PARTS LIST
OPERATION & INSTALLATION
DISPLAY
WALL MOUNTING
1. Identify a suitable position for the indicator assuring
the display is easily seen by the customers
2. Measure and mark the mounting holes on the wall
using the display wall mount bracket as a template
(Figure 6)
3. Drill holes using a 5/16” drill bit
4. Use the wall anchors if mounting the indicator to a
surface other than solid wood wall
5. Position the display wall mount bracket over the
drilled holes and secure with two large Phillips screws
(Figure 7)
www.satoamerica.com
Figure 6 Figure 7
WIRING
PUSH BUTTONS
WARNING! Electrical Shock hazard. Do not
connect the display to power until all push
buttons and power connections are complete.
Serious electric shock, injury or death may result.
Figure 8
Figure 10
ELECTRONIC DISPLAY
The Take-A-Number System includes three push
buttons. Set two push buttons to advance numbers
and one to go back to a previous number.
!
1. Cut a length of electrical wire to reach from
each push button location to display
2. Strip wire ends about ½” (Figure 8)
3. On the underside of one push button:
Loosen screws. Wrap one wire end around
one screw post and wrap the other wire
end around the other screw post. Tighten
the screws to secure wires (Figure 9)
4. Secure push button to surface using the
two included slotted screws (Optional)
5. Repeat steps 1-3 with the two remaining
push buttons
Figure 9
WIRING PUSH
BUTTONS TO DATA
CONNECTORS
1. 1. Strip wire ends about ½” for all three
push buttons. (Figure 8)
2. Each data connector has three numbered
ports. Loosen screws on ports 2 and 3 with
a mini flathead screwdriver
3. For (+) push buttons: Twist the same color
wires together from two of the push
buttons (copper to copper, silver to silver).
Insert the twisted wires into ports 2 and 3
on one data connector. Tighten screws to
secure wires (Figure 10)
4. For (-) push button: Use the wire from one
remaining push button. Insert the wires
into ports 2 and 3 on the second data
connector. Tighten screws to secure the
wires (Figure 10)
PLUGGING DATA
CONNECTORS INTO
DISPLAY
1. 1. Plug the data connector with two push
buttons attached into the (+) jack on the
back of the display (Figure 11)
2. Plug the other data connector with the
single push button attached into the (-) jack
on the back if the display (Figure 11)
