--
Menu Selection
To change mode, press the QUIT button. The display will show
CHANGE MODE?.
Use the UP/DOWN button to select the desired mode and
conrm the action by pressing the ENTER button or cancel by
pressing the QUIT button again.
In most of the modes, for example QuickPatch Network and
QuickPatch DMX, the congured settings will automatically be
taken over. Input on the device is only necessary when
changing set-up settings or switching within a new mode.
Change Mode?
Quit Enter
t: ...
Welcome to DPB Pixel-Router Pro
IP: ... v: 3.2. ...
Info
This mode displays the installed soware version, the IP
address of the unit and its temperature.
Manual Patch
When changing from the QuickPatch mode into the Manual
Patch mode the following display is shown:
In this case it’s possible to apply the QuickPatch values with the
manual patch. This step is irreversible. That’s why you must hit
the SHIFT-Key and the ENTER-Key to conrm. If you don’t want
to proceed with this step, you can exit with QUIT.
Setting values in Manual Patch Mode
To select the section you wish to work in – press the EDIT-Key.
To select the desired XLR output (-) use OUTPUT (OUT). To
select the desired channel use CHANNEL (CH).
With Type: Int can allocate this channel a xed, unchangeable
intensity via value.
With Type: DMX will assign a DMX input channel to this DMX
output channel.
Overwrite Patch with QuickPatch?
Quit Shi+Enter
Out: Universe: DMX
Ch: Type: INT Val: OFF
