .............................................................................................. 8
2.4.2 Power Supply......................................................................................... 8
2.5 Thermals............................................................................................................ 10
2.6 Fan Control Module (FCM) ................................................................................ 11
2.7 Display Module .................................................................................................. 11
3 Installation....................................................................................................... 12
3.1 Unpacking.......................................................................................................... 12
3.1.1 Ensuring Proper Airflow ....................................................................... 12
3.2 Basic Functional Check ..................................................................................... 13
4 Service ............................................................................................................. 14
4.1 Technical support and Return for Service Assistance ....................................... 14
4.2 Declaration of Conformity .................................................................................. 14
4.3 Scope of delivery ............................................................................................... 15
4.4 Accessories ....................................................................................................... 15
4.5 Spare Parts........................................................................................................ 15
5 Technical Data ................................................................................................ 16
6 Dimensions ..................................................................................................... 17
VME64x Tower System
10836-050
www.schroff.biz II R1.0, November 12, 2007
VME64x Tower System Safety
10836-050
www.schroff.biz 1 R1.0, November 12, 2007
1 Safety
1.1 Intended Application
The VME64x Tower System, described in this manual, is intended as a platform
for a microcomputer system based on the VME bus system (VME (VITA 1-1994)
and VME64x (VITA 1.1-1997)).
The VME64x system subracks are designed for protection class IP 20 and can
be used only in the resp. environments.
For higher protection requirements, a.e. IP 54/55 you must install the system
subrack in a protective case.
VME64x Tower Systems are not end-products, so there is no valid approval for
this unit. In order to enable stand-alone functionality, additional elements are
required. An operational system is achieved only by way of appropriate VME or
VME64x boards.
The completion and final testing of the units have been carried out, or at least
supervised, by qualified technicians. These instructions are directed exclusively
to these qualified technicians i.e.engineers, trained and qualified electricians
etc.
Make sure that:
• the assembled unit complies with the safety regulations currently applicable
in the country it is going to be used.
• the overall unit complies with all other regulations and specifications at the
place and country of use, e.g. interference limits, approval by the telecom-
munications authorities.
VME64x Tower System Safety
10836-050
www.schroff.biz 2 R1.0, November 12, 2007
1.2 Safety Instructions
The intended audience of this User’s Manual is system integrators and
hardware/software engineers.
1.3 Safety Symbols used in this document
1.4 General Safety Precautions
• Service personnel must know the necessary electrical safety, wiring and
connection practices for installing this equipment in a telecommunication
environment.
• Install this equipment only in compliance with local and national electrical
codes.
Hazardous voltage!
This is the electrical hazard symbol. It indicates that there are dangerous
voltages inside the Shelf.
Caution!
This is the user caution symbol. It indicates a condition where damage of the
equipment or injury of the service personnel could occur. To reduce the risk of
damage or injury, follow all steps or procedures as instructed.
Danger of electrostatic discharge!
The Shelf contains static sensitive devices. To prevent static damage you must
wear an ESD wrist strap.
Warning!
Voltages over 60 VDC can be present in this equipment. This equipment is
intended to be accessed, to be installed and maintained by qualified and
trained service personnel only.
This equipment is designed in accordance with protection class 1!
It must therefore be operated only with protective GND/earth connection!
VME64x Tower System Safety
10836-050
www.schroff.biz 3 R1.0, November 12, 2007
1.5 References and Architecture Specifications
• User Manual VME64x Backplanes
Order no.: 73972-103
• Short Form User Manual VME64x Backplanes
Order no.: 73972-128
• User Manual Fan Control Module (FCM)
Order no.: 73972-083
For more information see the catalogue „Electronic Packaging“ and at
www.schroff.biz
VME64x Tower System Product Definition
10836-050
www.schroff.biz 4 R1.0, November 12, 2007
2 Product Definition
The Schroff VME64x tower system consists of:
• A shielded subrack with front assembly area for
6 U front boards according to VME64x Standard (VITA 1.1-1997)
• A 7 slot VME64x (VITA 1.1-1997) Backplane
• An open frame power supply with wide range input
• Speed controlled fans for cooling the boards
• Fan Control Module (FCM) for fan monitoring/controlling
• Display module
• Mains/line switch
• AC mains/line module with IEC320-C14 connector, line filter and fuses
The fans are assembled at the rear panel, the power supply is located at the rear
lower side.
VME64x Tower System Product Definition
10836-050
www.schroff.biz 5 R1.0, November 12, 2007
2.1 Mechanical Overview
Figure 1: Mechanical Overview
10006844
1 Fan Control Module (FCM) 7 Front panel 4 U, perforated
2 Drive Unit 4 U / 8 HP 8 Fans
3 Display Module 9 AC mains/line module with IEC320-
C14 connector, filter and fuses
4 AC Switch 10 Power Supply
5 VME64x Systembusplatine 11 Air Filter
6 Card cage with guide rails
10
11
1
4
6
7
5
2
3
9
8
VME64x Tower System Product Definition
10836-050
www.schroff.biz 6 R1.0, November 12, 2007
2.2 Tower System
The VME64x Tower System system based on the Schroff europacPro subrack
in a ratiopacPro chassis with EMC shielding. The front card cage provides space
for the installation of 7 VME64x Boards (6 U, 4 HP, 160 mm deep).
The lower guide rails are fitted with ESD clips.
A 4 U / 8 HP Drive Unit for the assembly of a HD Drive is located above the card
cage.
2.3 VME64x Backplane
The 6 U Backplane is compliant to:
• VITA 1.1-1997
• VITA 38 Systemmanagement for VME
The Tower System has a 7 slot Backplane without P0 connectors as standard.
You can customize your system with different Backplanes.
For more information see the Backplane’s User Manual, Order No.: 73972-103/
-128, in the catalogue and at www.schroff.biz
1 Slot = 4 HP = 20,32 mm
Tabla de contenidos
Manuales populares de Accesorios de red de otras marcas
Patton electronics
Patton electronics 2888 Manual de usuario
Cradlepoint
Cradlepoint COR IBR1100/IBR1150 Manual de usuario
Paradyne
Paradyne Hotwire 8620 Manual de usuario
Infra Cool
Infra Cool F-1.3 Manual de usuario
Edgewater Networks
Edgewater Networks 4300T Manual de usuario
Edimax
Edimax SB-2200g Manual de usuario
Extreme Networks
Extreme Networks Mogul-100 Manual de usuario
Aaeon
Aaeon FWS-8500 Manual de usuario
Panduit
Panduit Z11C Series Manual de usuario
F5
F5 BIG-IP 10000 Series Instrucciones de montaje
ZyXEL Communications
ZyXEL Communications NMA1115 Manual de usuario
Auerswald
Auerswald COMtrexx Business Manual de usuario